When I open a hard disk partition on my computer, it can t be opened, and it shows that it wants to

If the partition is broken, if there are no important numbers in the partition, try to format it first, if there is important data in it, you should recover the data first and then restore the data, because formatting will affect the data recovery effect;

You can use the "Recover Files in Partition" function of Data Recovery Wizard to recover data, first scan the partition, you can see the data in the partition after the scan is over, and then you can double-click to preview the file and copy the file you want to recover.

There is an error in the panel or a misoperation formatting,It is recommended that you use the installation disk to start to see the partition,If there are no important files,Try it first,Of course,If you have time,First detect that there is a bad sector,If it is a logical bad sector can be repaired,If it is a physical bad sector,It is recommended not to repair it。。。

Kill the virus first, if it doesn't work, it may be a broken partition; If you have important data in the partition, try formatting; If you have important data, recover it first, and use DiskGenius to recover the data first.

Then format it again.

Kiss. There are three scenarios for this:

1. It may be a virus, use antivirus software to kill the virus.

2. There may be a problem with the partition table, and you can re-divide the partition.

3. If the above two situations are not good, dear.

Then it's a bit of a cup.

The hard drive is broken.

It is for you to take the hard drive to another computer and install the system, and then install it back.

How do you use it as a portable hard disk, and now the other 3 partitions of that hard disk are not very slow to access files? If that's the case, your hard drive is scrapped.

When opening the partition, it prompts formatting, and the hard disk is required to be formatted due to hardware problems, which is usually caused by MBR damage. First of all, it is recommended to remove the hard disk, find another computer, connect the hard disk to the slave disk, and then detect the bad sector condition of the hard disk through MHDD. If the bad sector is detected, it is necessary to immediately cut off the power and stop the operation, power-on may lead to the aggravation of the bad sector fault, if the data is important, it is recommended to find 51recovery to help recover; If there is no bad sector, you can judge that it is caused by MBR corruption, if the data is not important, you can directly format and repartition, if you need the first choice of data or through 51Recovery for the formal recovery process.

If you want to operate by yourself, you must connect the slave disk, remember to save the data scanned by easyrecovery to the main disk, in short, do not do any writing operations on this hard disk, once there is a write, it will involve overwriting, which is likely to cause the data to be unrecoverable.

Unformatted means that the partition has been logically deleted, but no physical operation has been performed;

If you need to rescue the above data, please do not format it, just take it to the place where the computer was repaired for data recovery.

Prompt: Formatting is a typical dbr problem, it can be fully recovered, as long as the dbr is repaired, you can click my name hi me below, it can help you recover successfully remotely, looking forward to your question.

unallocated space] again.

partition , after which it is formatted.

After the check, use Diskgen or Easy Me Partition Table Doctor to get back the partition table of the E disk to ensure that your E disk is of the Disk E.

None of the files are small, even if they are divided, they will be fine.