After Octavia replaces the battery, the power window can t be lifted with one button

The window glass can't be lifted, the switch is fine, the wiring is fine, the motor is fine, sometimes it can be used, sometimes it can't be used, and when it can't be used, the relay doesn't respond. When I can use it, I press down the gap to rise, and I cannot go down.

Three common fault causes and maintenance methods of automobile glass regulators:

1. Abnormal sound of glass vibration. This indicates that the glass regulator screw may be loose, and the solution is to tighten the regulator screw;

2. The glass regulator is stuck. This failure may be caused by deformation or damage to the glass mud groove and loose fixing screws of the lifter.

Deviation of the installation position of the moving and guide rails or damage to the glass regulator. The maintenance method is mainly to clean and replace the glass mud tank or loosen the glass.

Glass mounting screws to adjust the position of the glass.

3. All glass regulators cannot work. The cause of this failure may be the detachment of the tie wire of the combination switch and the total power supply.

Wire detachment, poor relay contact, damage, or lockout switch poor contact or not closed. The repair method is to overhaul the circuit. Hand.

The principle of stirring the window is that there is a gear in the center of the handlebar, and there is also a curtain of knife-shaped chainrings on the glass lifting linkage mechanism, as long as one turn.

The grip and gear drive the chainring, which will make the glass go up and down a specific track. Nowadays cars are using electric windows, and electric windows only.

However, the crank part is changed to be driven by an electric motor, and the direction of the current is controlled by the switch to change the direction of the motor.

toward, let the glass window rise. One of the most important responsibilities of the glass window in the car is to protect from the wind and rain, so in the glass frame.

There are rubber seals on all sides, so that the glass can be close to the body, to achieve the function of wind and water resistance.

Glass regulator is a lifting device for automobile door and window glass, which is mainly divided into two categories: electric glass regulator and manual glass regulator.

Now the lifting (closing and opening) of many car door and window glass has abandoned the manual lifting and lowering mode of rocker type, and generally change to the electric lifting mode of button type, that is, use electric glass regulator. The electric glass regulator for cars is mostly composed of an electric motor, a reducer, a guide rope, a guide plate, a glass mounting bracket, etc. The general switch is controlled by the driver, the opening and closing of the whole door window glass, and the sub-switch on the handle of each car door is controlled by the occupant respectively, and the operation is very convenient.

After changing the battery, you can reset it, press and hold the button glass down to the bottom and hold it for another 2 seconds, and then hold the button for 2 seconds when it rises to the top and set it.

The consequences of changing the battery without permission.

Summary. Hello, your question is that after the battery of the 14 Skoda Octavia is replaced, the key does not have the function of one-key window lifting, how to set it? If your vehicle has been replaced with a battery, the key cannot be used to lock the car or unlock the one-button window lifting function.

First of all, you need to make the basic settings for the window regulators of the 4 doors with the vehicle powered on. The specific method is to hook the regulator switch upwards and hold it, wait for the glass to rise to the top, then release the camera switch to hook up again again, hold for 1 2 seconds, and then release. Then press the lifter switch downwards to let the lifter run downwards until it is released in the end, and then press and hold the switch down again for 1 2 seconds so that the lifter of the door is set up for 1 2 seconds.

Refer to the above method to make a lifter for the other three doors, turn off the ignition after the basic settings are done, then lock the car to unlock, and then lock the car again, you try again, the remote control key is lifted with one key, and the window function is normal and should be able to be used. I hope mine can help you.

After the 14 Skoda Octavia has changed the battery, the key does not have the function of one-key lifting the window, how to set it?

Hello, your question is that after the battery of the 14 Skoda Octavia is replaced, the key does not have the function of one-key window lifting, how to set it? If your vehicle has been replaced with a battery, the key cannot be used to lock the car or unlock the one-button window lifting function. First of all, you need to make the basic settings for the window regulators of the 4 doors with the vehicle powered on.

The specific method is to hook the regulator switch upwards and hold it, wait for the glass to rise to the top, then release the camera switch to hook up again again, hold for 1 2 seconds, and then release. Then press down the sock lifter switch to let the lifter run downward, release it in the end, and then press and hold the switch down again to hold the lifter for 1 2 seconds, and the basic setting has been completed. Refer to the above method to make a lifter for the other three doors, turn off the ignition switch after the basic settings are done, then lock the car to unlock, and then lock the car again, you try again, the remote control key is one-key lifting, and the window function is normal and should be noisy.

I hope mine can help you.

Thank you very much

You're welcome, I wish you a happy life and car.

The window can be reset when the one-key lifting fails, specific operations: 1. Press 6 times, let go of each press; 2. Every time you press it, you can see that the window is lowered; 3. When you press it for the 6th time, let go and find that the window is automatically raised, which means that the reset is completed; 4. Then the buttons are below when they are lifted upwards; 5. Lift the button for the first time to make the glass window reach the top and then let go.

The possible causes of the failure are:

1. The glass control lock on the driver's side is locked. Press and hold the button to lower the glass to the bottom and hold it for a few seconds, then raise the glass to the top and hold it for a few more seconds.

2. It may be a circuit problem, and you need to go to a 4S shop or a professional circuit repair shop to repair it.

After continuously raising and lowering the window glass several times, in order to prevent the glass lifting motor from overheating and damage, the window window lifting function may be temporarily turned off for a few seconds, please wait for the function to recover before operating. It may also be that the door control module is abnormal, the window regulator control button is out of order, the battery is not lit enough, etc., and the automatic lifting function of the power window window regulator may temporarily fail if the car battery is reconnected after disconnection.

Photo by Car Picker) Model Y Model 3 Model X AION V Ideal One Xpeng P7 2019

One-key window lifting operation, press the window to the end, release the button, then press the window lowering button for 5 seconds, then raise the window to the top, release the button, press the window up button for 5 seconds, and turn off for 1 minute. The instructions go like this.

The failure of one-key window lifting after battery replacement may be due to a locked glass control lock on the driver's side or a wiring problem.

The solution to the failure of one-click window lifting;

The glass control lock on the driver's side is locked. Press and hold the button to lower the glass to the bottom, hold it for a few seconds, then raise the glass to the top and hold it for a few more seconds. It may be a circuit problem and needs to be repaired by a 4S shop or a professional circuit repair shop.

After raising and lowering the window several times in a row, in order to prevent the glass lift motor from overheating and damage, the window lift function may be temporarily closed for a few seconds, or it may be that the door control module is abnormal, the window lifter control button is out of order, the battery is insufficient, etc. If the car battery is disconnected and then turned on again, the automatic lifting function of the car glass regulator may be temporarily disabled.

How Windows works:

The working principle of the power window is shown in Figure 4. The front door has a one-key lifting and anti-pinch function, so the BCM directly controls the front door switch and the front door motor to achieve one-key lifting and anti-pinch control, and the rear door motor does not have a one-key lifting and anti-pinch function, so it is not connected with the BCM. The switch on the driver's left side can control the lifting and lowering of not only his own window, but also the other three windows, and lock the lifting of the power window.

This design makes it easy for the driver to control the whole vehicle. The opening and closing of the other three doors only have the function of controlling the lifting of the window glass.