Will too much original engine oil cause Audi Q5 to burn oil?

This has some impact, although many Volkswagen cars burn engine oil, but the quality of the engine oil used is better, which can protect the engine well, even if there is a case of burning engine oil, it can also clean the carbon deposits of the engine and prolong the service life of the engine. So I've been using fully synthetic engine oil, the original fully synthetic before, after the warranty was replaced with GT Magic Red engine oil, PAO base oil, good quality, enough power, mileage is longer than the general full synthesis, although now the car has not burned engine oil, not enough insurance points are always right.

The engine of the Audi car is relatively easy to burn the engine oil, which is a design loophole of the designer, and many German cars have this problem, and you are not alone.

First of all, you need to confirm the reason for burning engine oil, and the main reasons for burning engine oil are two aspects.

First, there is a problem with the accessories, the waste gas valve, the valve seal, the cylinder is pulled in the cylinder, and the cylinder pressure is insufficient.

The second is that the oil circuit is not cleaned for a long time, the antifreeze is not replaced in time, the oil service life is too long, and the piston ring is stuck, and the more common situation is that the piston ring is stuck.

Causes of piston ring seizure.

In fact, the treatment principle of piston ring stagnation should start from the oil circuit, the reason for the stagnation is the beginning of the oil circuit, the oil bearing temperature is 110 degrees, and the high temperature caused by the long-term unclean oil circuit makes the oil at a temperature of 120 degrees or higher for a long time, so that the oil will be exhausted in advance, the small hole of the oil ring is very small, and the oil inside will be dried and scabbed for a long time, and a cylinder stuck is 5000 kilometers of a liter of oil, at this time, the working conditions of other cylinders will also begin to be bad, and soon the 4 cylinders will be stuck. It becomes a liter of engine oil for 1000 kilometers or even hundreds of kilometers. Therefore, in order to solve the problem, we must start from the root oil circuit, which is the way to remove the root.

The solution to burning engine oil in Audi cars.

First of all, you need to check the accessories. If it is a damage to the accessory, the accessory needs to be replaced. Check if there is a serious problem with the cylinder. If there is a serious situation of pulling the cylinder, you can directly choose to overhaul the engine and replace the middle cylinder. If there is no pull cylinder or slight pull cylinder, you can do not rush to overhaul it first.

Burning engine oil is not a terminal disease, there is a way to solve it, and it is not necessary to overhaul the engine. Overhaul is self-evident on engine damage, and many car owners will still burn engine oil after overhaul. At present, the solution to the problem of burning engine oil has matured, so there is one more option for the treatment of burning engine oil!

As long as you use the general burning oil repair agent for 4 times in a row and drive more, you can clean the carbon deposits on the top of the piston and release the piston ring.

The solution to burning engine oil in Audi link.

In order to protect the engine and prolong the life of the engine, German cars are designed to reduce the frictional resistance between the piston ring and the cylinder wall, and an oil film will be formed in the cylinder wall, and part of the oil film will be burned off with the gas burned at high temperature, so the oil loss is more than the same period last year.

1. The processing technology of the engine cylinder of Audi car, the engine cylinder wall is shown as a mesh under the microscope, and each small mesh is a "small oil depot" for storing oil, and the piston has better lubrication performance than the flat cylinder wall when running up and down in the cylinder, which also minimizes the wear between the piston ring and the cylinder wall.

2. The toughness of the piston ring of the Audi car is better, and the degree of tension is weaker than that of the Japanese car, simply put, it is strong, but the elasticity is small, and this matching naturally reduces the wear and tear caused by the piston ring running up and down on the cylinder wall, so the Volkswagen car has traveled hundreds of thousands of kilometers to measure the wear of the cylinder wall of the engine, which is much smaller than that of other car series, and the engine can still maintain good working condition.

3. The engine is like the heart of the car, the engine burns oil in the final analysis, or the piston ring has a problem, under normal circumstances, there is no oil loss of 1000km, if it exceeds too much, it is possible to burn oil. If there is a problem with the sealing of the piston ring, the oil will follow the movement of the piston and secretly drill into the combustion chamber to participate in the combustion, and then the oil will be burned.

4. In order to prolong the service life of the engine, Audi car manufacturers burn engine oil.

Precautionary measures for burning engine oil:

1. Use high-quality engine oil

Engine oil is very easy to corrode and age in a long-term high temperature state, resulting in the oil film becoming thinner, and it is easier to escape to the combustion chamber to participate in combustion, so the use of high-quality engine oil can greatly delay this phenomenon.

