When replacing new tires, it is better to put them on the front or rear wheels

In the case of replacing only 2 two tires, it is recommended that new tires be installed on the rear wheels. If you put the new tires on the front wheels, then when the vehicle is steering, because the grip of the rear wheels is smaller than the front wheels, there will be a high risk of causing the vehicle to slip and flick the tail, so in order to ensure the safety of driving, we recommend that the new tires be installed on the rear wheels. Of course, the fundamental solution is to adjust the four wheels regularly to ensure that all four tires can be replaced at the same time.

In fact, this problem depends on the vehicle to decide, the placement of new tires depends on the driving characteristics of the vehicle and the car environment, the following two situations, to sit down

Rear-wheel drive vehicles are best changed to the rear wheels.

Because the power output of the rear-wheel drive car is in the rear wheels, the characteristics of the rear-wheel drive car will make the rear wheels more likely to slip, if the rear tire pattern is seriously worn, it is more likely to have a lack of grip, and the vehicle is in danger of losing control. Therefore, if you are using a rear-wheel drive vehicle, it is best to replace the new tires with the rear wheels to avoid the risk of losing grip and losing control of the vehicle.

Front-wheel drive vehicles are best changed to the front wheels.

The characteristics of the front-wheel drive car determine that the front wheels need to bear a lot of working pressure, and the steering, acceleration and braking of daily driving will eventually act on the front wheels. As a result, front-wheel drive vehicles are more likely to wear out the front wheels than the rear wheels, and there is a greater chance of a puncture. Once the front wheel blows out, the vehicle becomes difficult to control and extremely dangerous.

Therefore, if you are using a front-wheel drive vehicle, it is recommended to replace the new tires with the front wheels.

It is necessary to change the front and back tires.

Due to the different working conditions and loads of each tire, the rear wheel load of the truck is generally greater than the front wheel, and the front wheel load of the car is generally greater than the rear wheel, if the driving position is on the left side.

Normally, the speed of the car when turning left will be greater than the speed when turning to the right, resulting in the tire on the right side of the car being stressed more than the left tire when turning left, and the right edge of the right tire is most worn after the car has traveled a certain mile.

Therefore, in order to avoid uneven wear caused by long-term fixed use of the wheel, which will affect the service life of the tire, it is still necessary to change the front and rear of the tire.

Precautions for tires:

In the manual we buy a car, it is generally indicated that the car has run for about 20,000 yuan, and the front and rear wheels need to be reversed once. This also depends on the degree of wear and tear of the tires of the car, if you usually drive, your car often runs on that kind of non-paved road, it may need to be reversed for more than 10,000 kilometers, because this is particularly worn on the tires.

The safe mileage of a tire is about 80,000 kilometers, and it can be driven for about five or six years. But some friends may drive 3 to 5 kilometers and then plan to change the tires because they are afraid that it will not be safe.

It is necessary to change the front and rear tires, and the front and rear wheels wear differently Pay attention to the tires to change positions frequently. Generally speaking, the front-wheel drive vehicle, because its front tire bears most of the force in load-bearing, acceleration, driving, steering, braking, so the front tire wears out faster than the rear tire, and its wear ratio can reach 2 1. During routine maintenance, frequent tire rotation helps to ensure uniform wear and tear of the tire, thereby extending the life of the tire.

If signs of premature wear and irregular wear are found, the frequency of tire rotation can be appropriately increased, and the wheel alignment needs to be done after replacement, because the wheel alignment will keep the vehicle's suspension system and driving system in a standard state.

1. The specifications of the tires purchased must be consistent with the specifications of the tires assembled in the original car, if you need to change the tire specifications, you must go to a professional modification shop for tire upgrades, or consult the car manufacturer.

2. Tires of the same specification, structure, manufacturer and pattern should be assembled on the same axle. (Load index, speed level is the same).

3. The load of the vehicle should not exceed the maximum load capacity of the tire, and the speed of the driving vehicle should not exceed the maximum speed of the tire.

4. In the case of replacing only 2 two tires, it is recommended that the new tires be installed on the rear wheels.

5. In the case of replacing only one tire, the new tire must be close to the depth of another tread groove on the same axle, otherwise it may cause problems such as vehicle deviation.

