What to do after the car wades in the water, and how to operate it

1. If there is water ingress and stalling during the wading process of the vehicle, turn off the ignition switch immediately, do not try to start the engine again, move the vehicle to a safe place, and try to make the vehicle high in front and low in the rear, so that the water entering the exhaust pipe can flow out and avoid damage to the three-way catalytic converter and muffler.

2. After judgment, if the water enters the engine, the spark plug should be removed, and the motor should be used to transport the motor after artificially cutting off the fuel supply system and ignition system, so that the water entering the engine can be discharged smoothly. At the same time, check the oil status of each system of the vehicle, and replace it in time if there is foaming and turbidity. After the test is completed, compressed air should be used to clean the electrical connection parts inside the engine compartment to prevent corrosion caused by moisture accumulation in the electrical connection parts.

The key removal areas are: fuse boxes, sensor plugs, and water accumulation in the body. After the cleanup, the vehicle road test is carried out to confirm that the engine is free of abnormal noise during driving.

If there is significant driving noise, check the engine bearings and rotating parts.

3. If the water enters the compartment in the wading, the maintenance process is mainly to clean up the water in the car, and there are several sealant plugs located in the lower part of the vehicle chassis, and the water in the compartment can be released when the rubber plugs are opened. However, due to the strong water absorption of the interior decoration material floor glue, the floor glue should be removed, placed in a spacious space to facilitate the evaporation of water, after installation, it is also necessary to pay attention to turn on the air conditioner, adjust the vehicle circulation switch to the internal circulation, so that the water vapor in the compartment is discharged out of the car through the air conditioning system, which is a very fast dehumidification method in summer.

4. Chassis parts are easy to cause deterioration of lubricating oil in the process of wading, especially when it comes to steering, transmission and other systems. For example, the maintenance manual requires the Land Cruiser to grease the chassis components after wading through water. At the same time, you should listen carefully to the chassis for abnormal sounds during the road test, or disassemble and inspect the chassis.

First of all, as long as the water depth does not exceed the air intake, the car will not turn off. There is no problem.

If there is no flameout when passing through the water, then there is no effect on the engine, only automatic flame-off and breakdown. After deep water, it will generally cause short circuit of wires, poor contact, water ingress into the engine, rust on the car body, fabric, sound insulation layer, etc., mold, etc. So after wading through the water, open the front machine cover, 4 doors and trunk, dry it to avoid moisture erosion, and check it carefully.

Of course, wading in the water also has to pass through at one time, even if the car is soaked in water. After a long time, the water came in.

Even professional top-of-the-line off-road vehicles should try to avoid wading, and racers will not wade unless they have to.

Wading in the water is too risky. In case the water exceeds the limit, the car floats up, loses grip, and can't get out of trouble, just wait for overhauls.

The next time you have to wade into the water, look at the approximate height of the water, and the engine should not be flooded when the water depth is about half the height of the tire. After the water recedes, it can be driven to the maintenance shop for chassis or exhaust pipe cleaning. When the water depth exceeds half the height of the tires, the engine compartment and the passenger compartment may have been flooded, and the electrical system will be flooded and short-circuited.

At this time, do not start the engine rashly, and after the water recedes, please tow the tow truck to the repair shop for repair. If you start the car rashly, it can cause serious damage.

Post-wading measures:

Check the electrical system.

Immediately remove the wrapping from the electrical part, wipe off the wet part, and install the fan belt. Check whether the gearbox is soaked in water, whether there is drift blockage between the radiator plates of the water tank, whether the tires are damaged, and whether there are aquatic weeds under the chassis.

Clean the vehicle in time to restore the braking effect. Do not attempt to start until you have determined that the electrical system, engine components, etc., have not been flooded, so as not to cause further damage.

Reasons why the car waded and stalled:1Water enters the inside of the cylinder through the engine intake mechanism; 2.

Water enters the exhaust pipe; 3.The electrical system is flooded and short-circuited. What to do after the car wades and turns off:

2. If you accidentally encounter flooding while driving, the owner should turn off the engine immediately and take measures to tow the car to a safe place with less water as soon as possible. Once the engine is turned off, do not restart the vehicle, because restarting the cylinder that has been flooded will be hit by compressed water, causing serious wear and tear on the engine piston, cylinder block, etc., and even causing the engine to be scrapped. What's worse is that the insurance company will refuse to pay for the resulting losses on the grounds of "improper operation by the car owner".

3. After the engine is turned off, the car should be sent to the maintenance shop for maintenance in time to avoid greater losses. Tip: When driving in rainy weather, be sure to pay more attention to the road conditions ahead, so as not to cause the vehicle to stall when driving into a puddle and bring unnecessary trouble to yourself.

When encountering waterlogged roads, you should observe carefully.

First, you should slow down or stop and observe. As long as the water level reaches two-thirds of the bumper or tire, there is a certain danger of wading in the water, so you should try to detour and do not force your way through. When passing through stagnant water, if the vehicle is too fast, it will increase the actual depth of the car's crossing, causing rainwater to easily enter the cab from the engine compartment or chassis.

