Ask for all the CAD commands.,Don t talk nonsense, the reward of 50 points is all given.。。。

po (point) l (straight line).

XL (ray) PL (polyline).

ML (multiline) SPL (spline).

pol (regular polygon) rec (rectangle).

c (circle) a (arc).

do (ring) el (ellipse).

reg (region) MT (multi-line text).

t (multi-line text) b (block definition).

i (insert block) w (define block file).

div (aliquot) h (fill).

CO (Copy) MI (Mirror).

AR (Array) O (Offset).

ro (rotation) m (movement).

e, del key (delete) x (decompose).

tr (trim) ex (extend).

s (stretch) len (straight line elongation).

sc (scaling) br (interrupt).

CHA (chamfer) F (round).

PE (polyline) ed (modify text).

Let's try it in a variety of ways.

1. Command: sdi, press enter, enter 0

2. In the command line position, right-click "Options", remove the check mark of "Single Document Compatibility Mode" in "Basic Options" in the "System" option, and then click OK.

3. It may be normal to delete the parameters because the parameters are used in the shortcut. [Please refer to the following content of the help file: User Manual - User Interface - Custom Graphical Environment - Custom Startup, check the shortcut and registry to see if this is the reason].

There's a taskbar parameter in the version above.,You can modify it through this parameter.,But unfortunately 04 doesn't.。 Thinking about a different version? Recommend 06 is good. But it's up to you to get used to it.

Give me an email and I'll send it to you.

These simple ones are actually drawn with the straight line command l, but it is possible to open the isometric side view, and when capturing, it is a 30-degree angle snap, open the isometric side view method, and enter it on the command line"ds"command, enter the sketch settings dialog, or right-click on the status bar at the bottom of the CAD screen, click Settings to enter the sketch settings dialog, and then look at the image below.

After turning this on, the crosshairs of the drawing on the screen will become oblique.

Then, when drawing, turn on the orthographic mode, which is 30 degrees, 90 degrees, and 150 degrees. There are also 3 kinds of switching in the isometric side view, press the F5 key to switch back and forth, and it will prompt, "Isometric Plane Left", Isometric Plane On".

Isometric plane right", these are some angles that are not easy to draw when drawing, and they have to be switched back and forth.

It is also possible that the other party is more proficient in drawing and does not open the isometric side view, and draws directly with a 30-degree angle, if I draw such a picture, I will not open it, like the faucet on the picture, household appliances or something, it may be a direct copy of the block, not drawn by him. It takes a long time for the painter to use these electricity, and they are usually used by copying blocks.

Dear, you can change the coordinate system, enter UCS, and then click twice on the diagonal line in your diagram, and the coordinate system will be turned around, (or you can make a diagonal line with a good angle and put it in your diagram, as the reference line of your UCS coordinate system), and you can draw orthogonal parallel straight lines in the current coordinate system.

When you want to draw a vertical line, enter UCS and press enter twice to return to the original horizontal and vertical world coordinate system.

You can switch back and forth between these two coordinate systems.

This kind of 2-and-a-half-dimensional diagram is actually a plane diagram, you only need to capture a 30-degree angle, and you can also convert the coordinate axes.

Click on the menu tool Customize Program Parameters (

The pop-up file is full of software instructions.

What commands, shortcuts, are you talking about? If you don't understand, you can ask me.