How to make dry tobacco soft and how to make dry tobacco

Tobacco selection: no matter how special flavors and spices, it is only an auxiliary role, the mellow aroma of real cigarettes comes from the tobacco itself, the fragrance and quality of tobacco are the soul of cigarettes, and all the processes behind are just to give full play to the fragrance of tobacco leaves. Therefore, choosing a good tobacco leaf is the key to homemade tobacco.

Open. Knife shredding: first of all, the tobacco leaves are moistened, the humidified tobacco leaves are to prevent the tobacco leaves from being crushed when cutting the tobacco, and can be cut into thin strips, the way of humidification is also very simple, when the weather is humid, put it outside the next morning, the tobacco leaves will be naturally damp;

Another method I've experimented with is to spread the tobacco leaves on the newspaper, take them to the bathroom, turn on the water heater, and let the hot water mist wet the tobacco leaves, which is very fast. Under normal circumstances, a pound of tobacco leaves can be made if it is cut very finely.

If you roll a cigarette by hand, you can cut it in ten minutes, and if it is a pipe cigarette, it will be even faster. Cutting tobacco is like cutting vegetables, you can do it on a cutting board.

Flavor stirring: Mix the honey with wine and put it into a watering can; Sprinkle the malt flour on the shredded tobacco and stir; Spray honey and liquor evenly on the tobacco and stir Here, the choice of liquor is based on your own taste, you can use Wuliangye for the strong flavor type, and Moutai can be used for the sauce flavor type, and the actual taste of the second pot head is very good, economical and cost-effective.

Stir-fry the tobacco: After the tobacco is sprayed with wine and honey, fry the soybeans and tobacco at the same time (don't be too anxious) When the golden tobacco turns dark yellow and close to red, stop! At this time, it may be broken (you can try the microwave, I haven't tried it, if you use the microwave it may not be broken, it is better) sift it through a sieve.

Bottling and fermentation: The fried tobacco is sealed in a glass bottle and opened for a month to enjoy. The fragrance is fragrant and the taste is positive, which is better than any kind of tobacco on the market, mainly because it is environmentally friendly and safe.

1. First of all, cut the fresh tobacco leaves, as shown in the figure below

2. Cut the tobacco leaves from the top down, as shown in the figure below

3. After cutting the tobacco leaves with a sickle, flatten the tobacco stems and put them in the back basket, as shown in the figure below

4. Then dry the tobacco leaves one by one, as shown in the figure below

5. After the moisture of the tobacco leaves is slightly dry, fix the tobacco leaves one by one with a brown rope and hang the tobacco leaves in the sun to dry.

6. In the evening, the tobacco leaves need to be rolled up and put away from the end of the rope, as shown in the figure below

7. The next day, the tobacco leaves are opened to dry, and the tobacco leaves are turned over to dry after half an hour, as shown in the following figure

8. After repeating for a week, the tobacco leaves are dried and put away for preservation, and the dry tobacco is prepared.

Summary. Hello dear, the method of preparing dry tobacco: 1. Prepare one or several durable plastic bags.

Because the flavored tobacco should be sealed, before the flavoring, the tester puts a small amount of tobacco into several bags to select the satisfactory flavor, so as not to waste your tobacco raw materials unsuccessfully. 2. Drizzle the tobacco with white wine and diluted honey. It feels more appropriate to use it like a spray bottle.

They can be sprayed separately in separate plastic bags with different amounts and proportions to compare their taste. 3. Stir to mix the tobacco and seasoning thoroughly. It is then sealed and stored in a fully airtight space for 1 to 5 hours to allow the tobacco to fully absorb the flavors.

4. Open the plastic bag and spread the tobacco thinly on a piece of paper, let the tobacco dry naturally, and let the tobacco retain a certain amount of moisture. 5. If the tobacco has not yet reached the desired taste, put the tobacco back into the plastic and spray the wine and honey as before. Then remove the tobacco and let it dry until it reaches your preferred humidity.

6. Prepare a container that can be sealed, put the mixed tobacco into it and seal it. So that the tobacco does not dry out quickly and loses its flavor. Generally, it can be stored for about 2 months.

In this way, the prepared dry tobacco is basically completed!

Hello dear, the method of preparing dry tobacco: 1. Prepare one or several durable plastic bags. Because the flavored tobacco should be sealed, before the fragrance, the tester uses a small amount of tobacco to put it in several bags and select the satisfactory taste, so as not to waste your tobacco raw materials unsuccessfully.

2. Drizzle the tobacco with white wine and diluted honey. It feels more appropriate to use it like a spray bottle. They can be sprayed separately in separate plastic bags with different amounts and proportions to compare their taste.

