How to deal with water ingress in the charger and what should I do if the charger enters water?

If you are using a vivo charger, it is recommended not to continue to use the charger after it is liquidized to avoid safety accidents caused by short circuits.

The charger does not belong to the scope of the three guarantees, you can go to the vivo customer service center or vivo official ** to buy the original charger to use, pay attention to WeChat *** "vivo" or "vivo customer service" to inquire about the address of the service center**, it is recommended to contact before going to ensure that there is a staff to receive you and then go over, so as to avoid delaying your precious time and letting you run in vain.

If your charger is flooded with water or liquid, it is recommended that you do not try to plug it in to prevent the charger from being damaged and dangerous due to a short circuit inside the charger. It is recommended that you bring the machine to the local after-sales service center, and the engineer will help you test it.

If the charger gets into the water, you must not use it again in this case, because it is easy to be dangerous and even burn the charger when the water is not cleared. It is recommended to disassemble the charger first, wipe the water inside, and then use a hair dryer or other items to completely remove the water before putting it back on, so that you should be able to continue to use it.

1. First of all, after the charger enters the water, it is necessary to quickly fish out the charger by hand or keep the charger away from the water source to reduce further damage. 2. If it has not been placed in water for a long time, it can be wiped with a dry paper towel or with a dry glasses cloth. 3. For the charger that has been soaked in water for a long time, you can put it on toilet paper, and then use a hair dryer to cold dry it and evaporate the water at medium speed.

4. After making sure that there is no moisture in the charger and it is completely dry, you can try to plug it into the socket to check whether it can be used. 5. If the charger has an indicator light, you can observe whether the indicator light is on, and if there is no indicator light, it can be plugged into other suitable electrical appliances for detection. 6. If the result of the detection is that the charger is bad, you can go directly to the store or buy a new suitable charger online.

If the charger gets water, first stop using it, dry or blow dry the internal moisture, and wait for about five days to check the normal situation before using it if it is not normal, do not use it, otherwise it may burn out the equipment.

Under normal circumstances, if the charger is flooded, it cannot be used immediately. Be sure to use a professional hair dryer to drain the water inside, and then use it for two or three days, if you use it halfway, it may cause a blockage in the circuit.

It's the same as the water treatment of mobile phones.

When the mobile phone enters the water a lot, it just falls into the water and is immediately fished up, but it still needs to be repaired hundreds of pieces to be good, and some are soaked in water for half an hour to dry up and dry, but it's fine, this is actually the most important thing is that the IC inside is not glued.

Let's talk about the treatment method of influent water first! But what you have to do when you pick up your phone from the water is to remove the battery immediately, not to see if it is turned off or to see if it can be turned on, if you try to turn it on, you may pay hundreds of dollars for your small press.

After removing the battery, it is time to send it for repair, and mobile phone stores generally deal with mobile phones that have entered the water like this. Take the phone apart, take out the motherboard separately, put it in the ultrasonic cleaner and wash it with pure alcohol or water. This cleans away the impurities under the IC, and if these impurities remain on the circuit board, it will corrode the circuit board until the phone is scrapped.

If you don't want to send it for repair, then you can also take it apart yourself, take out the mobile phone motherboard, remove the shield cover, use a hair dryer to dry the motherboard, see if there is white oxide on the feet of each small component, if there is one day take water to clean it off and then dry it with a hair dryer, and then put it aside for a few hours after it is completely dried to see if there is any oxide. If not, put it back on. It's usually going to be fine.

You are in the case of water after it is not powered up.

After the charger gets water, you can wipe it with a dry paper towel, or wipe it with a dry towel, if the charger has been soaked in water for too long, you can let it dry naturally, and then use a hair dryer to dry it to evaporate its moisture.

After the charger is flooded, first unplug it from the socket quickly, and then use an absorbent towel to clean all the water stains on the charger. Then put it in the sun for more than 10 hours and you can use it.

If the charger gets water, you need to open it to dry it quickly, if the water is very serious, then directly discard this charging head.

The place where the charger comes into contact with water can be absorbed directly with absorbent paper. Then put it in the sun and dry it for 1 to 2 days. This will work normally, because there are no electrical components in the charger. Just dry the outer layer of water.

It's not a big deal, it won't break, and the charger doesn't have any complicated parts.

It can be used. But just bask in the sun, or use a hair dryer, and remember to blow it for a week, a little bit every day. Or put it in rice to absorb the moisture.

