Can the car instrument light pass the annual inspection if it is not lit?

Hello, yes, this is not about the annual review.

If the instrument indicator is not lit, first check the power supply fuse of the dashboard, and replace it if it is blown. Disassemble the dashboard, the lights are generally at the back of the dashboard, replace the lights that are not lit, and generally the individual lights are not lit to indicate that there is no problem with the fuse and wire, the main reasons are as follows

1. The lamp of the dashboard is damaged and needs to be replaced in time;

2. If the power supply line of the dashboard is broken, there is an open circuit or short circuit, which will also cause the car dashboard to not light up;

3. If the power supply fuse of the car dashboard is broken, there will naturally be no power supply, and the dashboard will not light up.

Precautions in the use of the car dashboard:

1. When the indicator light is on, the odometer should be observed immediately, if the cumulative mileage reaches or exceeds l00,000km, the timing toothed belt must be replaced, otherwise the timing toothed belt may break, so that the engine can not work normally.

2. After replacing the new timing toothed belt, it is necessary to open the rubber plug outside the reset switch on the mileage dial, and press the reset switch inside with a small round bar to extinguish the indicator light of the timing toothed belt.

3. After replacing the new timing toothed belt, remove the odometer and adjust all the readings on the odometer to the 0 position.

Can't pass.

The Regulations of the People's Republic of China on Road Traffic Management have corresponding provisions on it:

Article 19 Motor vehicles must be kept in good condition and clean and tidy. Brakes, steering, horns, wipers, mirrors and lights must be kept in full force.

The brakes, bells, reflectors and braking devices of bicycles, tricycles and vehicles for the disabled must be kept active. If the inspection is not carried out in accordance with the provisions or the inspection is unqualified, it is not allowed to continue driving.

After the vehicle is started, if the fault light keeps on, it means that the engine electronic control system is faulty. The most common cause may be a faulty engine sensor, or a damaged actuator, or it may be a wiring cause. However, if the fault light is on, it may affect the annual inspection.

If it has influence, it can't pass the stage, and it is a non-qualified item. Affect the annual inspection may not work, there are 6 kinds of vehicle detection: 1. Speedometer indication error detection.

2. Vehicle chassis (trench) detection. 3. Headlamp detection. 4. Steering wheel slip detection.

5. Wheel weight detection. 6. Automobile dynamic performance testing.

The annual inspection only checks the lights, brakes, exhaust, whether there is any major damage to the appearance, and whether there are illegal modifications. Generally, small faults can be signed on the annual inspection form to ensure that the maintenance can be passed.

The vehicle inspection does not detect the instrument, as long as the fault light is on and does not affect the exhaust emissions.

If the fault light is on after the annual inspection, it does not necessarily mean that the car is broken, but it may just be a false fault caused by the car's computer misjudgment.

After the annual inspection, the fault light may be a false fault, and the computer system will misjudge due to external interference during the operation of the car, resulting in a fault signal.

The state of the annual inspection of the car is quite different from the normal driving state of the car, and the computer of the car is prone to misjudgment and lights up the fault light.

Bright yellow ABS fault light.

In this case, the easiest thing to report is ABS.

The wheel speed sensor detects the speed of each wheel at all times, and then sends the speed signal to the electronic control unit, which controls the hydraulic module according to the signal, so as to adjust the braking force of the wheel.

The yellow ABS fault light will light up, reminding you to check.

The car is tested on the test bench, and then the exhaust is tested, the speed will be higher than usual, and the on-board computer will feel that the car is malfunctioning and light up, but there is no need to worry too much.

Because when the car is inspected, the inspector will turn on all the functions, so the indicators on the dashboard are all on.

This is a violent car inspection on the car inspection line, after the offline if you find that the dashboard is fully lit, go to the 4S shop to eliminate the error**, basically there is no problem. The current car review is simply a ruined car.

Summary. The fault light on the car instrument is on, and there is definitely no way to pass this annual inspection. In the process of annual inspection of the vehicle, this will check the fault light on the instrument, first of all, this needs to be checked, including this light control, including the instrument to see if there is a fault, this must be checked, the fault light on the instrument must not be able to pass the annual inspection.

Can the annual inspection be passed if the fault light of the car dashboard is bright?

Hello, happy to answer your questions.

The fault light on the car instrument is on, and there is definitely no way to pass this annual inspection. In the process of annual inspection of the vehicle, this will check the fault light on the instrument, first of all, this needs to be checked, including this light control, including the instrument to see if there is a fault, this must be checked, the fault light on the instrument must not be able to pass the annual inspection.

If the car airbag failure light is on, can the car pass the inspection?

The airbag failure light is on, and there is no way to pass the annual inspection. The airbag is a safety system of the vehicle, and there is definitely no way to pass through this light.

It is because some staff will conduct a violent test on the vehicle, resulting in damage to the vehicle, so the alarm indicator light will be turned on.

Because they will test the performance of the car, for example, the speed is relatively high, which will be detected by the car's computer system as faulty.

This is because all the functions of the car need to be tested during the annual inspection, so the lights will be on.

The reason why the car dashboard lights are fully lit.

The CAN bus is faulty, and the CAN interface of the ECU is not in good contact.

2.Excessive dirt and carbon deposits, abnormal air circulation, and inability to accurately control the normal air intake volume, resulting in unstable gas levels and making the engine not work well.

3.The low fuel pressure combined with the poor constant pressure performance leads to a low level of atomization in the system, making it difficult for the car to start.

Extended Materials. About the car dashboard.

1.The car dashboard is a device that reflects the working conditions of each system of the vehicle. Different cars have different gauges. However, the conventional instruments of general automobiles include speedometer, tachometer, oil pressure gauge, water temperature gauge, fuel gauge, charging gauge, etc.

2.A variety of indicators or warning lights are made under the instrument panel of modern automobiles, such as coolant level warning light, fuel level indicator, washer liquid level indicator, charging indicator, high and low beam dimming indicator, transmission gear indicator, brake anti-lock braking system (ABS) indicator, drive force control indicator, airbag (SRS) warning light, etc.

Hello dear, two situations: the first situation is the normal quality inspection of the vehicle, will not be affected, after the vehicle completes the self-inspection, the lights on the dashboard will be all extinguished. The second situation is that there is a fault, it is the driving computer that is confused, and the motor vehicle at this time is not able to drive, and it is necessary to use the detection computer to read the specific fault**.

The dashboard of the motor vehicle can reflect the working conditions of the various systems of the motor vehicle, and the dashboard of the motor vehicle is guessed that there will generally be fuel indicators, cleaning fluids, indicator lights, electronic throttle indicators and some warning lights, when there is a fault on the dashboard of the motor vehicle, it is necessary to detect the motor vehicle and determine the fault after maintenance.

The vehicle management office inspected the vehicle violently, which seriously damaged the vehicle system and engine, resulting in the instrument panel indicator light being fully lit.

It may be that in the process of testing, a relatively non-standard detection was encountered, which damaged a lot of internal components and had a big problem with its performance.

This is because the DMV conducts extreme tests on vehicles. In case of emergency, see if the vehicle can work safely and effectively.