How to install a DNS server on a CentOS system

I guess it's not a historical figure anymore.

DNS server setup configuration method:

2008 DNS is set up by creating a new DNS role server, after opening the 2008 system, open the server manager, find the role--- there is a role on the right side to add a role.

Then enter the role creation wizard page, and proceed to the next step by default.

Wait a few moments to scan the server role, and then select DNS server (note that a fixed IP address is required to set up a DNS server).

Check Set the server fixed IP

Open the Network and Sharing Center and find the local connection properties. Open and click on Internetv4 Properties, and select Manually Configure IP in the General tab

If the server has a fixed IP address, proceed to the next step.

The dialog box is prompted to confirm the installation of the DNS server, and click [Install] to continue.

After clicking Install, you will need to wait a few minutes to enter the installation stage.

Once installed, a warning will be prompted if Windows Update is turned off. It is recommended to activate the Windows Update service (in fact, this can be turned on without affecting the use of DNS).

Go back to the Server Manager role service again, and you can see the DNS server.

How to set DNS for the client, if the internal computer, set the DNS part of the DNS part as the IP address of the server. Secondary DNS can be set to a public IP that can be connected normally, if it is dynamically assigned to the router, set the allocation of the preferred DNS to internal DNS

Step 1: Click Start, point to Administrative Tools, and then click DNS to open the DNS Manager.

Step 2: If necessary, add the applicable server to the snap-in and connect to the server. In the console tree, click the applicable DNS server.

Step 3: On the Actions menu, click Configure DNS Server. Open the DNS Service Configuration Wizard.

Step 10: Complete the configuration wizard to list the DNS server name and search zone name, confirm and click Done, and complete the DNS server configuration.

Hello. The operation steps to set up a DNS server under the window are very simple, mainly to clarify the principle, and it is OK to learn the following two files DNS:

How nameservers work.

The steps to set up DNS are as follows:

FTP for embedded Linux is most commonly used to complete the file transfer function between the development board and the development environment Linux system, avoiding the process of frequent USB flash drive copying.

Configure the yum source and install it:

yum install bind