The gas dried by the dryer is water and oil 5

Whether it is a refrigeration dryer or a suction dryer, theoretically there should be no obvious visible water at the back end that has been dried in this season, and this problem needs to be analyzed in detail.

It's certainly not normal to have water. For the refrigeration dryer, see if the drainage is smooth and how the refrigeration is. The dryer will be troublesome, and the adsorbent may be ineffective due to poisoning. What are you**? If it's close, it's free to take a look at it.

In your case, there must be a problem with the dryer, or the pipeline is gassing

Summary. 1. The air humidity around the air compressor station is high, and the air itself has humidity and contains a certain amount of moisture, when the air is compressed, due to the high internal temperature of the compressor, the water directly evaporates to form water vapor, and then the compressor is discharged with the pressure, and when it is shut down, the temperature drops, which will make the water vapor form condensation. Therefore, the working environment humidity of the air compressor should be low; Or drain the condensate before starting it up.

Hello, dear, we have seen your problem here, wait for 5 minutes to sort out the information, and immediately inquire <> for you

1. The air humidity around the Zhipei air compressor station is large, and the air itself has humidity, containing a certain amount of moisture, when the air is compressed, due to the high internal temperature of the compressor, the water directly evaporates to form water vapor, and then discharges the compressor with the pressure, and when it is shut down, the temperature drops, which will make the water vapor form condensation. Therefore, the working environment humidity of the air compressor should be low; Or before starting the machine to use, drain the condensate out only to the acacia.

That's because the air itself contains water, and you can see the enthalpy diagram to know the moisture content.

1.Whether the refrigeration dryer is a high-temperature type (with pre-cooling).

2.Whether the refrigeration dryer capacity is sufficient.

3.Whether there is an air filter installed, the front end is installed, and the front end is generally two at high temperature.

4.Whether the air volume of the air compressor matches the air volume of the refrigeration dryer, 5If it is a new installation, there is still this problem, if it is not a problem with the refrigeration dryer model and the problem of the working environment, it is that the gas requirements are too high.

Solution(s): 1Adsorption desiccant 2

Replace the dryer filter 3Install an adsorption dryer. 4.

If you consider simplicity, ** and the quality of compressed air is not too high, it is recommended to add a water eliminator after the dryer to deal with the problem of too much water. After all, the cost of adsorption dryer is relatively high.