Where is the Haval H6 tire pressure reset button, and how to reset the Harvard H6 tire pressure ligh

The Haval H6 does not have a tire pressure reset button, and if the air pressure of the tire is the standard air pressure, it will automatically reset after driving more than 30 kilometers. If it doesn't work, you need to use a special computer to detect.

The tire pressure monitoring device is a system that uses the pressure sensor installed in each tire to directly measure the air pressure of the tire, and uses a wireless transmitter to send the pressure information from the inside of the tire to the system on the receiver module, and then displays the air pressure data of each tire. When the tire pressure is too low or flat, the system will automatically alarm.

The power of the Haval H6.

Haval H6 has always had a feature of the car is that the power is good, but the low torque is very general, including the old one, but this new engine has been strengthened in terms of low speed torque, and it is finally no longer weak compared to itself, and the smoothness at the sensory level is much stronger than that of the model, and it will be more comfortable to deal with the traffic jam in the city.

The 7-speed wet dual-clutch transmission has an improved speed compared to the old model at the beginning of the start, and in the process of rapid acceleration, it can be clearly felt that its shift speed is slower, and there is a neutral gear with unconnected power; And at the level of daily driving, there is no problem, and the logic of upshift and downshift is fine.

Great Wall Haval H6 tire pressure lamp manual reset method: open the key to 2nd gear, press the instrument information switch key on the left side of the steering wheel to switch to the instrument display kilometers interface, press the up button on the left side of the steering wheel, the instrument panel displays rrfi active reactivate: r, press the (r) button on the dashboard, the instrument panel will display + and -, and then press the steering wheel + number button, wait for 10s and then turn off the key.

The tire pressure light can be reset to complete the set.

The dashboard of the Haval Red Label H6 model displays RRFI Active Reactivate: R, (in the case of the Haval Blue Label H6, the instrument panel will display "Tire Low Pressure Continuation Indicator Reactivated"); Press the (R) button on the instrument cluster (black indicator button).

When the tire pressure warning light is on, it means that the current four tire pressure deviations are too large or the air pressure is insufficient, and it is recommended to check it. Haval H6 tire pressure is generally at the right level. Manufacturers will have clear recommendations for the tire pressure value, in addition to the clear instructions in the manual, car owners can also find it on the label of the body.

Tire pressure tabs usually appear at the bottom of the b-pillar when the door is opened, or inside the fuel cap.

Steering wheelThe up button on the left is the reset button.

Haval H6 This car has always had a feature that the power is good, but the low torque is very general, including the old Hui Bang, but this time the new engine has made a certain leakage in the low speed torque, compared to their own search before the talk is finally no longer weak, the comfort of the sensory level is much stronger than the model, and it will be more comfortable to deal with the traffic jam environment in the city.

Tire pressure can be adjusted via the instrument cluster option on the left side of the steering wheel.

Lamp reset. Taking the 2021 Great Wall Haval H6 as an example, its body dimensions are: length 4615mm, width 1860mm, height 1720mm, wheelbase 2680mm, body weight 1675kg.

The 2021 Great Wall Haval H6 front suspension is a MacPherson independent suspension.

The rear suspension is a double wishbone independent suspension, which is equipped with a turbocharged engine with a maximum power of 150ps, a maximum torque of 210Nm, and a maximum power of 110kW, which is mated to a 6-speed manual gearbox.

Haval H6 tire pressure reset method: disconnect the negative pole of the battery for more than one minute and then connect it back; At this time, the interval odometer is zero, the tire pressure of the four wheels does not display a number, only a horizontal line is displayed, and the yellow warning light of the speedometer on the left is no longer flashing. Then Jingyan drove about a kilometer, and the tire pressure value of the four wheels was displayed and returned to the previous normal state.

If the tire pressure monitoring system warning light is illuminated while driving, stay calm, do not panic, immediately reduce your speed and avoid fast steering wheel and hard braking, and check your tires immediately. If you have a simple inflation device or tire pressure gauge, you can drive to the side of the road, test and inflate each tire. If you don't have one, you can drive slowly and find the nearest server or car repair shop or 4S shop.

When the tire pressure is adjusted to the normal state, the tire pressure light can be reset, in addition to using a special decoder to clear the fault code to achieve the tire pressure light reset, for those models with the tire pressure reset button, we can also operate manually in the case of tire pressure collapse. The operation method is: turn on the start ignition switch, press and hold the tire pressure monitoring reset button, and let go after hearing a knock, then the tire pressure monitoring system will store the normal tire pressure data at this time, and then automatically clear the original data, and finally the fault light of the dashboard goes out.

This method is only available on certain models, as described in the vehicle's owner's manual.

The ignition switch is turned to the second gear, and the instrument presents the following interface (total mileage and mileage interface); Press the "OK" button on the left side of the steering wheel, and then press the right button to the "Maintenance" interface; Press the steering wheel down arrow button to the "Tire Pressure" interface (underlined); The instrument prompts "Low Pressure Continuation Indicator Enabled", press the steering wheel "OK" button to confirm; The instrument prompts "whether the tire pressure is normal", select "Yes" from the steering wheel down button and press "OK" to confirm; After completing the tire pressure reset operation, the tire pressure reset is successful after the engine is turned off and restarted.

The tire pressure monitor is a real-time automatic monitoring and detection of the "change" of tire pressure during the driving of the car, and prompts the owner of the tire to leak, low air pressure or the increase in air pressure due to the increase in ambient temperature.

The Haval H6 can display tire pressure monitoring through the multi-function button on the steering wheel, and the tire pressure can be checked through the function button on the steering wheel (turning the page up and down on the left side of the steering wheel).

