The automatic transmission car can t catch fire, the brakes are hard, and you can t step on it?

If there is no fire, of course the brakes can't be stepped on, there is no electricity, let alone brakes, and the steering wheel can't turn. There are many reasons why you can't catch fire, and I'll talk about a few common situations where you can't catch fire. 1. The most common situation is that the battery is dead, which happens suddenly, and even many car owners encounter this situation on the road, causing the car to break down.

This may be due to the battery life being up, or the battery may be running out of power (for example, the lights forgot to turn off, turned on overnight, or left it on for a week, etc.). If the battery life is up, just replace the battery with a new one. If the battery is out of power, you need to find someone to pick up the electricity and ignite, and then let the car idle for more than ten minutes to let the battery be charged.

2. Of course, it is also possible that the battery in your key is dead, maybe your car is a keyless start system, and there are batteries in the key, if the battery is finished, there will be a situation that the car cannot sense the key, so it will also occur that it cannot ignite.

1.The steering wheel is locked. If the steering wheel is turned on after the car is parked, the steering wheel will lock. This is the anti-theft feature of the car. Solution: Ignition with the steering wheel running.

The battery is dead. The phenomenon is that the engine squeaks when it is a little hot. Solution: Replace the battery or find a car to take the battery.

3.Failure of the engine itself. If this is the case, you can only go to a 4S shop or a professional auto repair shop to do a good test first to determine where the problem is and fix the symptoms.

If you can't catch fire, the battery is out of power or the spark plug is going to be replaced, and the brake can't be stepped on, you need to go to the 4S store to see, it is recommended to go to the 4S store to see.

A car with an engine. Motor. If you can't point it, you can't step on it without vacuum brakes. You fix the car and the brakes are naturally good.

Hello! The ignition is not reacted at all or there is a sound of starting, but it cannot be started, which needs to be divided into two situations.

No response, sound: It means that the battery is not charged, or the ignition switch is faulty.

The starter is working: it means that the battery and starter are normal, then it is the problem of ignition, fuel injection, and air intake failure.

If the key does not move, the steering wheel is locked, and you need to turn the steering wheel for ignition.

Hope it helps!

If you can't deal with such a problem by yourself, then go to the car repair department, if you can't deal with it, then go to the car repair department to see such a problem, if you can't deal with it yourself, then go to the car repair office to see. Let the sh there and the repairman there take care of it for you, or let the repairman there take care of it for you, or help you.

It may be hard at first, and then look at the battery.

The trolleys are hydraulic with vacuum-assisted brakes, which rely on the intake pipe to suction to produce a vacuum and increase the braking force. Once the engine starts, a vacuum is naturally created, and even if it's a little loosely sealed, it's not a big problem. But to check.

When the door is opened, see whether the engine will run with it, and the operation is a weak start, which may be a problem with the battery or starter. If the engine does not move when the key door is screwed, it is necessary to check the starter relay, solenoid switch circuit, and main circuit.

with the car. As far as your current problem is concerned, then try to press the brake pedal heavily, if you still can't hit the car, then the fault has nothing to do with the brakes, please see if the gear is in the parking gear, that is, the P gear, some cars are in the N gear, that is, the neutral gear can also be cared, it will be judged that emergency braking is needed, so it will automatically pressurize the braking system to enhance and produce the most powerful braking force, so that the vehicle and the driver and passengers can quickly get out of danger, at this time the brakes will become very hard, and it has been handed over to the system to deal with.

The first time to hit the direction to dodge the second rear-end Audi A4 the other car cost 4600 I have to 7100 4S said that it is ABS start I think this start is too frequent There is a sudden braking will be like this But driving There are accidents must be sudden braking, some vehicles are also equipped with electronic booster pumps on the mechanical vacuum booster to prevent the real air from reaching a sufficient amount when braking frequently, and use the electronic booster pump to provide vacuum assistance. The phenomenon you are talking about should be checked by a professional maintenance personnel, after all.

Low speed should be used, and the use of braking should be minimized as much as possible (in off-road areas of modern passenger cars, low-speed cruising based on the ESP function has begun to solve this problem). You can also take two feet of throttle to increase the vacuum of the booster in the middle to solve this problem. Good.

Method three. Press the brake pedal while the engine is running, then turn off the engine and keep the pedal in the depressed position, after about 30 seconds, if there is no change in the pedal height, it is well sealed. If the pedal has a pick-up phenomenon, it is an indication that the vacuum booster is faulty.

It is most likely because the car's braking system is faulty, so the brakes are hard and do not catch fire.

First of all, you need to check whether this phenomenon is caused by the loss of battery power? If the battery is out of power, you need to charge the battery or replace it with a new one.

In the case of making sure that the battery does not lose power, focus on checking whether there is a problem with the vehicle starter or whether the anti-theft is locked? If there is a problem with the starter, you need to check the corresponding control circuit of the starter or replace the starter. If there is a problem with the anti-theft system, you need to re-do the anti-theft matching.

