Precautions for the installation of parquet ? It s time to decorate, how to choose?

Shengda parquet fully accepts third-party impartial inspection and is accredited by a national laboratory.

The precautions for the installation of parquet are as follows

1. Clean the floor before installing it. Especially where there is a "tumor".Eradication

2. If the wall is on the sideThe heating duct trough is too large and too deep, it is better to fill it with dry sand. Don't seal it with cement!

3. Sprinkle the floor medicine, and sprinkle more in the corners and doorways.

4. PavingMoisture-resistantFloor mats, if it is a geothermal floor, must be a geothermal special floor mat.

5. Be sure to keep the floor and wall 8mm stretchable space.

6. InstallationKick corners, it is best to use a yin and yang angle, because when a yin and yang angle is used, the joint of the kick angle will be strong.

7. Before the installation is finished, be sure to fully accept it again.

8. Arrange the wired, first-class and network cables.

9. If there is a water pipe, the installation master must be notified of the heating pipe renovation to avoid accidents!

10. Require the installer to remove the sawing under the door sleeve and let the floor be inserted under the door sleeve, so that the installation is more solid.

11. Before installation, it is best to open the packing box and check whether there are any missing corners on the floor surface (this situation is rare, but it should also be prevented).

12. Be sure to make each room a section of its own. (Disconnect at the door, leave a retractable space) if it is a large area, disconnect every 8-10 meters of span.

13. It is best to use copper or stainless steel strips at the junction of the floor and kitchen floor tiles, and never use ordinary plastic strips.

Many families now choose parquet, because of its good touch on the soles of their feet, it has won a lot of customers who like to walk around barefoot at home, and its installation process is also different from other floor tiles, let's take a look at the installation steps and precautions of parquet!

1. Installation steps of parquet:

1.First of all, it is necessary to determine whether the ground is flat, which is a very critical step, because it is related to the installation and use effect, so it can not be ignored, if it is found that the local unevenness, this time you can do local leveling; If we find that the ground is uneven in a large area, then we can consider self-leveling.

2.If you want the interface between the two floors to be stronger and not loose, you need to apply a special fixing glue to the horizontal and vertical sides of the floor before installation.

3.After checking that there are no problems with the floor, you can start laying the special floor mat and then directly install the parquet.

4.During the installation process, it is necessary to retain 8-12 mm expansion joints between the floor and the wall, and it is also necessary to add spring steel sheets and springs, about 40 steel leaf springs per 100 square meters, and the number of springs is about 200.

5.Once installed, tap the floor from the side so that the joints of the floor will be better fixed and the surface seams will be finer.

6.If you encounter irregular corners, the expansion joints of the floor and wall should also be done, because this will affect the quality of construction.

7.In addition, the gap between the buckle should be pressed with pliers so that the upper and lower parts can be made stronger, and the standard for compression is that it does not make a sound even if you step on it.

2. Precautions for installation of parquet:

1.Be sure to clean up the wood chips and floor waste that are generated during the installation process.

2.Since the surface of the floor is very easy to scratch, it is necessary to lay a protective film with a certain elasticity on the surface of the floor to protect it.

How to maintain parquet?

1.It is very important to keep the floor dry and clean, and it is absolutely not allowed to wipe the floor with a dripping mop, or with alkaline water or soapy water, which will directly destroy the gloss of the paint surface.

2.It is necessary to avoid the floor being exposed to the sun, because if it is exposed to the sun for a long time, the floor is easy to age and even crack.

3.It is best to keep the waxing frequency every three months, so that you can maintain the finish of the floor and prolong the service life of the floor.

4.In addition, it is necessary to avoid scratches on the floor by sharp objects and places objects on the floor that are too hot.

The quality of floor installation largely determines the use experience and quality of the floor, largely due to the lack of standard installation of the floor. There are four things to pay attention to when installing laminate flooring, which are: choosing the right time to place the floor, moisture-proof flooring, paving process, and cleaning and maintenance after construction.

