When decorating, is it necessary to install a pre filter in the water pipe?

The pre-filter is something that you regret when you install it, because it's so easy to use, I regret not installing it earlier! The pre-filter mainly filters sediment, rust, insect eggs and other large particles, purifying the water quality of your home is a very useful home artifact!

Pre-purified water should be the standard configuration of every household, but it is actually a simple filter. This thing doesn't require electricity like other appliances, as long as it is installed, it can work. Its mission is to filter out the impurities of the tap water as large particles, and the filter element is replaced with more sticky things, so you can just put water to flush it.

Loaded with this thing. In addition to relatively improving the quality of water supply, for all water pipes, valves, faucets, shower water heaters and so on. will be a beneficiary of longer service life and reduce the risk of waterway failure.

To choose a backflush filter with a strainer scraper, when it is necessary to clean up the filtered impurities, adjust the reversing valve to achieve a reversal of the water flow. At the same time, the scraper cleans the filter screen, which is convenient without dismantling. The filtration accuracy should be between 40 and 80 microns, too low to block the water flow will cause blockage, too high can not play the role of filtration.

The filter is made of 316 stainless steel, which can reach 8,9 years.

The bottle body is made of metal, which can adapt to the environment between minus 20 degrees and 80 degrees, don't choose engineering plastics! It can only be adapted to an environment of five to forty degrees. Whether it's 4 minutes or 6 points, remember to choose 1.5 to 3 tons per hour for the flow rate.

Finally, it is emphasized that there are less than 100 yuan but the quality is poor, higher than 1,000 yuan, and the cost performance is not high. Basically, five or six hundred yuan is fine.

So how should such a good thing be installed, and should it be installed in **? There was once a landlord who inquired that the property did not allow him to install the front in the total location of the entire unit ....... In fact, the pre-installation sequence should be the main valve in the water meter room, and then the pre-filter.

In order to ensure that the length of the elbows on both sides of the water pressure front can not be less than 30 cm. So sometimes the water pressure becomes smaller after installation, not necessarily a pre-installation problem, it may be a problem with your installation. The water meter is not indoors, and it is generally installed under the kitchen sink is the best, and the total water entering the house is generally in the kitchen, and those who are not in the kitchen should also be led to the kitchen!

Installing a pre-filter at home is cheap, durable and worry-free! Is it installed in your home?

Many people install a pre-filter on the faucet when using water at home, thinking that after filtering the tap water twice, they can ensure that the water they drink is cleaner. But should a pre-filter be installed for household water? Don't install blindly without figuring out what the filter is for, what are the advantages and disadvantages of installing a pre-filter?

1. Should a pre-filter be installed for household water?

Many people don't know that the small pre-filter is actually very useful. It is the first simple filtration equipment for water purification in the whole house, and the main filter body is a metal filter with an accuracy of about 50 microns. You can first filter out large particles of impurities such as rust, sediment, and floating objects in the water pipes at home.

Although the water filtered by the pre-filter cannot be used directly, it also needs to be further purified and disinfected by a water purifier. However, after installing a pre-filter at home, a large number of visible impurities are removed and the water purifier can also be protected. Avoid impurities from directly entering the water purifier, causing the filter element to be blocked, reducing the water output, and its service life can also be extended.

Because a large number of impurities wear a lot of damage to the filter element, the filter element needs to be replaced frequently. Now the water purifier filter element is very expensive, one is hundreds, and it is too expensive to replace it frequently! Therefore, its biggest role is to reduce the loss of other water purification equipment in the whole system.

In addition, unlike the filter element, which is discarded after half a year or a year, the pre-filter can be dismantled and washed regularly, and then reused, it is generally no problem to use it for ten or twenty years. Some pre-filters even have an automatic flushing function, so you don't have to manually disassemble and wash them, they rinse them regularly. It can also solve the problem of excessive water pressure of the water purifier, and avoid impacting the water purifier filter element when the water pressure rises sharply.

In addition, the pre-filter can also protect the water safety of other household appliances, such as high-end faucets, washing machines, water heaters, toilets, etc.

Of course, not every family must install, if it is a new residential real estate, not an old pipe, if the water quality is good, you can choose whether to install it according to your own situation. However, it is recommended that for the sake of our health and the life of household appliances, we can choose a mid-range installation at home, and there is no other follow-up use cost, and the cost performance is relatively high.

Second, what are the advantages and disadvantages of installing a pre-filter?

Pros as above, disadvantages of pre-filter:

The first point is that the pre-filter is basically discharged with wastewater, so you must know this problem when installing, and reserve the pipeline for draining wastewater in advance, otherwise it will not be able to be used in the later stage; The second point is that because the pre-filter adopts the filter filter method, this filtration method is installed at the water inlet end of the home, which will have a certain impact on the water pressure at home.

Should I install a pre-filter for household water? If you feel that it is necessary to install the pre-filter, you can install it, after seeing what are the advantages and disadvantages of installing the pre-filter, it also gives you a clearer answer to whether to install the pre-filter, everything according to your daily life needs.

Of course it is necessary to install it. The pre-filter is the first step in filtering the water, allowing us to use a healthier water source.

It is necessary because the tap water will be directly connected to the water heater and water purifier, and if it is not installed, these equipment will quickly produce scale, and the number of cleaning will increase, which is very inconvenient.

It is necessary to install this device to help us better filter drinking water, prevent some debris from entering, and also protect the next level of water purification equipment in the home.

Is it necessary to install a pre-filter in the water pipe? It's still a professional who analyzes it reliably, don't make a mistake.

If the front water purifier really has no effect, then there is no need to exist in the first place. So, why is there a front water purifier? The origin is because the filter of the water dispenser is often clogged, the filter is replaced early, and the replacement cost increases.