3. Stir to mix the tobacco and seasoning thoroughly. It is then sealed and stored in a fully airtight space for 1 to 5 hours to allow the tobacco to fully absorb the flavors. 4. Open the plastic bag, spread the tobacco thinly on a piece of paper, let the tobacco dry naturally, and let the tobacco retain a certain amount of moisture.

5. If the tobacco has not yet reached the desired taste, put the tobacco back into the plastic and spray the wine and honey as before. Then remove the tobacco and let it dry until it reaches your preferred humidity. 6. Prepare a container that can be sealed, put the mixed tobacco into it and seal it.

So that the tobacco will not be sold in orange liquid, dry quickly, and lose its flavor. Generally, it can be stored for about 2 months. In this way, the prepared dry tobacco is basically completed!

Thank you for your consultation, hope! <>

To make dry tobacco softer, you can take the following measures:1Humidification:

Place the dry tobacco leaves in an airtight container and humidify them with some moistened paper towels or cotton cloths in the container. In this way, the dry tobacco leaves will absorb the moisture of Zhou Huai Minwei and become softer. 2.

Patting: Place the dry tobacco leaves on a clean table or flat plate and gently pat the surface of the dry tobacco leaves with your hands or other tools (such as rubber maces, etc.), which will make the fibers of the dry tobacco leaves soft and easier to roll. 3.

Steam heating: Heating with steam can also make dry tobacco leaves soft. Put the dry tobacco leaves in the pot, then add water to heat, open the lid, and let the steam in the pot wrap the dry tobacco leaves for steaming and roasting.

Be careful not to let the dry tobacco leaves get too wet later than they get wet. Although these methods can soften the dry tobacco leaves, be careful not to make the dry tobacco leaves too moist, otherwise it will affect the quality and taste of the cigarette rolls. At the same time, due to the obvious harm of tobacco products, it is recommended to minimize the frequency and amount of smoking for the health of individuals and others.

Summary. There are several ways to make dry tobacco softer. The first is by soaking, where dry tobacco leaves are soaked in water, which can make them soft.

Secondly, you can add some humidity regulator to increase the moisture content of tobacco leaves, which can also achieve the purpose of making tobacco leaves softer. In addition, the softness of tobacco leaves can also be greatly affected by the choice of appropriate storage methods, such as storing tobacco leaves at a stable humidity and temperature.

Excuse me, but please go into more detail?

There are several ways to make dry tobacco softer. The first burial is through soaking, and the dry tobacco leaves are soaked in water, which can make them soft and soft. Secondly, you can add some Burn Fuel Humidity Regulator in an appropriate amount to increase the moisture content of tobacco leaves, which can also achieve the purpose of making tobacco leaves softer.

In addition, the softness of tobacco leaves can also be greatly affected by the choice of appropriate storage methods, such as storing tobacco leaves at a stable humidity and temperature.

First of all, what you need to do is to fold the dry tobacco leaves in half, put the knife in the middle with a flat knife, and then slowly separate the dry tobacco leaves to the left and right two years old, and then you can flatten the shape of the dry tobacco leaf clump appropriately, but don't use too much force, so as not to deform the shape of the leaves, and the last thing to pay attention to is that there are a lot of impurities such as tobacco residue or pollen in the leaves, and they should be cleaned up thoroughly, leaving no impurities to affect the quality of the leaves. Only in this way will the smoke have a better taste and effect.

The purpose of drying dry tobacco leaves is to allow the tobacco leaves to reach a suitable degree of dryness, thereby improving the quality and taste of the tobacco. Here are a few steps to dry dry tobacco leaves:1

First, choose a suitable venue. It is best to use a well-ventilated, sunny place and avoid dust or odors. 2.

Spread freshly picked tobacco leaves flat on a smoke rack or string, trying to keep the spacing between each leaf to ensure smooth air circulation. 3.Pay attention to sun protection.

When drying tobacco leaves on a sunny day, try to avoid direct sunlight so as not to destroy the nutrients of tobacco leaves. It can be covered or adjusted at the right time to keep the tobacco leaves exposed to the right amount of sunlight. 4.

Pay attention to flipping and jitter. During the drying process, the tobacco leaves should be turned at regular intervals to ensure that they are evenly heated and dried. At the same time, the leaves can be shaken at the right time to make them better dissipate moisture.

5.Depending on the characteristics and humidity of the tobacco leaves, the drying time is generally 1-2 weeks. In the process of drying, you can check the degree of drying of the leaves in a timely manner as needed to ensure that the tobacco leaves are moderately dry, neither too dry nor too wet.

After drying, the dry tobacco leaves can be used for smoking. Remember to keep it in a cool, dry place to preserve the quality and taste of your tobacco. Hope the above helps!