The motorcycle burned the oil, repaired the sound, and occasionally a little smoke, why

Updated on Car 2024-03-22
9 answers
  1. Anonymous users2024-02-07

    Summary. Generally, the most ideal situation is not to repair, this is the motorcycle piston ring wear excessive wear caused by oil channeling, this problem is generally based on the vehicle, the senior motorcycle ring is about 180-300 between, very cheap motorcycle ring is dozens of dollars, but the ring is not durable after the replacement, so that it will form a strange circle, in the future will often be on the way to repair the car, you can find the oil essence that can repair the cylinder liner and piston ring to eliminate the wear and tear between the piston ring and the cylinder liner or sell the motorcycle for a new motorcycle stop loss.

    The motorcycle oil burned dry, and when the oil was added, it smoked.

    Hello, I am inquiring for you, please wait a while, I will reply to you immediately Dear, hello, I am happy to answer for you. When you are short of oil, some cylinders are pulled, and the cylinder is not tightly closed, causing the oil to burn. You have to change the barrel, the piston, the ring.

    Generally, the most ideal situation is not to repair, this is the motorcycle piston ring wear excessive wear caused by oil channeling, this problem is generally based on the vehicle, the senior motorcycle ring is about 180-300 between, very cheap motorcycle ring is dozens of dollars, but the ring is not durable after the replacement, so that it will form a strange circle, in the future will often be on the way to repair the car, you can find the oil essence that can repair the cylinder liner and piston ring to eliminate the wear and tear between the piston ring and the cylinder liner or sell the motorcycle for a new motorcycle stop loss.

    What smoke does it emit in this situation.

    If the fuel tank is burned out, the temperature is high, and if you add it again, it will smoke.

    Isn't there blue smoke when the piston ring is broken?

    I'm smoking.

    No, dear, the white smoke is due to the fact that the oil has burned out and the temperature of the oil pipe has risen.

    It has nothing to do with the water inlet of the engine oil and the water inlet of the exhaust pipe.

    Nope. I hope the above is helpful to you If you are satisfied with me, please give me a thumbs up

  2. Anonymous users2024-02-06

    Motorcycle burning oil, generally due to the cylinder block, piston, piston ring wear, valve oil seal is not tightly closed caused by the paragraph, supporting the replacement of these parts, if not very expensive or special model, the general repair cost is about 200-400 yuan is enough.

    There are many possibilities for the problem of loud noise, the motorcycle engine is assembled from many parts, and many parts are running at high speeds, almost any part has a problem, it may cause loud noise, and the sound problem can not be judged in the case of not being heard, which can only go to the after-sales service or motorcycle Hulu car repair shop to check, find out the cause of the fault and then repair it according to the situation.

    Today's motorcycles are all four-stroke, the engine noise is large, generally related to the large valve clearance, camshaft and valve rocker arm wear, timing chain lengthening or tensioner failure, valve ejector rod damage, cylinder piston strain or trouser burn damage clearance, crankshaft connecting rod failure, bearing wear, and other parts loose or damaged.

  3. Anonymous users2024-02-05

    You've been here for 10 years, haven't you? If it's been 10 years, there's not much need. Burning engine oil must be the piston ring is broken, if the cylinder can not be used then it is miserable, a set of cylinders will be one or two hundred, the noise is because the cam is worn, the timing chain does not know whether the branch can be used, this thing is broken is also a loud noise.

    If you change to the cam, the swing ratio should also be changed at the same time. If you have to change all these things, it will cost about 400 yuan. If it's a car that Cheng Chun has been lifting for ten years, do you still spend so much money to get in?

    The clutch is not included in the price.

  4. Anonymous users2024-02-04

    Replace the piston rings and check the piston and liner clearance.