The pre-mounted water purifier helps to filter large particulate matter, which can reduce the amount of these substances entering the water purifier's filter, reduce clogging, and also reduce the failure rate of other equipment of the appliance. The front water purifier is useless, will it be used **? Don't be foolish enough to be deceived by real estate and uncover the essence of the truth.

Don't underestimate the water purifier in front, the purification effect is average. However, it can only intercept large particulate matter, but its main role is not to purify water, but to protect other water purification equipment. Then we will know what it does and what it means.

It cannot be considered that the purification effect of the pre-water purifier is average. No installation is required. In areas with poor water quality, the front water purifier is particularly important.

It can protect other water purification equipment and ensure normal operation and life. So, if you think that a total water purifier is just a gimmick and a tool to make money.

You may not know anything about a total water purifier or how useful it is to install a total water purifier in an area with high water pollution. After all, only those who have a deep understanding can understand this. For some communities, if part of the comprehensive water purifier is installed near the water meter, it will occupy public resources and increase the cost of real estate management, so the real estate will oppose the installation.

In addition, some pre-water purifiers are not installed correctly, and when there is a problem with the connecting pipe, it will leak and affect the water consumption of other users.

But the front water purifier will**, this doesn't seem to be. If there is such a danger, a total water purifier will not be installed in the kitchen. Some of the statements were grossly unrealistic.

The installation of the front water purifier is simple. Filters, filters, copper heads, water pipe connections, tap water filtration, water pipes** are not hazardous. In order not to occupy resources in public places, the front water purifier is set at the kitchen water inlet, which is simple to install and does not take up space, so you can easily clean the filter in the front water purifier!

This is true, because the filter is useless, and the water is still tap water, and there has been some change in principle, so it has no effect.

Of course, it is useful, but because this filter is so small, it takes a few days to replace the filter element, so the effect is still very small.

Not really, the pre-filter still has a role to play, filtering out sediment and rust and other particulate stuff from the tap water.

Not really, such a statement is very incorrect, I feel that the filter is very useful to filter out some of the residue.

Now that the living conditions are getting better and better, many friends will consider installing water purification equipment for new house decoration. Generally, the installation of a water purifier at the rear end will be considered, so do you need to install a filter at the front end? Let's answer it for you:

The role of the pre-filter: The pre-filter is the first threshold of healthy drinking water in the home, which filters out large particles of 100 microns in size, including sediment, rust, scale and other large particles, which has many benefits.

1.Solve the contamination of pipelines.

At present, the tap water pipes in many areas are relatively old, especially in the old city is very serious, and there are many decay impurities in the tap water pipes, so it is very necessary to install a pre-filter to ensure the original quality of tap water.

2.Inhibits scale, prevents rust, and softens water quality.

We all know that scale will cause damage to water appliances at home, such as water heaters, water boilers, etc., and installing a pre-filter can solve this problem well and protect these appliances.

3.It works best when installed in homes.

The installation of the pre-filter needs to reserve a good space in the decoration, and it is generally installed between the main water pipe and the water meter in the home, and the effect is the best. In addition, the pre-filter needs to be cleaned regularly to ensure that the water quality is clean.

4.Protect the rear water purifier.

Generally, the water purifier used in our family is made of PP cotton, which needs to be replaced once every six months. If the water quality is poor, it may need to be replaced within 3 months. After installing the pre-filter, the service life of the water purifier filter element can be at least doubled.

As the saying goes, illness comes from the mouth, and in home decoration, it is particularly important to ensure the cleanliness of water. In the decoration, everyone should try to install a pre-filter to take care of the health of the family.

Popularize the knowledge of installing a pre-filter, if your new house is in the renovation stage, you can consider installing one.

Designers popularize the knowledge of installing pre-filters 1. What is a pre-filter?

The pre-filter is the first coarse filtration water purification equipment for the whole house water, which mainly filters out large particles, rust and moss harmful to the human body from the front end, and needs to be installed at the front end of the main water valve when the new house is decorated, and the filtration is its main water purification equipment.

2. What are the advantages of installing a pre-filter?

Solve the secondary pollution of pipelines:

Tap water can meet the standard of direct drinking, but due to the obsolescence and length of the pipeline, the tap water will also be polluted, resulting in a large amount of rust, sediment and moss and other pollutants that can be seen by the naked eye.

Softens water quality, prevents scale, prevents rust

Scale is mainly composed of calcium and magnesium, but now many families use gas water heaters are more common, but if the scale enters the gas water heater, it will have a certain corrosive effect on electrical appliances, so the pre-filter also plays a role in softening water quality and preventing a large amount of scale.

Can be used as a pre-processor for water purifiers:

The commonly used preprocessor of water purifier has a filtration accuracy of 1-50 microns, which is to prolong the service life of the filter element, but if the pre-filter is installed in advance before decoration, such a pain point will be solved.

3. What should I pay attention to when purchasing a pre-filter?

The pressure should be high

It is necessary to choose a pre-filter with high water pressure or to ensure that the water pressure is stable, so that there will be no damage to the water equipment at home, so the selection of a high-quality pre-filter depends on the pressure capacity.

Technologically advanced

Choosing a technologically advanced pre-filter can solve a big problem, and the market is divided into two kinds of direct flushing and backflushing from the technical point of view, the technology will be more advanced compared to the backflush, you can use the filtered water on the upper layer for backwashing, and at the same time carry out 360 degree automatic rotation, so that all angles of the filter screen can be flushed.

The material should be fine

The material Xingzhi recommends choosing stainless steel, because the pre-filtration is in contact with water, and if the material is easy to rust, it will directly shorten the service life.