My PSP battery is not aging

It must be a battery issue. However, if you are using raw electricity, the power detection should not be accurate.

It doesn't make any difference if you continue to use it, it's just that you don't know when it's time to charge.

It is recommended to buy raw electricity. PSP has been reduced in price, and the original electricity is not expensive.

As long as the battery has a power storage phenomenon, then more than 86% of your battery has to be used for bricklaying. The battery must be aging, the discharge is not normal, the motherboard cannot be recognized, and the motherboard will be scrapped if you don't replace it quickly!!

Of course, the original, it is recommended to buy the original more insurance, about 100-150 yuan, and the quality life is ***. It is not clear to assemble the battery, the quality is good or bad, and the service life is not to be discussed, and the power of the assembled battery will also be incorrect, and there is still a big difference compared with the original battery.

Well, it should be replaced, and the battery must be aged for four or five years, in fact, I think it is better for you to buy the original electricity than to buy the domestic original electricity, Pinsheng, or something, it's better, 45 yuan, because you buy the original electricity, the first imitation is quite a lot, you know, it's hard to distinguish Second, there is no way to know whether you bought the real thing (can't find it), and like the Pinsheng battery, you can verify the insurance point on the official website, and it is relatively cheap.

The original is good, because this is for your own use, of course, it must be safe! Otherwise, it would be nonsense to play and explode!

It may be recommended to match the original with a piece of magic electricity if necessary.

Normal, my battery has been playing for two years and it has become like this.

The battery is locked?

1. What does it mean that the battery is locked?

PSP has high requirements for the battery used, and if the battery voltage is too high or too low, PSP will not recognize the battery, such as unable to turn on, unable to charge, etc.

And even if the voltage meets the requirements normally, PSP still doesn't recognize this battery. Commonly known as battery locked.

2. Why is it locked?

1) Some of them are locked because of the use of a charger of poor quality, especially a portable base charger, and the battery voltage is too high after charging, and it is locked after being put into the PSP.

2) The battery is left in the PSP that is not used for a long time, which causes the battery to be over-discharged and locked.

3. How to repair a locked battery?

1) For batteries with overcharge resulting in high voltage, a 10 ohm to 15 ohm resistor can be used to connect the positive and negative poles of the battery to discharge.

The normal current of a standard 1800mAh PSP battery is 400 700mA, and the voltage is discharged with a resistance of 10 ohms, and the current is 360mA, which is very safe and will not damage the battery due to high current discharge. The complete discharge time is about 4 hours, and after more than ten minutes of discharge, you can put in the PSP to see if it has been unlocked.

2) For over-discharge caused by locking, put in the PSP can not be charged, you can first charge it with the socket charge, do not need to be full, it is estimated that after charging about 50 charges, stop charging, measure the voltage, should have normal. Take two wires, insert them into the slots of the two poles respectively, and quickly touch the other end of the two wires, that is, short circuit, and generally see a small spark.

Wait for more than ten seconds, put it in the PSP, and you will find that the battery has been unlocked. The short circuit is to force the protection circuit inside the battery to reset and return to the initial state.

When your PSP battery is locked and there is no other option than to throw it away, you may wish to try the above methods to revive the battery.

This brother, it looks like your battery is finished. It is recommended to buy one online.

Is there only one battery flashing when it is turned on, if it is, then you can pick off the battery and put it back on, but you have to re-flash the machine No, you can't turn it on. The light will only turn on when charging with direct charging and the battery signal light is not on, then it is estimated that it is locked often people will take the situation I said above as a power lock =. = Unlock related :

When the 1000 original current is locked, its positive and negative poles have the ability to output current independently, but the PSP cannot be lit, because the signal pin is temporarily closed, and the PSP needs the signal pin to have the correct signal when it is turned on.

When the 2000 original current is locked, its positive and negative poles are in a closed state, and the current cannot be output independently, of course, the PSP cannot be lit at the same time, and the same is the same as 3000. Corresponding unlocking method:

The 1000 original current unlocking method is to completely discharge.

2000 & 3000 Raw Power Unlocking Method:

1. Leave it alone, put it for an afternoon after externally, let it discharge by itself 2, disassemble a simple lighter to take out the electrical appliances, and hit the positive and negative poles of the battery once or twice 3, find copper wires and small bulbs or small motors, and add the PSP battery to make a small circuit discharge battery without marking the positive and negative poles, there are three points, how should I judge the positive and negative? Isn't it a hit on each side = = just hit it over there It's just unlocking and it doesn't have a bad effect on the battery.

Is durability bad? The domestic garbage battery bought online is often broken, and the time used is particularly short, I haven't charged it for six years, I thought it was broken, but it was charged directly, and it was as durable as when I first bought it, and Sony's things are good.

The protection of the battery is good, if you want to short circuit, then directly ** dare not guarantee it. Or be careful.

Maybe it's locked up.

You try the following methods, these methods are recommended by Tieba Lida people, and they should work.

Corresponding unlocking method:

The 1000 original current unlocking method is to completely discharge.

2000 & 3000 Raw Power Unlocking Method:

1. Leave it alone, put it on the outside for an afternoon and let it discharge on its own.

2. Disassemble a simple lighter and take out the electrical discharger, and hit the positive and negative poles of the battery once or twice.

3. Find a hail copper wire and a small bulb or a small motor, and add a PSP battery to make a small circuit discharge.

PS: Finally, I would like to send a few knowledge about the maintenance of PSP batteries.

There is no problem that the first three times of the newly purchased machine should be deeply charged and discharged (the charging light can be turned off), and there is no need to deliberately ensure that it is discharged every time and then charged.

A deep charge and discharge can be done for a period of time to correct the battery level statistics (but this will not increase the actual capacity of the battery).

Batteries that have not been used for a long time.

It should be placed in a cool place to reduce the rate of its internal self-passivation reaction.

The protection circuitry is powerless to monitor the self-discharge of the battery.

The battery that has not been used for a long time should be charged with a fixed amount of power per mu to prevent the battery from self-discharging in storage, which leads to the impermeability damage of over-discharge.