  5. Anonymous users2024-02-03

    Burning engine oil is blue smoke, and black smoke is generally caused by the excessive concentration of mixed gas caused by various reasons. Check whether the air filter is blocked, whether the carburetor mixing ratio is improperly adjusted and too concentrated, whether the oil level or oil needle height is too high, whether the damper is used improperly or problematic, whether the carburetor is aging and the main volume hole becomes larger, etc., and other causes of black smoke include the exhaust valve clearance is too small or not tightly closed, the gas distribution is late, and the gasoline is not good. Due to the many possibilities involved, how much does it cost to repair the specific repair, it is necessary to find out the cause and then depend on the failure situation.

  6. Anonymous users2024-02-02

    Black smoke from motorcycles is not burning engine oil, but blue smoke is burning engine oil. The black smoke is usually caused by the air filter being blocked, resulting in the mixture being too thick. Blue smoke is what burns engine oil and needs to be changed.

    Whether the negative pressure rubber pipe connected to the throat is aged, cracked, and leaking. Whether the three-way fuel tank switch is damaged. Whether the carburetor oil filter is blocked.

    Whether the fuel line is unobstructed. Whether the various measuring holes of the carburetor are blocked. Whether the carburetor float height is too high or too low.

    Whether the main oil needle is worn. Whether the vacuum membrane is ruptured.

  7. Anonymous users2024-02-01

    When running, black smoke is generally too thick in the mixing ratio, but if you idle and throttle a car will basically emit black smoke and burn inadequately.

    It may be good to clean the carburetor, which is the imbalance of the compression ratio of air and oil 9:1 of oil and gas.

    Blue smoke is generally caused by burning engine oil, but in addition to seeing whether there is blue smoke, there is also an important criterion to see whether the engine oil in the engine will decrease significantly faster, if the engine oil in the engine is not reduced, but only sometimes there will be blue smoke, it is not burning engine oil.

  8. Anonymous users2024-01-31

    Black smoke from a motorcycle is not burning engine oil. Black smoke emitted after a motorcycle is started may be due to an excessively thick mixture in the motorcycle engine, poor spark plug work, or late ignition. If the motorcycle often emits black smoke after starting and can smell the pungent smell of gasoline, then you need to pay attention to avoid more serious failures of the motorcycle, and you should pay attention to sending the motorcycle for repair as soon as possible.

    Failure analysis: 1. Blue smoke from the exhaust pipe.

    The fault phenomenon is: during the working process of the engine, light blue smoke is often seen at the tail of the exhaust muffler, and the organic oil is consumed too quickly. The reasons for the failure could be:

    The oil level is too high; The cylinder compression pressure is lower than the specified value; The gap between the piston, the piston and the drum barrel increases.

    2. White smoke comes out of the exhaust pipe.

    The fault phenomenon is: when the engine is working, the exhaust pipe emits white wheel smoke. The reason for the failure of Latongcha may be: the fuel contains water; There is moisture in the cylinder or muffler.

    3. Lack of power.

    In this case, the piston ring is aging and the seal is not good, the valve is not tightly closed or the carburetor is blocked! Replace piston rings, valves, and clean carburetors.

  9. Anonymous users2024-01-30

    1.Motorcycles emit black smoke, is this burning engine oil?

    Sometimes when we drive a motorcycle, there will be black smoke from the motorcycle, and many people will think that the motorcycle burns engine oil. However, the cause of black smoke from motorcycles is very complex and can be related to many aspects. Let's take a closer look.

    2.What causes black smoke from motorcycles?

    First of all, the black smoke emitted by the motorcycle may be due to the air filter being clogged, causing incomplete combustion, resulting in a large amount of smoke. Secondly, if the engine is not properly tuned and the fuel mix ratio is incorrect, it will also lead to incomplete combustion. In addition, if the exhaust pipe of a motorcycle is blocked or deteriorates, it can also lead to poor exhaust gas, which in turn leads to smog.

    In conclusion, the causes of black smoke emitted by motorcycles can be caused by a variety of factors.

    3.How to avoid black smoke from motorcycles?

