How to find out which computer in the LAN has the ARP virus, it always sends ARP to conflict with th

A firewall alone is not enough, now your computers are all shared in the local area network and share an egress bandwidth. ARP, on the other hand, is a normal protocol behavior in Ethernet. ARP spoofing is a protocol vulnerability in Ethernet itself.

For example, the ARP spoofing you mentioned. But there's still a lot of ARP spam packets in the network you're sharing. If conditions permit, you can use package capture software to analyze and see, such as domestic science analysis software.

The intranet is flooded with this large number of broadcast packets and other types of protocol attacks, and your computer is still showing slow speeds. There are many ways to solve ARP in technology now, but none of them can completely solve the problem. Only the immune wall technology can completely solve the protocol attacks on the intranet such as ARP, SYN, and DDoS, including the flow direction-based rate limiting.

Therefore, it is recommended that your network be upgraded to an immune network, so that no one can attack the network shared by everyone, and the network environment is clean. Naturally, it will not affect the use.

Hello: It is recommended that you install the Rising Antivirus v16 version and upgrade to the latest virus database, restart the computer and press the F8 key to select the safe mode, perform a full virus scan and kill, and then use the Rising Security Assistant to repair the computer, **Address:

ARP viruses are LAN attacks, and the ARP wall in 360 Security Guard can block ARP attacks. You can set it up and set the method. Open the 360 Trojan Shield, turn on the ARP Guard, and click Smart Settings on the right.

In the ARP Firewall page that opens, switch to the Status tab and click Enable ARP Firewall.

Next, switch to the "Settings" tab and check "Manually configure gateway DNS".

and click the "Bind Gateway DNS" button to manually enter the gateway and its MAC address.

After the ARP firewall is enabled, a notification will be given when an ARP attack occurs again on the local area network, and in the "Interception Logs" tab, you can view the ARP attack records, including the source computer of the ARP attack. As shown in Fig

Run the software and tick the item "Automatically isolate when LAN ARP attacks are found" in its main interface.

Then select the "NIC Type" and click the "Start Monitoring" button.

Click the "Move to Whitelist" button to move all or part of the computers in the "Blacklist" to the whitelist for effective monitoring.

ARP network disconnection attack, someone is attacked in the LAN, 360 intercepts more than 400 times and is still adding, and the IP address has been chased, how to deal with it? Praise him That's the same LAN to have arp attack, you have to know who is attacking, you should be able to find the other party's IP address in 360 (I don't use 360's so I don't know very well), you can also find it in the cmd command line, arp -a. This command can look up a table, and to determine which one is attacking you, use arp -d to clear it.

If there is a certain IP message in a row, it is probably this IP. To prevent ARP attacks, enable ARP Firewall. Kingsoft Shell Firewall is very good, and it can be bound to this machine.

I'm not talking about experience. ~

In the 360 firewall list, there will be the other party's MAC, address and IP address, trace the other party's MAC address, enter the route and add this MAC address to the MAC filter list, he will not be able to access the Internet, I hope it can help you.

Check the IP of the computer, and multiple computers will appear when the same network is connected.

Run cmd --- enter arp a to see which IP address is the same as the IP address of the route.

Or directly bind the other party's MAC address and change his IP input (format) ARPS MAC address.

Or you can go straight to the route and bind each IP address to the MAC address.

Install anti-virus software Rising Antivirus on all computers.

Be careful to sail the ship of ten thousand years.

ARP seems to be attacking your broadband, targeting the entire local area network. It's not just attacking a computer.

Look at the mac and you can see that it's the computer.,There's a Mac displayed in the router.,Look at it yourself.。