The webpage can t be opened, and it prompts that the local is restricted or there is no connection

It doesn't matter.

If you want to get rid of the restrictions, just fix the IP in the local connection, for example.

Fix the IP address of the NIC in the attribute configuration of the NIC.

There are things that don't work.

If you are connected to Mondem, this is mainly because your network card does not get a valid IP address from the modem, which will not affect the broadband connection, as long as you set an IP according to the modem. Connect the route to see if all computers are like this, if it is a routing problem, check the connection line if it is one, especially the crystal head.

Try to set the IP address of the local connection, and then ping the route, if it is not through, that is, there is no prompt such as time out, which means that there is no problem with the network, and you should connect to the network normally after setting the IP.

If it does not work, it means that the computer network card is not connected to the routing line, and the reasons are as follows:

1. The network cable is not good, it is very important to replace or repair the network cable and use the most advanced crystal head.

2. The network card of the computer has been broken, you can replace the network card chip or add another independent network card (if you have used an independent network card, it may also be that the independent network card is in poor contact).

3. Sometimes there are some inconspicuous drive files or system file conflicts in the system, and the general software can't be repaired, so try to reinstall the system.

Problem Description]:

The faulty machine indicates that the local connection is limited or no connection, and the Internet cannot be accessed, and a yellow exclamation mark is displayed in the lower right corner.

Cause Analysis]:

ADSL dialing exception.

Router settings.

The IP address is abnormal.

NIC working mode.

Easy Steps]:

Network Neighbors] - [Local Connection Properties] - Cancel [Notify when this connection is restricted or there is no connection].

My Computer] - [Management] - [Device Manager] - [Network Adapter] - [Advanced] - [Connection Speed and Duplex Mode] - [10

Mbps half-duplex.

Solution:]:

Solution 1: Disable the icon in the lower right corner.

Figure dry search 1 figure 2

Figure 3: Check the DHCP of the router, turn it off and on to see if it is valid (go to the router to check the DHCP).

Solution 4: Change the working mode of the NIC. Change to 10m half-duplex or full-duplex.

Figure 6: Problem description].

The faulty machine indicates that the local connection is limited or no connection, and the Internet cannot be accessed, and a yellow exclamation mark is displayed in the lower right corner.

Cause Analysis]:

1.If the local connection is restricted, you will not be able to obtain the correct IP address, so you need to check whether the IP address assigned by the router is normal.

2.You can manually configure IP addresses and DNS to configure local connections.

3.In addition, the working mode of the NIC also has an impact on this issue.

Easy Steps]:

1.Check the DHCP of the router, turn it off and on again to see if it works (go to the router to check DHCP).

2.Correctly configure the IP address and DNS address.

3.Change the NIC working mode. Change to 10m half-duplex or full-duplex.

Solution:]:

Figure jujube roll 34Select "Advanced" - connection speed and duplex mode" - 10