2. Pay attention to the cleanliness of the fuel circuit

Carbon deposition is indispensable in the combustion process, and carbon deposition is the root cause of some automobile failures, such as the aging of valve seals, piston wall clearance, etc., which are directly or indirectly related to the formation of carbon deposition, so keeping the fuel oil circuit clean is of great help to prevent burning engine oil, of course, this needs to be done with the help of high-quality fuel additives.

3. With the help of external forces

Considering the relationship between domestic oil products, it is necessary to use high-quality engine oil and (PNF) fuel additives to achieve, which is also the key to solving the problem of burning engine oil without dismantling and repair.

Burning engine oil is blue smoke;

If it doesn't burn well, it emits black smoke;

The water ingress into the combustion chamber of the engine is white smoke;

No matter what kind of car, as long as the oil is not wear-resistant, it will definitely wear out, and if it is worn, it will burn the oil, don't trust those so-called masters, it's almost the same as killing people with knives;

A lot of high-end cars are burned; It is a problem of mechanical assembly, and it is useless to overhaul it.

You go to find super American eutectic engine oil, you can burn engine oil, and you don't have to spend money in vain;

Go to the 4S store for a physical examination, there are many reasons for this thing.

Audi "burns engine oil" so seriously, why do so many people still buy it?

The engine has been running for more than 100,000 kilometers, and the wear and tear has reached a certain level, and the oil consumption will exceed the limit.

Burning engine oil will cause adverse consequences such as decreased power, increased fuel consumption, slow speed-up, and blue smoke exhaust, which will affect normal use.

It is recommended to send it for repair as soon as possible.

In the eyes of Chaomei eutectic not burning engine oil, burning engine oil is really a small problem.

How much to burn? Try changing the oil;

The oil is not anti-wear;

Some car owners have used super American eutectic engine oil, burning 1 liter for 1,000 kilometers, without disassembling the engine, which solves the problem of burning engine oil.

Hello in how many kilometers the car travels in which year.

It is a very common phenomenon for Audi to burn engine oil, in fact, no matter what car type of engine has a certain amount of oil consumption, it is not that you think that it is not burned or not, but the performance is not obvious, but excessive consumption is to burn engine oil. As long as there is no serious strain on the cylinder wall, there is no need for major repair.

Most of the engine oil is caused by the piston ring being trapped by carbon deposits. Relying on the addition of high-viscosity engine oil to continue life is only an expedient measure to cure the change. When the oil enters the combustion chamber to participate in combustion, more carbon deposits will be formed, which in turn will lead to the aggravation of the burning of engine oil, forming a vicious circle.

In the long run, it will cause cylinder wall strain, or even cylinder burst, and finally the engine can only be disassembled for overhaul.

Four reasons why you burn engine oil.

A ...If you don't clean the oil circuit for a long time or don't do effective oil circuit cleaning, detergents are used at will, and using detergents and effective detergents are two different things;

IIThe antifreeze replacement cycle is too long or not changed at all;

IIIThe oil change interval is too long;

IVLong-term or often short-distance driving.

The above four points of the vehicle that burns engine oil must be occupied by one or all four points.

How the piston rings are stuck.

The principle of piston ring stagnation should start from the oil circuit, the oil temperature is 110 degrees, and the high temperature caused by the long-term unclean oil circuit makes the oil at a temperature of 120 degrees or higher for a long time, so that the oil will be exhausted in advance, the small hole of the oil ring is very small, and the oil inside will be dried and scabbed for a long time. It becomes a liter of engine oil for 1000 kilometers or even hundreds of kilometers. Therefore, in order to solve the problem, we must start from the root oil circuit, which is the way to remove the root.

The solution to burning the oil.

In the habitual thinking of car enthusiasts, they always think that burning engine oil should be overhauled, so that they not only have to bear high maintenance costs, but also bear the unpredictable risks and depreciation losses brought about by the overhaul. Destroy the airtightness and precision of the engine. And there is a possibility that the engine oil will burn again after tens of thousands of kilometers, so overhauling the engine is not sustainable.

Now the no-dismantling technology has been very mature and gradually accepted by the majority of car owners. In particular, the non-destructive repair products containing PNF patented technology have completely gotten rid of the technical shackles of the operation of the auto repair shop, and the owner can operate it himself without removing a screw, and the piston ring is repaired and released during driving, and the effect is remarkable.

The oil itself has a certain amount of consumption, and this consumption is normal. If you consume too much, there is a problem of burning engine oil. Burning engine oil is caused by the following factors, as long as the following problems are solved, burning engine oil can be solved.

