How does the aptio setup utility interface boot up normally?

The reason why this phenomenon occurs is that the partition type of the hard disk is not checked during installation, and after the ghost installs the system, the hard disk partition table cannot be recognized, and the BIOS phenomenon of boot jump appears from the surface, and the solution to this phenomenon is:

When the above picture appears, select the BOOT menu to see if there is a hard disk and a USB flash drive.

If there is no hard disk and USB flash drive, then you can restore the motherboard to factory settings.

As shown below: <>

Other methods:

For BIOS discharge, if the notebook is still under warranty, it is recommended to send it for repair.

1. In the boot menu, check whether there is a hard disk and a U disk, if there is no hard disk, only a U disk, then you can enter the U disk PE and convert the hard disk partition table to MBR partition.

2. In the boot menu, check whether there is a hard disk, if there is a hard disk and a U disk, you can try to start from the U disk, if it can't be started, then enter the U disk PE, check whether the partition ** is MBR in PE, if not, convert to MBR first, and then install the GHOST system.

The above is the response to the aptio setup utility interface in the U disk installation system, and friends who encounter this problem may wish to try the above solutions!

How does the aptio setup utility interface boot up normally?

Hello, according to your description, it is as follows: 1. Confirm that the power interface has been connected, and the power switch of the chassis is in the off state; 2. Press the power switch of the chassis to switch it to the ON state; 3. When booting up, first enter the BIOS setting interface, and follow the prompts to set the BIOS; 4. Press the F10 key on the keyboard to pop up the Amibios Boot Options, select EFI Aptio Setup Utility, and you can enter the Aptio Setup Utility interface. 5. At this time, you can make the corresponding settings in the aptio setup utility interface, and finally press the F10 key to save the settings and exit; 6. Convert the power call switch of the source chassis to the off state, and then switch to the open state, and the computer will be restarted to enter the normal operation mode.

Summary. The reason why this phenomenon occurs is that the partition type of the hard disk is not checked during installation, and after the ghost installs the system, the hard disk partition table cannot be recognized, and the BIOS phenomenon of boot jump appears from the surface, and the solution to this phenomenon is:

1. When the above picture appears, select the boot menu to check whether there is a hard disk and a USB flash drive, if there is no hard disk and a USB flash drive, then you can restore the motherboard to factory settings.

How does the aptio setup utility interface boot up normally?

The reason why this phenomenon occurs is because the partition type of the hard disk is not checked during installation, after GH OST installs the system, the hard disk partition table can not be recognized, and the boot jump BIOS phenomenon appears from the surface, the solution to this phenomenon is: 1. When the above figure appears, select the boot menu to check whether there is a hard disk and U disk, if there is no hard disk and U disk, then you can restore the motherboard to factory settings.

Dear, you can follow the **tutorial in this link.

Dear, give a thumbs up if you're satisfied.

Still can't do it.

Try this method dear.

Still can't do it. I can't get in.

Still can't do it. I can't get in.

If it doesn't work, it may be that the internal parts of the computer are damaged, so you can only find a professional to help repair it, so it is safer.