How can I see the FPS value in CS1 6?

First of all, turn off the vertical sync of the graphics card, and the second and most important XP system, the default monitor refresh rate is 60Hz, so even if you configure it well, no matter how you optimize it, adjust it, even if the display fps=99 is actually equivalent to 60, in a sense, the refresh rate of the display is fps... You need to set the refresh rate of the monitor to 100hz But you need to lock it If you don't want to enter the game or 60hz Next software Lock the refresh rate Lock the refresh rate of all your commonly used game resolutions to 100hz Generally 100hz is enough Lock the refresh rate of CS, the game resolution is 640*480 and 800*600 locked to 100hz, if the game resolution is 1024, it is locked to 85hz, the relevant tools go to search for it, search for the name" cs locks the refresh rate".

This problem can definitely be solved, enter fps max 101cl showfps 1 in the CS console, look at your fps, shoot and feel it, you will know that the contraction is much better, there is no delay, and in the game, press the button on the settings on your monitor, find the display status (it seems to be this name), you can see that 100hz is considered to be locked, otherwise you have to continue to lock until it succeeds.

If the 98 system only needs to turn off the vertical synchronization, except for 98, you need to solve it according to the above.

CSGO display FPS setting method: First of all, you need to open the console: game start screen - "Options" - game settings" Find "Enable Developer Console ( ) and select "Yes" After that, you can open the console by pressing the " " button (below ESC) in the game.

It can be displayed by entering the corresponding command in the consoleNumber of frames(fps) and network parameters.

Command introduction: net graph 1 enables the display of frame rate and network parameters, and net graph 0 turns off Enter "net graph 1" in the control and finger station, and then the frame rate (fps) and network parameters (ping, loss, choke, etc.) can be displayed in the lower right corner.

Modify the display position of the parameters (left, center, and right): the NET Graphpos 0 parameter is displayed on the left side of the page, the NET Graphpos 1 parameter is displayed on the right side of the PAGE, and the NET Graphpos 2 parameter is displayed in the middle of the page.

Modify the parameter display position height (detailed to pixels) method: net graphheight value, the larger the value, the higher the position.

Modify the font size of the parameter display (two): net graphproportionalfont to make the parameter font smaller Jane, net graphproportionalfont 1 to make the parameter font larger (default).