Why can t the DJI drone Phantom 3se start?

If your Phantom 3 SE's motor does not start properly, please try to solve the problem by using the following methods:

1. If this phenomenon occurs after the collision, please send the aircraft back for testing through self-service repair;

2. If the aircraft is a new and inactivated product, the motor can only start normally after activating the aircraft;

3. Please check whether the take-off area of the aircraft is in the no-fly zone, and the motor of the aircraft in the no-fly zone will not be able to start;

4. When the aircraft is in novice mode, it will not be able to start the motor normally when there is no GPS signal (such as in the indoor environment);

6. If the remote control lever breaking operation cannot start the motor normally, please try to calibrate the remote control, set the remote lever mode to "American hand", and try again;

7. When trying to start the motor, pay attention to the message prompt on the DJI GO or DJI GO 4 interface.

UAV control theory v, light UAV professional research v is required

Dear, hello, I'm glad to answer for you, the big trouble Xinjiang elf 3s boot gimbal didn't respond? Answer; The status indicator flashes yellow to indicate that the gimbal is abnormal, check if there is any concealment and failure to adjust the balance. Double-click the mode switch to see if there is any response, or try to change mobile devices and try again.

Turn on the Phantom 3 SE gimbal, there is no response, it should be the chip burned 1Please extend the button time of the DJI drone to confirm that the long press is in place; 2.Please check whether the gimbal macro tremor short circuit protection is caused by moisture or rain, etc., and release the battery short circuit protection by charging after the gimbal is dry; 3.

Please check whether the battery overvoltage protection is caused by abnormal charger charging, and you can remove the protection by charging the gimbal with a compatible charger. If the handle fails to turn on, it means that there is no battery or that the power button is damaged.

Launching a DJI drone is a relatively straightforward process, and here's the general process of getting started:

1.Check the drone: Make sure the drone's battery is charged and that there is a good connection between the drone's main body and the remote control. Inspect the exterior of the drone for any damage or foreign objects.

2.Turn on the remote control: Press and hold the power button on the remote control until the remote control's indicator light is on.

3.Start the drone: Press and hold the power button on the drone until the drone starts flashing or beeping. This indicates that the drone has been activated.

4.Connect the drone to the remote control: Try connecting the remote control to the drone. Press the connect button on the remote or bring the two close together until they connect successfully.

5.Calibrate the drone: Before the drone takes off, it's a good idea to calibrate. The specific calibration steps will vary depending on the drone model, please find detailed calibration instructions in the user manual.

6.Prepare for takeoff: Make sure there are no obstacles or crowds around the drone. Adjust the camera wilt angle, check the flight mode and flight parameter settings. Confirm that the connection between the remote control and the drone is stable.

7.Takeoff: Usually, you can gradually lift the drone to take off off from the ground by pushing the throttle lever on the remote control up. Carefully control the attitude and altitude of the drone to ensure flight safety.

Please note that the above is only a general process for starting a DJI drone, and there may be some differences between different models of drones. To ensure a safe and smooth take-off, it is highly recommended to read the appropriate user manual carefully before starting the drone and to follow the guidance and safe operating specifications provided by the manufacturer. <>