If you accidentally change lanes at the compaction line at the intersection, will you be photographe

If there is an electronic eye at the intersection, it will definitely be photographed.

According to the "Regulations on the Application and Use of Motor Vehicle Driving Licenses" (Order No. 139 of the Ministry of Public Security):

There are several situations in which a motor vehicle violates the prohibition marking.

1. In the process of driving, the line is pressed, the line is crossed, and the single or double yellow solid line is crossed.

2. Temporary or long-term parking on the road section where parking is prohibited.

3. U-turn at a section where a U-turn is not allowed, and turning left at an intersection where a left turn is prohibited, all of which are violations of the prohibition of marking instructions. The prohibition marking is the solid yellow line on the ground and the prohibition of parking sign, and pressing it up violates the prohibition marking indication.

4. If the intersection does not follow the road guide marking in the corresponding lane, it is also a violation of the prohibition marking indication.

Not necessarily.

The solid line lane change camera system adopts a ground pressure magnetic induction coil, and the principle of taking pictures: when the front wheel of the car presses over the induction coil on the ground, the first image is taken electronically**; When the rear wheel of the car presses against the induction coil on the ground, the second photo is taken electronically**; When the car passes through the intersection and presses over the induction coil on the ground opposite, the third image is taken electronically**.

<> under normal circumstances, the probability of changing lanes on the compaction line is not large, in many cases, the electronic police will not shoot the lane change of the compaction line, mainly by the traffic police on-site capture violations, usually because of the traffic accident caused by the change of the compacting line The probability of shooting is greater, but many accidents occur because of the violation of minor violations.

There are two situations in which the electronic eye will capture the lane change with a white solid line: 1. In the urban area, there is generally a reminder sign with an electronic eye to remind you not to change lanes at will. 2. It will shoot at the intersection, but the monitoring range of the electronic eye is very short, and it will be monitored within 20 meters from the parking line.

Extended information: The following is an introduction to the line that cannot be pressed: 1. Single yellow solid line:

In some places where the traffic flow is small and the road width is narrow, this single yellow solid line will be set, and its function is to separate the oncoming traffic. 2. Double yellow solid line: Similar to the single yellow solid line, the double yellow solid line is also used to separate the opposite traffic.

3. White solid line: At the position of approaching the intersection, there will always be a white solid line, and the function of this white solid line is to separate the lanes in the same direction. 4. Yellow no-parking line:

The solid yellow line serves to warn that parking is prohibited on this section of the road. 5. Deflector line: The diversion line is generally set at intersections, ramps, U-turn lanes and other locations with complex driving conditions, and its function is to guide vehicles to drive according to the prescribed route.

According to theChinaArticle 90 of the Road Traffic Safety Law of the People's Republic of China stipulates that if a driver of a motor vehicle violates the provisions of road traffic safety laws and regulations on road traffic, he shall be given a warning or 20MetaA fine of less than 200 yuan will be imposed, and 3 points will be deducted if driving a motor vehicle in violation of the prohibition marking instructions. Therefore, changing lanes on a solid line also violates the above regulations, and will be fined 200 yuan and deducted 3 points.

Yes, the solid line lane change will definitely be photographed, so don't leave anything to chance.

How is the solid line changing lanes captured.

When driving a vehicle normally, the monitoring equipment at the intersection will not take pictures of the normal driving vehicle. When a vehicle changes lanes illegally, the vehicle's tires press against the induction coil of the solid line, which triggers the camera to take a picture. Generally, the front wheel is pressed on the induction coil that is photographed first, and then the rear wheel is also pressed to the induction coil of the solid line, triggering the second **.

With these two **, you can clearly record the process of violation, and without special circumstances, you can prove that it is already a solid line lane change. In addition, it will also take a picture after changing lanes**, so that the facts of the violation are very clear.

Compaction lines caused by vehicle breakdowns or road repairs.

If you build a road, it will be easier, and the camera that takes pictures of solid lines will be disabled, so that it will not be photographed. If the vehicle in front of you breaks down and cannot start normally, causing the vehicle behind to have to change lanes, it is also possible that the solid line changes lanes. This situation can be appealed back, and the traffic police will also call up the monitoring of the intersection to revoke the violation.

Of course, the best thing to do is to record the process with a dashcam yourself, which will be more convenient and quick to process.

Tips. Vehicles change lanes, even in the case of dotted lines, need to be particularly careful, can not hinder the normal driving of the lane of the vehicle, solid line lane change at the intersection must not appear, otherwise it will not only bring penalties, but also very likely to cause traffic accidents, inconvenience to their own driving.

Not necessarily.

The solid line lane change camera system adopts a ground pressure magnetic induction coil, and the principle of taking pictures: when the front wheel of the car presses over the induction coil on the ground, the first image is taken electronically**; When the rear wheel of the car presses against the induction coil on the ground, the second photo is taken electronically**; When the car passes through the intersection and presses over the induction coil on the ground opposite, the third image is taken electronically**.

1. The lane change of the compaction line will definitely be photographed. Reference: It is possible to take pictures, so no matter how you drive, you must obey the traffic rules, and you must not be opportunistic.

Of course, not every intersection can be photographed, some can be photographed and some can't, and we don't know which intersection can be photographed, so don't compact the line.

