Is Tao Zhilian brand tiles good, how about Tao Zhilian tiles, how to distinguish between good and ba

When choosing floor tiles, it is important to consider the following aspects: First, it depends on the brand. Only well-known brands of floor tiles, the quality of their building materials can meet the national standards, and the content of harmful substances can be within a safe range.

Second, it depends on its anti-pollution ability, if the family is very busy and can only clean once in two or three days, then choose the one with better anti-pollution ability. Third, if there are elderly people and children at home, you must do a slip resistance test when purchasing.

Specifically, the selection of floor tiles can start from the following aspects:

1.To see if the color of the tile is pure. Mainly observe whether the color of the back of the tile is uniform and consistent.

2.It is necessary to observe whether the particles of the cross-section of the tile are fine. The cross-section here does not refer to the cutting surface around the tile, but to the fracture of the tile fragment.

Generally speaking, the fracture is fine, hard and brittle, and the color is the same. Because the ceramic tiles with fine particles have strong waterproof ability, while the tiles with large particles are easy to soak in moisture, which affects the quality.

3.Pay attention to the thickness of the glaze layer. The thickness of the glaze layer is the thickness of the cross-section of the glaze. Glaze is the most expensive material in the cost of ceramic tiles, and the thicker the glaze, the better the quality.

4.To listen. Tap the tile to pay attention to whether the sound is crisp, such as the sound is clear and pleasant, such as the sound is dull, it is inferior.

5.Test the waters. Consumers can pour some water on the back of the tile and pay attention to how quickly the tile absorbs water. After a few minutes, see if the marks left by the water on the front are obvious. The density of tiles that infiltrate slowly after the water disperses is large, and the marks left by the water are not obvious, so they are regarded as the top grade.

6.Warp. Take two bricks back to back and face to face to see if they can be in close contact, and there is no phenomenon that the gap is too large to judge whether there is warping.

7.Infiltration. Find ink to apply to the surface for 1 hour and then scrub to see if there are traces, no traces are good bricks, and those that have infiltration are resolutely not selected.

How to choose tiles.

First, look at the appearance. The color of the tile should be uniform, the surface finish and flatness should be good, the surrounding rules should be regular, the pattern is complete, and four or five pieces should be extracted from a box to see if there are defects such as color difference, deformation, lack of edges and corners.

2. Listen to the sound. Tap with a hard object, the crisper the sound, the higher the degree of porcelainization, and the better the quality. You can also use the thumb, index finger and middle finger of the left hand to clip the corner of the tile, hang down easily, and tap the middle and lower part of the tile with the index finger of the right hand.

3. Drip test. You can drop water on the back of the tile to see how fast the water soaks after it spreads, generally speaking, the slower the water absorption, the greater the density of the tile; On the contrary, the faster the water absorption, the sparse density, and its intrinsic quality is superior.

Fourth, the measurement. The higher the accuracy of the side length of the tile, the better the effect after paving, and buying high-quality tiles is not only easy to construct, but also can save man-hours and accessories. Use a tape measure to measure whether there is a difference in the size of each tile, and the high accuracy is the top grade.

None, observe its hardness, ceramic tiles with good hardness, strong toughness, not easy to break and rot as the top quality. The edges and corners of the tile fragments are scratched on each other, and the broken fragments are inspected to see whether the broken parts are fine or loose, whether they are hard, brittle or soft, whether they leave scratches, or scattered powder.