There are many factors that affect the burning of engine oil, such as: fuel quality, driving conditions, driving habits, maintenance habits, etc., the above reasons will aggravate the oil consumption and lead to the burning of engine oil, making the vehicle appear:

1. Carbon deposition occurs in the combustion chamber, which makes the gas ring of the piston ring stuck, and the sealing is poor.

2. Oil sludge is generated in the lubrication system, and the oil sludge blocks the oil return hole of the oil ring and weakens the oil scraping performance.

3. Wear occurs between the piston and the cylinder wall.

4. The valve seal is corroded and aging, and the sealing performance fails.

In addition, cars now have crankcase ventilation systems (exhaust valves), which can also exacerbate oil consumption if there is a problem. In the past, the problem of burning engine oil could only be solved by dismantling and repairing, but now there is a plan to solve the problem of burning engine oil without dismantling and repairing.

Burn the engine oil to get power, but the improvement can burn a little less.

When the Audi Q5 has a gas engine oil situation, the owner can try to solve it through the following methods: choose better quality gasoline and engine oil; Old cars can choose a slightly higher viscosity oil to increase the sealing between the piston and the cylinder wall; Check the oil ruler frequently, regularly replace the oil and oil filter according to the requirements of the product instruction manual, and replace the first oil filter spare parts; Avoid brutal driving and big throttle acceleration and so on.

Si Youpu said that the car should always pay attention to regular oil replacement, regular and timely cleaning of carbon deposits, and can use Si Youpu fuel cleaners from the beginning of the new car to prevent excessive production of carbon deposits, which can avoid overhaul and burn engine oil.

Hello, how to say it German cars generally burn engine oil after a long time, there are various reasons for burning engine oil, Volkswagen Audi is generally due to bad pistons, exhaust valves, and turbochargers, now the most ** is already an improved version, compared to the previous will be much better, plus good maintenance, generally will not appear, if the oil is also a long time after the time can be overhauled, you can also change the car I hope it will help you.

What is Burning Engine Oil? The car exceeds the normal consumption of oil. The standard defined in our country is that 1000 kilometers must not exceed the liter oil consumption.

Theoretically, the engine only burns gasoline when it works, and the main role of engine oil is to lubricate parts and components, and the two are not related to each other. But in fact, it is impossible for any engine not to burn oil, the main reason is to lubricate the cylinder wall, when the engine is working, the oil will keep throwing on the cylinder wall, due to the existence of cylinder clearance, it is inevitable that a small part of the oil will be burned together with gasoline.

Audi Q5 engine oil is not an exception, it is more common, I am the Q5 car, now it is continued with engine oil, using GT magic red, the oil quality is good, there will be no carbon deposit, the power is similar to the oil that was not burned before, the engine oil is the base oil of the four types of PAO, the quality is very good, there will be no carbon deposit, there is no problem with normal driving.

There are two solutions to burning engine oilOverhaul of the engine.

Do not disassemble, do not repair, repair and burn engine oil.

There are several conditions that must be met for an overhaul of an engine.

insufficient cylinder pressure; The trouser wall of the cylinder bureau is seriously worn;

Air ring counterpart. If the above conditions are not met, there is no need to overhaul the engine.

Drawbacks of overhauling the engineThe multi-person operation technology is not unified and the assembly is not good, the hot and cold values of the engine assembled at room temperature are not enough, the overhaul is 1-40,000, and the vehicle is depreciated by 3-60,000. The disadvantages of overhaul: do not turn on the engine as a last resort, after opening, there are traces of disassembly, the car instantly depreciates a lot, and the result of assembly is unknown.

In the process of dismantling and assembly, the humidity of the air, constant temperature, low temperature are unable to meet the environment of the dust-free workshop operation, there are many people in the plugging and assembly, the technology is not the same, and the assembly can not ensure the stability of a machine because of the screwing and other links, often the later car volume is unable to consume fuel, shaking and other phenomena are found.

The disadvantages of burning engine oil without major repairsIt is necessary to do a relatively complete inspection, according to the condition of the silver call car to check the exhaust valve, valve seal, turbocharger, cylinder wear and other accessories, of course, not all check, different cars and different vehicle conditions check the content is also different.

At present, Tongbo Jane is a better solutionBecause overhaul and dismantling is something that many people do not want to see, non-destructive repair is a relatively safe and low-cost way at present. The problem of burning engine oil can be solved from the root.

The solution to burning engine oil in Audi link.