Laminate flooring installations have high requirements for ambient temperature and humidity. Usually, a temperature between 16 and 30 for the floor covering is sufficient so that the wooden flooring can be kept in optimal condition. In terms of season, the seasons of spring and autumn are more suitable than summer and winter.

24 hours a day, try to avoid midday and evening construction, preferably after 2pm.

Laminate flooring should be stored at room temperature for two days before installation and then laid. Those that are already damp are more likely to mildew, and their service life is greatly shortened. It cannot be dried or reused.

The purchased flooring is also treated with moisture protection before being placed. Apply a layer of moisture-proof protective paint to the back of the floor to prevent the wet floor from affecting the floor.

If the soil environment is relatively humid when the laminate flooring is installed, in addition to waterproofing, it is necessary to use waterproof materials such as pearlescent cotton or aluminum film to treat the substrate to ensure that the soil is dry. Then apply glue to the floor. When placing the mat, take care that the mat should lie flat and not be empty, and that the mat should be securely fastened to the floor.

Do not stick around the carpet as it will seriously affect the soil moisture. Function.

Laminate flooring installations should be covered with paper to prevent foreign objects or paintings from falling onto the floor during renovations. Avoid walking on the floor frequently and placing heavy objects during the 48 hours of floor covering, so that the floor adhesive can adhere firmly to the floor and the floor will dry naturally. Do not rush to open the window or use the air conditioner to blow after ventilation, as this will not only speed up the drying of the glue, but also make the floor dry and brittle.

Therefore, the floor should have some time to adjust to the temperature and humidity of the room.

When installing laminate flooring, pay attention to the above four precautions to make the installation of laminate flooring more scientific.

You can get it for free

Nowadays, most people install laminate flooring in their homes, not only because of its aesthetics, but also because of its high safety factor, especially for families with elderly people and children. The installation of laminate flooring is not easy, and there are many details to consider. I'm going to talk about that nextParquet installationsteps andParquet installationWhat to look out for.

1. If the garbage cannot be cleaned up and stepped on the ground in the future, you can feel the sound of "sand". Therefore, it needs to be completely cleaned, including every corner.

2. If the floor is uneven, the floor must be leveled first, and then placed. First of all, it is necessary to pay attention to the standard, and the horizontal error of the floor should be kept within 2 mm. If the floor is uneven, wooden flooring will be placed, which will seriously affect the quality of the floor and the future living environment.

3. Place a moisture-proof layer on the floor before placing it. When placing the vapor barrier, be sure to smooth it, the seams of the vapor barrier must be together and there are no gaps. This prevents the floor from getting wet for a long time.

4. Everyone should know that the floor will expand, so when placing the wooden floor, in the area where the floor and the wall meet, keep the expansion joints to prevent the floor from rising.

5. Check whether the special glue is qualified. When placing wooden floors, special glues are required, which not only have high viscosity, but also have less pollution. If it is a commercially purchased glue, it is better not to use it, the contamination is more serious.

6. Start laying wooden floors. In general, they will be placed in a long and a short order so that the published floors are of better quality and are not easily loosened. After splicing, you have to stop and use the tool. It's stressful.

7. It is to connect and install the anchor line. The final step is to attach the floor wire, which can be covered with a floor heel or filled with glass glue.

Parquet installationThe horizontal error must be controlled at 2 mm. If this is exceeded, it must be resurfaced through the cement surface.

2. Before laying the floor, you must make sure that the floor is dry and there is no liquid to sleep. If it is a concrete floor, wait at least 3 days before placing the wooden floor.

3. When cutting wooden floors, it is best to pick up defective floors and reduce the loss of floors.

Tuba Rabbit provides you with "each finger decoration **, 1-4 local decoration companies, and 3 sets of decoration design schemes" for free in guessing the tease line, and Suiyuan has a decoration strategy to avoid pits! Click this link: [

You can get it for free