2. Under normal circumstances, you can only shoot violations in front of the camera, such as running a red light, pressing the line in front of the camera, and bad driving behavior in the middle of the intersection.

3. How can you capture it behind the camera? In fact, it was not the camera above our heads that caught us violating, but the camera in the opposite lane. The innermost one of the opposite lanes is dedicated to photographing the compaction lines of the opposite lane.

4. I was also confused before dealing with the violation. After dealing with the violation, I looked at ** to know that it was taken by the camera. Of course, there are very few intersections photographed like this, almost none.

Now, more crimping cameras are still on top of our heads, just shooting backwards. The camera that runs the red light is facing forward, and the camera that takes the line and counts the traffic is looking backward, of course, it can take pictures of us. This camera is easy to see.

Generally, there are many cameras on one pole. When you get here, you must drive carefully and don't accidentally violate the rules.

Not necessarily.

The solid line lane change camera system adopts a ground pressure magnetic induction coil, and the principle of taking pictures: when the front wheel of the car presses over the induction coil on the ground, the first image is taken electronically**; When the rear wheel of the car presses against the induction coil on the ground, the second photo is taken electronically**; When the car passes through the intersection and presses over the induction coil on the ground opposite, the third image is taken electronically**.

The solid line lane change will not necessarily be photographed, the solid line lane change camera system uses a ground pressure magnetic induction coil, and the principle of taking pictures: when the front wheel of the car presses over the induction coil on the ground, the first image is taken electronically**; When the rear wheel of the car presses against the induction coil on the ground, the second photo is taken electronically**; When the car passes through the intersection and presses over the induction coil on the ground opposite, the third image is taken electronically**.

1. Materials required for demerit points on driver's license:

1. The original license of the illegal vehicle;

2. The original ID card of the scorer;

3. The original driver's license of the scorer.

2. The process of deducting points for a driver's license is:

1. Prepare the documents to deduct points with your driver's license, and you must take the driver's license, ID card and the driving license of the vehicle holder to the traffic police department to handle it.

2. Confirm the information: hand over the driving license and driver's license and ID card to the staff, and the staff will call up the illegal record for confirmation.

3. If the fine is paid to confirm that it is illegal information, the staff will print the penalty decision, and then take the penalty decision to the designated bank to pay the fine, and after the payment, the illegal information will be eliminated, and as long as the deduction does not reach 12 points, the score will be restored in the next cycle.

Legal basisRegulations on the Application and Use of Motor Vehicle Driver's Licenses

Article 65 The cumulative demerit period (i.e., demerit period) for road traffic safety violations shall be 12 months, and the full score shall be 12 points, calculated from the date of initial receipt of the motor vehicle driver's license. According to the severity of road traffic safety violations, the score of a demerit is: 12 points, 6 points, 3 points, 2 points, and 1 point.

Article 69: Where the driver of a motor vehicle does not score 12 points in a scoring cycle, and the fine has already been paid, the demerit points are to be cleared; Where the demerit score does not reach 12 points, but the fine has not been paid, the demerit points are transferred to the next demerit period.

The solid line lane change will not necessarily be photographed, the solid line lane change camera system uses a ground pressure magnetic induction coil, and the principle of taking pictures: when the front wheel of the car presses over the induction coil on the ground, the first image is taken electronically**; When the rear wheel of the car presses against the induction coil on the ground, the second photo is taken electronically**; When the car passes through the intersection and presses over the induction coil on the ground opposite, the third image is taken electronically**. Compaction line lane change photography is enabled 24 hours a day,** and related data will be retained for one week, and solid line lane changes that have not occurred major safety incidents are usually not photographed.

If it is a temporary license plate used in a new car, it is difficult to be photographed clearly by electronic violations due to material problems.

If a car changes lanes at an intersection, there is a high probability that it will be photographed because the frequency of camera shooting is very frequent. Changing lanes on a car compaction line is an offense that violates the prohibition sign and is punishable by a penalty of three demerit points and a fine.

Continuous lane changes can be judged by the car's turn signal. For example, the car will turn on the turn signal in advance before changing lanes, and the turn signal will be turned on in which direction the car changes lanes. Once you turn on your turn signals, you need to look at the opposite lane and the vehicles behind you to change lanes.

The deceleration marking is divided into longitudinal deceleration line and transverse deceleration line, which is generally set near the toll station, exit gate or other white dotted line that requires vehicles to slow down. The longitudinal reduction line is generally a set of diamond-shaped polygonal lines parallel to the lane dividing line, which is generally set at the upper and lower bridges and turning positions. The main function is to create a sense of pressure through the visual reduction of the car, so that the driver can automatically slow down where it is necessary to slow down.

The compacted lane change camera system uses a ground pressure magnetic induction coil. Camera principle: When the front wheel of the car presses against the induction coil on the ground, the first image is taken electronically**; When the rear wheel of the car presses over the ground induction coil, the second image is taken electronically**; When the car runs over the induction coil on the opposite ground through the intersection, the electronics take a third shot**.

The compaction line lane change can be activated 24 hours a day, and the relevant data is stored for one week. Solid lane changes without major safety accidents are generally not photographed. If it is a temporary sign used in a new car, it is difficult to be photographed clearly by electronic violations due to material problems.