    To avoid black smoke from your motorcycle, you first need to replace the air filter, and you need to clean and replace it frequently. Secondly, when the engine is adjusted, it needs to be carried out in accordance with the manufacturer's regulations to ensure that the fuel mix ratio is correct. In addition, regularly inspect the exhaust pipe of the motorcycle to avoid clogging, or replace the aging exhaust pipe in time.

    These measures can reduce the probability of incomplete combustion, which in turn reduces the probability of black smoke emitted by motorcycles.

    4.What are the manifestations of burning engine oil?

    Although the black smoke emitted by the motorcycle is not the result of burning the engine oil, if the motorcycle burns the engine oil, there are some obvious manifestations. For example, when driving a motorcycle, blue smoke will come out of the exhaust pipe, and it will also have a strong greasy smell. The fuel consumption of the engine will increase significantly, and at the same time, the engine will be less powerful and the noise will increase.

    In addition, if you open the oil cap, you will also see visible traces of oil.

    5.How to avoid burning engine oil on a motorcycle?

    The main reason for burning engine oil in motorcycles is that motorcycles are aging and used for too long. Therefore, the maintenance of the motorcycle is very important, and it is necessary to change the oil frequently, and change the oil filter regularly. At the same time, it is necessary to pay attention to the driving state of the motorcycle, avoid long-term low-speed driving, less rapid acceleration and deceleration, and avoid serious overload, these operations can prolong the service life of the motorcycle, and reduce the occurrence of burning engine oil at the same time.

    6.Conclusion.

    Black smoke from a motorcycle does not necessarily mean that the engine oil is burned, it can be caused by a variety of reasons, and avoiding the motorcycle burning engine oil also requires many attentions. Therefore, in the usual driving, you need to carefully observe your motorcycle, maintain it regularly, and follow the relevant driving specifications, which can reduce the probability of accidents on the motorcycle and provide us with a safer and more convenient guarantee for travel.

Related questions
20 answers2024-03-22

Burning engine oil is generally caused by the wear of the cylinder block, piston, piston ring or valve oil seal is not tightly sealed, disassemble the engine for maintenance, replace the problematic parts according to the situation, if it is the cylinder block and piston and piston ring caused by the burning of engine oil, it is best to replace the whole set of parts, sometimes the single replacement piston ring may not be very good, and the oil will be burned soon after, but if only the piston ring has obvious wear, the condition of the cylinder block and piston is very good, and it can not be replaced. If there is obvious oil stains on the back of the valve seal, but the cylinder block and piston ring are not obviously worn, and the piston ring opening clearance is not significantly too large (generally not more than millimeters), only the valve oil seal needs to be changed.

13 answers2024-03-22

Friend: I'm a car repairer. I'll help you with that. If you have changed the oil in this car, it may be that the screws are not tightened. >>>More

17 answers2024-03-22

Hello, just ask me, I'm professional, I don't know what kind of motorcycle, the general motorcycle engine has a 17 nut at the bottom, some on the right side, that is, 5 minutes after parking, put the big shelf up, the nut with 17 wrench to open the oil, it is best to use a basin to continue, until there is not, and then lock, open the nut of the oil, add the new oil, note: the oil added between the ruler and the next scale on the line, and finally tighten it OK.

6 answers2024-03-22

OK. The first time you change the master, you can see it by looking at it.

18 answers2024-03-22

The oil change during the run-in period of the new car is displayed on the head of the meter respectively kilometers to change the oil, and then every 1500-2000 kilometers to change the oil, the oil I am referring to here is the special all-mineral lubricating oil for motorcycles above the SG level, and the life of the domestic lubricating oil will be shorter. If it is a high-grade SL or above fully synthetic lubricating oil, the service life is about 5000 kilometers. During the break-in period, the engine and gearbox need to be cleaned with lubricating oil, so the oil needs to be changed frequently, so it is not necessary to use fully synthetic engine oil to avoid waste. >>>More