New tires should be fitted on the rear axle of the vehicle. This is because, if you put a more worn tyre on the rear axle of the vehicle, the weak drainage of the tyre will greatly increase the risk of oversteer in rainy weather.

Car tires need to be replaced regularly, generally after 6-80,000 kilometers or 5 years. But if a punctured tire is badly worn and needs to be replaced, do you know whether the new tire should be placed on the front wheel or the rear wheel?

The principle of the bench macro for tire change is that the front wheel drive is replaced by the front wheel, and the rear wheel drive is replaced by the rear wheel. The daily steering, acceleration and braking of the front wheels will bring high load to the front wheels. Over time, it will aggravate the wear of the front wheels, and the rear wheels, as driven wheels, will wear much better than the front wheels.

If the front wheels are not in good working condition, the probability of a puncture will increase invisibly.

Rear-wheel drive vehicles are the opposite of front-wheel drive, with the rear wheels carrying high loads. Because the rear wheels are the drive wheels, good tire friction needs to be ensured. The rear wheels are heavily worn, the grip will be reduced, and it is easy to slip. Therefore, rear-wheel drive recommends replacing new tires with the rear wheels.

According to the analysis, the front wheel drive is given priority to the front wheel, and the rear wheel drive is given priority to the rear wheel. If you drive four, of course you have to change the front wheel first. However, there will be exceptions. If individual tires are seriously worn, adjust the tire position appropriately to ensure driving stability!

As soon as a new tire is replaced, it must be dynamically balanced. If we don't do this, when driving at high speeds, the tires will not be round, resulting in unstable driving, steering wheel vibration, and affecting driving safety. In fact, when repairing tires, replacing valves of different materials, replacing wheels or installing tire pressure monitoring modules, it is necessary to correct the dynamic balance.

Have you learned?

Millions of car purchase subsidies.

<> "Are the new tires placed on the front or rear wheels?" It is normal for car owners to have questions about this problem, because even the recommendations of tire manufacturers are different. See what the technicians have to say.

The technician said that from a technical point of view, it should be placed on the rear wheel, why is that? This answer is the same as the advice of a well-known tire company, Michelin tire manufacturer. The masters all know that if the rear wheel adhesion of the vehicle is insufficient while driving, the vehicle will lose control, and there will be a side slip and tail flick, which is prone to accidents.

If it happens in the front wheels of the vehicle, it is easier to control, and the vehicle can be corrected by steering, throttle, and brake. This is for safety reasons, after all, we often say safety first.

Some technicians say that if it is a front-wheel drive car, it is better to put new tires on the front wheels to provide better grip. This answer is in line with the advice of another well-known tire company, Kumho Tire Manufacturer.

This point of view is also reasonable, as far as tire wear is concerned, many cars are front-wheel-drive, the front wheel is both the driving wheel and the brake wheel, and the vehicle in the braking process due to the center of gravity forward, the front wheel of the vehicle is subjected to friction much greater than the rear wheel, so the old posture of the general vehicle front wheel wear is much faster than the rear wheel wear.

Put the new tires on the front wheels, and the wear and tear of the front and rear axle tires will gradually equalize, and the old tires can be used for a longer time in the rear wheels, which will also save you money.

And, as the mechanic said, the front wheel drive has better grip with new tires, so the vehicle will power better. Tires will wear out during use, regardless of whether the vehicle is front-wheel-drive, rear-wheel drive or four-wheel drive.

As for whether to put it on the front wheel or the rear wheel, you can listen to the technician's advice, because it makes sense to put it on the front wheel or the rear wheel.

During the use of the vehicle, there will be one item in the after-sales maintenance project - four-wheel transposition. It is what we often say about changing the position of the tires on the front and rear axles, don't forget this item when maintaining the car, it is recommended to do it once for about 15,000 kilometers.

Tire rotation makes tire wear more balanced, so that it is not only safe but also maximizes the value of the tire, under normal circumstances, 4 tires can reach the service life at the same time, and then 4 tires can be replaced together.