Finally, care should also be taken to avoid driving in the opposite direction of the big car.

How to operate a car when wading in water.

Do not change gears or collect oil when wading in water.

In addition to maintaining a low speed when the car is wading, it is also necessary to try not to stop, not to change gears, not to throttle, and not to accelerate. It should pass at a constant speed in low gear and at high throttle.

Water should be removed for the brake pads after wading.

After the car wades in the water, the water of the brake pads should be removed in time, especially the car with drum brakes, otherwise the vehicle will lose its brakes after wading, causing serious danger or accidents. The specific operation is: low-speed driving at the same time step on the accelerator and lightly step on the brakes, people who do not know how to use one foot can step on the brakes many times, at this time pay attention to the speed must be slow.

Repeat many times to make the brake drum and brake pads evaporate and drain the water by friction to generate heat energy.

The correct approach is to ensure that the vehicle is driving at low speed, and check at any time according to the depth of water accumulation, manual transmission models should try to use 1st gear, stabilize the throttle and pass smoothly, and the automatic transmission should also try to hang into the forced low-speed gear or snow mode, increase the vehicle torque while preventing the tires from slipping, and try to avoid violent driving actions and halfway to kill the car. After the water comes out, it should be braked several times in a row to quickly evaporate the moisture of the brake disc to ensure the braking performance of the vehicle. If the vehicle wades through water during driving and the ignition stalls, you need to stay calm and turn off the ignition immediately, and do not try to start the engine again, because this will cause great damage to the engine and the insurance company will not be claimed; Then remove the negative wire of the battery as soon as possible to avoid a short circuit caused by water ingress on various electrical appliances on the car, and then move the vehicle to a safe place, try to make the vehicle high in front and low in the rear, so that the water entering the exhaust pipe can flow out and avoid damage to the three-way catalytic converter and muffler.

Has your car ever been involved in water?

After the car wades in the water, you should call the insurance company in time for professional self-rescue.

Has your car ever been involved in water?

As the name suggests, vehicle wading refers to the vehicle driving on a low-lying and waterlogged road and passing in the water. It usually occurs in rainy weather, and the lack of drainage equipment leads to waterlogged roads in low-lying areas.

First of all, let's talk about the cleaning of the throttle, the cleaning of the throttle is very important for the car, so what are the benefits of the throttle cleaning? Or what kind of discomfort will it bring to the car after the throttle is dirty? First of all, if the throttle is dirty, the first manifestation is unstable idling, and then if you want to start, if it is too dirty, you need to step on the accelerator to start, which is a manifestation of dirty throttle.

Like usual, if the throttle is dirty, the speed will sometimes be high and sometimes low during our driving, and the power output is very unstable and uncomfortable to drive.

We all know that in the past year or two, there was often a situation similar to the flooding of a car in an underground garage, so how should we repair it after we tow it out for this kind of car soaking accident? If you have insurance, you can report to the insurance company if you have wading insurance, so is this kind of wading insurance as long as the car is covered.

After wading; Slow down or stop to observe; No stopping, no shifting, no throttle; When the car is turned off in water, it must not be started immediately; The moisture in the brake pads should be removed in time. The treatment method after the car wading in the water is as follows:1.

You should slow down or stop to observe, when the car is driving on the road, as long as the water level reaches two-thirds of the bumper or tires, it will be dangerous to wade in the water again. The speed increases the car's actual water depth, causing rain to enter the cab from the cab or chassis. Avoid driving in the opposite direction.

It has been observed that if the water level is high, try to bypass it as much as possible and do not force your way through. 2.Don't stop, don't shift, don't **throttle.

In addition to maintaining a low speed when wading, do not stop, try not to change gears, do not **throttle, and do not accelerate. Low, medium, and high throttles should be passed at a constant speed, but not through large waves or splashes quickly. 3.

If the car stalls in the water, be sure not to start it immediately. Measures should be taken as soon as possible to tow the vehicle to a safe location where there is less standing water. Water ingress into the engine is a very serious problem.

Water can enter from the intake valve through the air filter element and then through the intake pipe into the cylinder block. Do not start the engine at this time, otherwise the crankshaft, connecting rod and other important parts of the engine will be deformed, causing the car engine to shake and the parts will be seriously broken. Stalling in water will most likely result in water ingress into the engine.

After the ignition is turned off, you can only take the empty trailer to the repair shop for cleaning. 4.After wading, it is necessary to drain the water in the brake pads in time, especially the car with drum brakes, otherwise it will lose the brakes after wading, causing serious danger or accidents.

Specific operation: Gently press the accelerator and lightly press the brake when driving at low speed. People who can't dual-purpose can apply the brakes multiple times.

Note: The speed must be slow. Repeatedly, the heat energy generated by the friction between the brake drum and the brake pad evaporates to dissipate the water.