Hello, H6 rear glass can t be lifted, is there a problem?

The window glass can't be lifted, the switch is fine, the wiring is fine, the motor is fine, sometimes it can be used, sometimes it can't be used, and when it can't be used, the relay doesn't respond. When I can use it, I press down the gap to rise, and I cannot go down.

Three common fault causes and maintenance methods of automobile glass regulators:

1. Abnormal sound of glass vibration. This indicates that the glass regulator screw may be loose, and the solution is to tighten the regulator screw;

2. The glass regulator is stuck. This failure may be caused by deformation or damage to the glass mud groove and loose fixing screws of the lifter.

Deviation of the installation position of the moving and guide rails or damage to the glass regulator. The maintenance method is mainly to clean and replace the glass mud tank or loosen the glass.

Glass mounting screws to adjust the position of the glass.

3. All glass regulators cannot work. The cause of this failure may be the detachment of the tie wire of the combination switch and the total power supply.

Wire detachment, poor relay contact, damage, or lockout switch poor contact or not closed. The repair method is to overhaul the circuit. Hand.

The principle of stirring the window is that there is a gear in the center of the handlebar, and there is also a curtain of knife-shaped chainrings on the glass lifting linkage mechanism, as long as one turn.

The grip and gear drive the chainring, which will make the glass go up and down a specific track. Nowadays cars are using electric windows, and electric windows only.

However, the crank part is changed to be driven by an electric motor, and the direction of the current is controlled by the switch to change the direction of the motor.

toward, let the glass window rise. One of the most important responsibilities of the glass window in the car is to protect from the wind and rain, so in the glass frame.

There are rubber seals on all sides, so that the glass can be close to the body, to achieve the function of wind and water resistance.

Glass regulator is a lifting device for automobile door and window glass, which is mainly divided into two categories: electric glass regulator and manual glass regulator.

Now the lifting (closing and opening) of many car door and window glass has abandoned the manual lifting and lowering mode of rocker type, and generally change to the electric lifting mode of button type, that is, use electric glass regulator. The electric glass regulator for cars is mostly composed of an electric motor, a reducer, a guide rope, a guide plate, a glass mounting bracket, etc. The general switch is controlled by the driver, the opening and closing of the whole door window glass, and the sub-switch on the handle of each car door is controlled by the occupant respectively, and the operation is very convenient.

If only this one can't be lifted, it may be a safety and switch, and then if it's okay, remove the door panel and measure the power supply and iron of this motor.

The H6 rear glass cannot be lifted, either the lift switch is broken, or the lift is broken.

The lifting was not in place, and the rubber strip was changed several times.

First of all, confirm whether the rear door lifter switch on the left front door combination control switch can control the glass lifting of the rear door, if so, it is recommended to see if the super function key on the combination switch turns off the rear lift function. If it is not turned off, the rear lifter switch should be suspected.

If the front cannot control the rear lifter, it is recommended to check the control safety or related computer.

The windows are dual controlled, and the main driver and co-pilot switches are normal to be controlled, or it is a problem with insurance.

The main driver has a switch, and the other doors cannot be raised or lowered after closing.

The main driver can't control the other three doors, or the other three doors can't be controlled separately.

I also have a car here that is also problematic

The reason why the rear window can't be raised and lowered is that the car has turned on the window lock button.

Press the window lock switch, the indicator light on the switch will illuminate, at this time the window switch on the rear door armrest will not work, and the window cannot be controlled to raise or lower. To disable this function, press the switch again.

In this case, it is recommended that you check your vehicle's glass regulators, lift switches, and door harnesses. In addition, the glass channel groove loses its lubrication effect due to the aging of the guide groove rubber, resulting in a certain degree of resistance, so the glass rises slowly. Because you can't see the actual car and can't make an accurate judgment of the fault, it is recommended that you contact your local 4S shop for inspection and maintenance.

Haval H6 two rear door glass can not be lifted, what is the reason?

Hello! First of all, confirm whether the rear door bending old descender switch on the left front door combination control switch can control the rear door buried which liter of the glass is lowered slowly, if so, it is recommended to see if the super function key on the combination switch turns off the rear lift function. If it is not turned off, the rear lifter switch should be suspected.

If the front part cannot control the rear lifter, it is recommended to check the control fuse!

If the two rear door glass regulators do not respond to the curved oak, this is mainly due to two reasons, on the one hand, it is caused by the damage of your glass regulator, and on the other hand, it is because of the fault with the wiring of the glass regulator. This inspection is relatively simple, is to remove the door panel of one side of the door, and then check whether there is electricity on the glass regulator motor, if the motor has electricity, that is, the glass regulator is buried next to the machine and directly replace the glass regulator can be replaced, if there is no electricity, then you need to check whether the power supply between the switch to the glass regulator is normal, whether the power supply of the glass regulator switch is normal, and then check the circuit according to the test results.

Summary. Hello, I am happy to answer your car master exclusive technician to answer your car questions sincerely and sincerely for you, and find solutions and methods for you to ask questions. The Great Wall H6 owner can not lift the glass when driving, and the common reason is that the glass motor is damaged or the door hinge position line is broken.

After the door trim panel can be opened, check whether the circuit is normal, the line can be broken and connected, whether the motor is damaged, the cost of replacing the motor is about two to three hundred yuan. Hope mine is helpful to you.

Dear, this question is up to me, it takes a little time to type, please be patient, thank you!

Hello, I am happy to answer your car master exclusive technician to answer your car questions sincerely and sincerely for you, and find solutions and methods for you to ask questions. The Great Wall H6 owner can not lift the glass when driving, and the common reason is that the glass motor is damaged or the door hinge position line is broken. You can open the door trim panel after Lu Zhao, check whether the remaining lines are normal, the line is broken and connected to Chang Xi roll, whether the motor is damaged, the cost of replacing the motor is about two to three hundred yuan.

Hope mine is helpful to you.