How to punch a belt, how to punch a belt How many holes should be made in the belt

The belt is punched, and the goldsmith's punching master asks everyone to measure their waist circumference with a tape measure, and then compare the length with the belt, and take a big pen to make a mark at the position where the belt is 1-2cm more than the waist circumference. After making the mark, place the belt vertically on the small cutting board, align the punch vertically with the mark, and use a hammer to inject force into the punch to punch the belt through.

The most critical step of belt punching, which is piercing, is almost complete. After piercing, the other end of the punch, that is, the end of the grinding effect, should be used to pass through the hole that has just been punched, and keep rotating to achieve the effect of polishing the inner hole. The goldsmith punch master said that the holes made in this way are more accurate.

After punching the hole, you can try to tie it, if the belt hole is small, then continue to polish until it fits.

Belt punching method:

1. The belt is generally a simple hole punch, which is divided into two ends, one is an open end with an inner groove, which is used to open a hole, and one end is a grinding end with a grinding pattern to expand the hole.

2. The first part is a good size, which can be increased by 1-2cm according to your waist circumference. You can also use the comparison method, the same slightly more relaxed. Then draw a marker.

3. Align the punch against the mark drawn. Then use a hammer or a brick to pierce the belt.

4. Take out the hole punch, use the other end to penetrate the hole, and then turn the hole punch to polish the belt hole.

5. After the belt hole is laid, you can try it on, if the hole is still relatively small, continue to polish it.

Belt punching needs to be prepared with a hammer, belt, belt punch and other items, use a ruler to measure the distance between the belt to punch holes, and then make a mark, with a hammer to smash the belt punch perforation. The following is an introduction to the specific content of "how to punch a belt".

1. Material preparation: Before operating the belt punching, it is necessary to prepare hammers, belts, belt punches, rulers, pencils and other items.

2. Marking: Spread the belt on the table, then take out a ruler to measure the distance between the belts to be punched, and mark them with a pencil.

3. Punching: Aim the belt punch at the marked place, and hit the belt punch with a hammer until the belt is penetrated out of the hole.

4. Completion: Repeat the above operations in turn, and wear all the holes in the marked places, so that the hole punching of a belt is completed.

Generally speaking, it is enough to make 5 holes in a belt, and the distance between each hole is centimeters. Through the above article, I believe that the big missing family knows the answer to the question of "how to punch the belt". In general, the number of belt punches can be adjusted according to your own usage habits.

Materials required: belt, belt punch, hammer, light paintbrush.

1. Spread the belt flat on the tabletop.

2. Measure the position that needs to be punched, and mark it with a brush.

3. Take the belt punch, compare the size, and choose the appropriate belt punch.

4. After choosing, align the belt punch at the mark.

5. Use a hammer to punch the belt until the belt punches through the belt.

Increase the size by 1-2cm according to your waist circumference. Draw a mark on the belt. Hold the punch against the mark, and use a hammer or brick to pierce the belt. Use the grinding zone at the other end to pass through the opening. <

1. Increase the size by 1-2cm according to your waist circumference.

2. Draw a mark on the belt.

3. Hold the punch against the mark drawn and use a hammer or brick to punch through the belt.

4. Use the grinding area at the other end to pass through the opening, so that you can do it.