How can Wuling Light burn engine oil when it starts in the morning

The engine oil itself has a certain amount of consumption, and excessive consumption is the problem of burning engine oil. Burning engine oil is caused by the following factors, as long as the following problems are solved, burning engine oil can be solved.

There are many factors that affect the burning of engine oil, such as: fuel quality, driving conditions, driving habits, maintenance habits, etc., the above reasons will aggravate the oil consumption and lead to the burning of engine oil, making the vehicle appear:

1. Carbon deposition occurs in the combustion chamber, which makes the gas ring of the piston ring stuck, and the sealing is poor.

2. Oil sludge is generated in the lubrication system, and the oil sludge blocks the oil return hole of the oil ring and weakens the oil scraping performance.

3. Wear occurs between the piston and the cylinder wall.

4. The valve seal is corroded and aging, and the sealing performance fails.

In addition, cars now have crankcase ventilation systems (exhaust valves), which can also exacerbate oil consumption if there is a problem. In the past, the problem of burning engine oil could only be solved by dismantling and repairing, but now there is no.

The solution to the problem of dismantling and repairing engine oil can be learned about.

If it is caused by engine oil, it is recommended to use a good car oil, and it is recommended to use a fully synthetic SN level of dark horse king car oil.

Taocai has more than 200 barrels of 4L, which is very cost-effective and effectively solves the problem of carbon deposition and burning engine oil!

Your car burns oil, go for maintenance.

Burn the engine oil, the engine can be overhauled, there is no need to change the engine assembly. Repair shops and 4S shops are available.

It is necessary to analyze the specific situation on a case-by-case basis! If the car is very old, the gap between the cylinder liner and the piston is large, the seal is not good, it is difficult to repair, resulting in oil burning, and the cost is high, it is cost-effective to replace the new engine! If the age of the car is not long, the burning of engine oil is not serious, the maintenance is easy, and the cost is not high, then the maintenance is more appropriate!

Just change the overhaul kit, and it may not take long to repair it.

It is recommended to check whether the spark plug of the car needs to be replaced and whether the throttle valve needs to be cleaned.

What should I do if I suddenly can't refuel?

1. Check the oil pump of the oil tank to see if it is working normally, the motor of the oil pump will make a sound, if the oil pump can not supply oil normally, it will lead to insufficient power of the vehicle.

2. Check whether the gasoline filter is working well, whether there is oil leakage or blockage, if the oil leakage is more serious, as long as the vehicle is started, it may ignite the vehicle due to static electricity.

3. Check whether the air inlet pipe is blocked by dirt, disassemble the air filter to see if there is water, and replace the air filter if necessary.

4. Check whether the gas distribution phase is correct, whether the intake and exhaust pipes are tightly sealed, and the throttle can be cleaned, or a clean fuel treasure (fuel additive) can be added to the fuel to achieve a certain carbon deposition effect.

Hello! In general, if the engine cannot be started, it may be caused by inaccurate engine timing, control module failure, engine water temperature sensor failure, and problems with the starter or battery, in addition to whether the fuel pump is damaged and whether the fuel filter is blocked, it will also cause difficulty in starting, so there are many reasons why the engine cannot start, in order to avoid affecting the use, it is recommended that you contact the after-sales service for specific inspection.

If you feel that the oil does not respond when you just ignite, it is most likely caused by the dirty fuel injector, you can go to the repair shop and ask him to help us clean the fuel injector, which will generally improve; If Wuling Light has just started, it can't be added oil and there is shaking, it should be a manifestation of insufficient oil supply and carbon deposits, and it is recommended to clean the throttle and fuel injector.

Hello, Wuling Light has electricity and no oil, first check whether the fuel is sufficient, at the same time check the gasoline filter, and finally check whether the fuel pump is working.

If it is determined that it is a problem with the oil, check whether the gasoline pump is normal and whether the fuel injector is normal.

It may be that the frequency of your Wuling Light is relatively high, it may be a little malfunction or the fuel injector is dirty, etc., it is also possible, that is to say, it is possible that the atomization of the fuel injector is not good, and it may be time to clean it.

It should be that your oil pipe is blocked or the oil pump does not work will cause the oil to not come, you can check whether there is oil in the oil pipe, and if there is oil, it is the problem of the oil pump.

Wuling light engine ignition does not come to oil, it is recommended to check the oil circuit system to see if there is a problem with a component in the oil circuit system.

The light of the engine does not come to the oil, which means that the engine may be faulty, so you had better go to the 4S shop or some repair shop to test some problems with the lighter.

Wuling Light can't catch fire, you can follow the steps below: 1. Check the battery, it may be that the battery is out of power.

Check the battery oil pump oil pipe to see if it is not working.

The key to this depends on the type of oil you choose, different oil types have different replacement intervals, and there are currently 3 types of oil on the market.

They are fully synthetic, semi-synthetic, and mineral machine noisy without oil.

The interval for a fully synthetic oil change is 10,000 km or 1 year.

The semi-synthetic oil change cycle is 7500 km or half a year.

The cycle for changing mineral rubber oil is 5000 km or 3 months.

It depends on the road conditions in the area where the vehicle is used, if the road conditions and congestion are built, it is recommended to replace it 1000 kilometers or 1 month in advance.