Haval H6 tire pressure monitoring can be viewed on the dashboard. The tire pressure monitoring system equipped with the vehicle automatically alarms and prompts, without manual operation. When the tire pressure light is on and needs to be reset, if the tire pressure sensor is not changed, the tire pressure light will automatically go off after a certain distance, and if the tire pressure sensor is changed, it will be matched by a special computer in the 4S store.

In general, the tire pressure light is correct, but the alarm after a bump is not relevant in many cases. It is recommended to pay more attention in the future, it is more dangerous to run at high speed with injuries.

Here's how: turn off the key. Do not pull out the key.

Then press off and on together to turn on until the power is on! The car beeped. You get out of the car and see if the turn light on the left is on.

Then grab your barometer and follow the turn lights to deflect that tire! During the deflation, I heard a horn, and the turning light jumped to the right to put 4 tires in turn. When you finish doing it, the air pressure light goes out.

Then refill the air according to the system pressure value.

Haval H6 tire pressure monitoring light and tire pressure alarm elimination method:

Press the instrument information switch button on the left side of the steering wheel to switch to the meter display kilometers interface. Press the up button on the left side of the steering wheel. Press the R button on the dashboard, and the dashboard will display addition and subtraction.

Press the plus button on the steering wheel, wait for 10s, and then turn off the key, Haval H6 tire pressure monitoring light and tire pressure alarm can be eliminated.

Model introduction:

On August 25, 2011, the Haval H6, which is positioned as an urban intelligent SUV, was grandly launched in Great Wall Motor's Tianjin Xingongsheng Filial Piety Factory, providing Mitsubishi gasoline-powered models and green diesel models, which are divided into three versions: urban, elite and noble.

At the 2017 Shanghai Auto Show, the new generation of Haval H6 was officially launched, and the new car was launched with a total of six models with two powertrains. The design style of the new car is basically the same as that of the current model, and the biggest change is the increase in the dual-clutch powertrain.

On December 12, 2019, the new Haval H6GT version was officially released on the market, equipped with a powertrain, only 100 kilometers of acceleration, and the exterior and interior are designed with sports suits, which is sporty and cool, and lives up to the name of GT.

In August 2022, at the 25th Chengdu International Automobile Exhibition, the Haval H6 super hybrid DHT was unveiled at the exhibition.

The process of repositioning the Haval H6 tire pressure light is as follows: DU

1. First of all, park the Haval zhih6 car in the garage or in the safety area to avoid danger. Genus.

2. Start the Haval H6 vehicle, the central control screen will light up, and click the selected button in the red box.

3. Find the red box selected "tire" on the central control screen and click to enter.

4. Click the "set" button selected in the red box to enter the next setting.

5. Click the "OK" button selected in the red box to enter the next step of settings.

6. Wait for the "tire pressure monitoring initialization" to be completed, and then the tire pressure fault light can be eliminated.

1. First of all, open the main display screen of the Great Wall Harvard H6 car, and click the settings icon in the lower right corner.

2. Next, click on the tire pressure initialization option on the display screen of the Great Wall Harvard H6 car.

3. Then you can see that the Great Wall Harvard H6 car display screen shows that the tire pressure is initializing.

4. Wait until the tire pressure initialization of the Great Wall Harvard H6 car is completed, and then select OK.

5. Finally, the Great Wall Harvard H6 car tire pressure lamp was reset.

1.Disconnect the negative pole of the battery for more than one minute

Pick it up again; This time interval odometer is zero, and the tire pressure of the four wheels of the dao is not displayed only digitally.

In the state of showing a horizontal line, the yellow warning light of the speedometer on the left no longer flashes.

2.Then after about a kilometer, the tire pressure value of the four wheels is displayed and returns to the previous normal state.

As an urban SUV, Haval H6 subverts the off-road flavor of the previous model in appearance, Guo Feng's marriage, dating and blind date, Haval H6's heavy style, and adopts a new design that can win the recognition of mass consumers. The straight roofline ensures headroom in the car.

The Haval H6 has a good performance in terms of convenient space. Of course, in addition to the passenger space, the Haval H6 also provides ample cargo space, with a trunk volume of 808L, and a maximum of 2010L of expansion space when the rear seats are turned to the front.

The Haval H6 does not have a tire pressure reset button. If the tire pressure is standard, it will automatically reset after more than 30 kilometers. If it doesn't work, it needs to be detected by a dedicated computer.

The tire pressure monitoring device is a system that directly measures the tire pressure by using the pressure sensor installed on each tire, and sends the pressure information inside the tire to the ** receiver module by using a wireless transmitter, and then displays the tire pressure data. When the tire pressure is too low or flat, the system will automatically alarm.

As an urban SUV, the Haval H6 subverts the style of the previous model with a strong off-road atmosphere, Guo Feng's marriage and dating Haval H6 weight, and adopts a new design that can win the approval of mass consumers. The overall design atmosphere is relatively calm, but there are also some fashion elements. The straight roofline ensures headroom in the car.

The Haval H6 performs well in the air. Of course, in addition to taking an empty room, the Haval H6 also has a lot of empty rooms for bulk loading.

If the TPMS warning light is on while driving, stay calm, don't panic, reduce your speed immediately, avoid hitting the steering wheel and braking hard, and check your tires immediately. If you have your own simple inflator or tire pressure gauge, you can drive to the side of the road to measure the pressure of each tire and inflate. If not, you can open it slowly and find the nearest server or auto repair shop or 4S shop.

When the tire pressure is adjusted to the normal state, the tire pressure light can be reset. In addition to using a special decoder to clear the fault code and reset the tire pressure light, for those vehicles with a tire pressure reset button, we can also manually operate the tire pressure light when the tire pressure is normal.

Millions of car purchase subsidies.