How to set up the Huawei MT800 router with high scores!!

You can enter, the default password is admin, and so is the username.

After going in. There is a quick setup - then select ADSL to dial - Next - Enter ADSL password - Next - Save.

Then just restart the router. (System Tools - Reboot Router)

You type in the web page.

Log in to the land rover, enter the initial password, and go up.

There's one in there'Internet Guide'Choose the one for PPPoE.

Next, type your ADSL username and password, and next, OK.

Congratulations, you're done.

The routing software version is V100R004C01B011SP01 to lock the routing function, and you can change the version to V100R006C01B010SP02 by upgrading the version, which should enable the routing function.

To see what the version is, the new cat basically blocks the routing feature.

You can upgrade the firmware and flash the version to implement the open routing function.

There are many instructions and solutions online, please remember that all operations are dangerous, be careful!

Just say that I have added the landlord QQ and solved it smoothly

Question 1: Login information.

Before setting, you must first change the IP of your PC to for example: , the IP is generally ; Username and password: admin admin (or admin epicrouter).

Question 2: The settings screen after logging in.

HUAWEI MT800 has several software versions,The tutorial I wrote is just one of them,If everyone's version (setting interface) is different,Please first find the "Huawei MT800 full series manual" I sent in the "Huawei product series"** (you need to use acrobat or above to open),Then refer to this tutorial settings。

Question 3: Does ADSL support routing autodialing?

Look at the corresponding version of the manual first, if there is a manual, then there is; If it is not mentioned, then it is most likely not supported.

Special note: I do not recommend that ADSL without routing function be upgraded by flashing the firmware, after all, it is too dangerous, if the flashing fails, then you can only wait for your ISP (network service provider) to help you change ADSL. (Think about how long you have to wait before you can go online).

Problem 4: ADSL cat disconnection.

Huawei's ADSL does have a disconnection problem (it was just to visit relatives at a friend's place at the time, and I haven't found out the reason yet, it may be a heat dissipation and chip problem), at least the ADSL exists after I help my friend do the routing function (I use it for the first time every morning). The solution is to turn on the ADSL for the first time, turn it off and then power it back on, and the connection will not drop.

Question 5: What about the VCI value.

Each city ISP has its own VPI VCI value, generally 0 35 or 8 35, if you can't try, then you can only go to the Internet to check the VPI VCI value of your city, or call ** to ask your ISP.

Problem 6: Networking connection problems.

If you want multiple PCs to access the Internet through the switch, please connect the ADSL to the switch with a direct cable; The original cable that comes standard with ADSL is a crossover cable, which can only be used for a direct connection between ADSL and PC.

Question 7: About the model of the cat.

The mention of the software version in the forum post refers to the fact that after entering the web settings page of the cat, there is an item on the home page: software version, followed by a series of strings. Standardly, the model of the cat is MT800.