The second major aspect is that the vehicle engine can rotate, but does not catch fire, so in this case, it is important to check, is the gasoline pump oil pressure insufficient? Or the vehicle engine does not ignite, if the pump oil pressure is insufficient, this situation requires the gasoline pump to be replaced. Check the fuse or wiring of the gasoline pump.

If ignition is not required, focus on checking the crankshaft position, sensor and ignition coil.

Question: The car doesn't catch fire.

Ask how to determine if the battery is losing power?

Question: I can open it when I was on fire yesterday, but I feel a little weak and powerless, and I can only open it after a few turns.

Is this feeling of running out of power?

Question: Before this, my engine failure light was on yellow for a while, and occasionally the automatic start-stop light and the triangular exclamation mark light in the lower right corner were also on.

This may be caused by the engine not working, or there may be damage to some parts of the brake that need to be checked.

This is probably because your engine is affected, which is why this happens, either because there is no oil or because the electrical circuit is affected, ask your local repair staff.

This situation may be that there is an air leak in the vehicle's brake vacuum booster pump or a component failure, resulting in the brake pedal can not be pressed, because the brake system of the car is a hydraulic system, to ensure that the brake pads are tightly pressed on the brake disc, it is difficult to step on the brakes alone, and it is difficult to step on the brakes alone, and it is necessary to rely on the vacuum booster system.

Your handbrake doesn't go down, and that's the reason, because if the handbrake doesn't put down the car, it's in a braking state so it doesn't catch fire.

Failure to catch fire is naturally the reason why you can't step on the brakes. As for the reasons why it can't catch fire, the main ones are:

1. Hang the wrong gear. When the automatic transmission car starts, the gear must be placed on the P or N gear, if it is placed on the R or D gear, it will not ignite. There are also some manual transmission cars that will not catch fire if you don't step on the clutch.

2. See if there is oil. I used to go to rescue a car with a friend, but the fuel gauge showed that it was below the red line, so naturally it couldn't catch fire. At the same time, pay attention to the quality of the oil.

When we used to repair the car, we found that there was water and mud in the fuel tank after disassembling it, and with such oil, it was impossible for the car not to break. Therefore, remind the owner to be sure to go to the regular gas station to refuel, and you can bring a gauze wrapped in the muzzle of the refueling gun to filter impurities.

3. No antifreeze is added. Some car owners add water or inferior antifreeze to the car, resulting in a particularly cold winter, causing the entire waterway to be frozen, the engine to be frozen and cracked, resulting in the car water pump can not operate, can not catch fire, and injure other parts of the engine.

4. Check whether the battery has electricity. It may be due to the loss of power or the expiration of the battery life due to the long-term headlights have not been turned off, and it is generally recommended to replace the battery in time after 2 years. In addition, the installation of xenon headlights, high-power audio, etc. are also the causes of vehicle circuit failures.

Hello, check if there is a problem with the key and can't be sensed, and repair it if there is a problem! [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

1. The car has no oil, basic common sense, no oil must not catch fire;

2. Battery failure, if the car battery is out of power or malfunctioning, it will naturally not be able to ignite;

3. The spark plug is a key component of the automobile lighter system, so the spark plug cannot work normally, which is related to the performance and efficiency of the car;

4. Too much carbon deposit, too much carbon accumulation in the vehicle will also cause the vehicle to not catch fire, and you need to go to the 4S store regularly to clean up the carbon deposit.

Check it out by name at 1234.

If the car doesn't catch fire, it means the engine won't start, so it brakes.

The pedal can't be pressed. This is a logical relationship between the before and after. Therefore, the car could not hit.

Fire, not because the brake system is faulty.

The solution to the problem that the automatic transmission can't start and the brake can't be stepped on:

1. For models with one-button start, you need to step on the brake when the gear is in P gear.

The car can be started, which ensures that the vehicle will not move when it starts. But there are no on the net.

Few people reported that they had encountered the phenomenon that the brakes could not be stepped on and could not be started, and they suspected that it was.

**There is a breakdown, and some people are worried about whether there will be brake failure when driving.

down the situation;

2. In fact, the reason why the brake cannot be stepped on is likely to be unable to start.

Hit the brakes a few more times after the last time the engine was turned off. Nowadays most of the cars are mined.

The vacuum booster pump is used to assist the brakes, so that we do not need to use the brakes when we apply the brakes.

With a lot of force;

3. Therefore, when the engine is turned off, step on the brakes several times to make the booster pump.

The only vacuum left is gone, so brake the pedal the next time you start.

It will be very hard and you can't step on it;

4. At this time, you should press the brake pedal with more force, and then press the ignition switch.

I was able to start the engine. The brakes are noticeably felt after the engine starts.

The pedals are sinking, and this is because the engine intake pipe has formed a vacuum, vacuum.

Booster pumps are also starting to help.

See if the vehicle is back in neutral, if it is normal, then it will be driven to the 4S shop, or the repair shop for maintenance.

Use a computer to check if there is a fault code? It may be that the ignition switch is broken.