XP SYSTEM WINDOWS DOES NOT RECOGNIZE THE SYSTEM FIREWALL, MASTER PLEASE COME IN

Amount e e e e e e e"Windows can't show Windows Firewall settings due to unrecognized issues. So the virus was disinfected in safe mode, and the symptoms were still the same after restarting.

Next: Start by clicking Settings Control Panel Security Center Windows Firewall and Windows Firewall settings cannot be launched.

On my computer, right-click on the Management Services and Applications service and find Security CenterThat's right.

Run the command to open Group Policyr, and then Computer Configuration Administrative Templates Network Connectivity Dency and Windows Firewall - the service is correct.

Run "Locate the Windows Firewall Internet Connection Sharing service enabled and automatic."

Still no, I guess it's something about the system that has been destroyed, dizzy! Probably only the problem with the registry remains.

In a hurry, it took a lot of effort to finally find a solution to the problem, which was the problem of the registry. (Although sometimes we turn off the Windows Firewall in order to avoid conflicts between the firewall of some antivirus software and the Windows Firewall, but this time I didn't turn it off, so the problem had to find a way to solve it, hehe).

Go and see the following is what Microsoft offers for users who don't understand English so that they can understand the content of these articles--- Windows XPSP 2 can't start Windows Firewall service:

1.Windows Firewall Internet Connection Shares (ICS) are not displayed in the Service List Control Panel.

2.In the Services Matrix, it shows Windows Firewall Internet Connection Shares (ICS) but the service cannot be started.

3.When you try to access Windows Firewall settings, you receive the following error message:

Due to an identification issue, Windows is unable to display the Windows Firewall settings bridge muffled.

1) If it is a problem with the broadband itself, first directly connect the broadband network cable to test, if it is a broadband problem, contact the broadband customer service to solve it.

2) If it's a problem with the router, if it can be used originally, it can't be used for the time being, my own practice is to disconnect the power of the router and plug it in, and I'll take a look. After there is a factory reset, it can be used from the new settings (this is under the premise that the physical mountain Luzi connection is correct, sometimes it is caused by the router finding IP address slow or failed, not that the router is broken).

If it can't be solved all the time, it is recommended to call the customer service of the router**, they have **** guidance, I encounter a problem that I can't solve by myself, it is very useful to consult them for advice on the way to the min, and they will give the correct advice for your settings or operations.

3) If you turn off the wireless switch, turn it on, if it is a wireless connection with software, it is normal for the software to be difficult to use and often have problems, there is no better way, use a router. In addition, it is caused by the network card driver is not or is not suitable, and whether there is a problem with the network cable interface or network cable.

4) If it is caused by a system problem, it is recommended to restore the system or reinstall it.