Quickly unplug the charger for him, and shake him off, you can put it in the sun to dry, or you can use a hair dryer to slowly dry the water inside, it is best not to use it for the first two days, and then use it after a few days, it will be fine.

Any electronic device should not be attempted to turn on after it has been flooded.

The correct way to deal with it should be to disconnect the external power supply immediately, remove the internal battery of the device, and then clean up the moisture.

Air dry thoroughly in a cool place, or blow it off with a blow-off on a cold air setting, before trying to turn it on, otherwise the hardware may be burned due to a moisture short-circuit.

If you are white, it is recommended to send it to after-sales service to avoid big losses.

Dear, the charger is flooded, you must stop using it quickly, one is to shake the water dry, the other is to take it to a cool and dry place to dry for a few days, and wait for the water inside to be completely dried before it can be used again, so as not to cause a short circuit and burn out due to moisture.

Do not plug in the charger after it gets water, be sure to take it to a dry and ventilated place for air drying, or take it to some hot heaters to dry, and then confirm that there is no moisture and only use it again.

If the charger is flooded, then it is best to carefully wipe the water outside with a dry cloth first, and wait for it to dry naturally. Wait a little longer, etc. Make sure it's completely dry before using it.

If the charger gets into the water, do not use the charger at this time, wipe the water on the surface with paper, and then put it aside to dry. Wait for the moisture inside to dry thoroughly before use, if it can't be used, please replace the charger in time.

Do not use the charger immediately after the water enters, be sure to use a drying tool such as a hair dryer, and then try to see if there is a fault and whether it can be used.

If the charger gets water, don't use it anymore, if the charger gets water, there is a possibility that the residual scale will affect the use of the circuit board, and the circuit board is easily damaged when charging, which will affect the service life of the mobile phone.

It can be used.

First, the charger of the battery car is wet, and it can still be used. Electric vehicle manufacturers will do some waterproof treatment when they produce it, and if they are not soaked in water for a long time, it will have no effect. But wait until it has dried thoroughly before using it, otherwise it will be dangerous.

Second, if the unused charger is wet, never turn on the power supply, the charger should be dried with a dryer before using it the next day, otherwise it will be short-circuited and burned.

3. If it is damaged by a short circuit when charging, it may have been damaged by a short circuit, at this time, you need to fold the charger to check whether there are signs of burn damage (it is recommended to go to a professional repair shop to check), and then try to see if it can be used after drying, if it cannot be used, it can only be replaced.

EV charging methods and precautions.

1) Hot weather.

Do not charge in the sun, and cannot be charged immediately after driving. Whether it is normal or charging, keep away from open flames and high temperature heat sources. Try to choose a cool and ventilated environment, too stuffy environment is not conducive to the state of charge, and will also destroy the battery and reduce the life of the charger.

2) Be sure to charge with an adapted lithium battery charger, first insert the charger output plug into the battery charging socket, and then insert the charger plug into the mains jack, and observe the indicator light for charging judgment.

3) Generally, after the charger indicator turns green, it will be charged for about 1-2 hours and then stop charging.

After taking it apart and drying all the water vapor, there should be no problem in a short time.

If the charger gets water, shake off the excess water in time, remove the shell, dry it with an absorbent cloth (or paper towel), and then use a hair dryer to dehumidify. When the hair dryer is blowing, pay attention to turn on the cold air to dry. Finally, for the sake of insurance, put the charger in a cool and ventilated place for 24 hours to completely eliminate the moisture in the charger, and then reinstall the shell and turn on the power.

As long as the water ingress of the charger is treated in time and the method is correct, it can continue to be used.

Check the water situation, if you have the ability to disassemble the charger, disassemble and dry, you can put it in the rice tank, rice is a good water absorption tool, put it for a few days, make sure that the water is dry and then power on, if there is no way to be sure, it is recommended not to rush to power.

If you plug in the power supply after entering the water, then most of it has burned out, and there is no need to repair it, and you can buy a new charger, if there is a small amount of water in the charger, it is easy to cause short circuits, smoke, ** and other accidents, because electronic products are generally afraid of water, so effective avoidance is the key,

If you are currently using a vivo mobile phone, the vivo charger does not have a waterproof function, and it is recommended not to continue to use the charger after it is liquided to avoid safety accidents caused by short circuits. The charger is not within the scope of the three guarantees, you can go to the vivo customer service center or vivo official** to buy the original charger for use.

The charger is flooded, can it still be used, let's see what is inside.