What are the steps to change the oil filter?

1.Warm up the engine.

2.Open the engine filler oil port cap.

3.After lifting the vehicle, remove the engine guard, remove the oil pan drain screws, and release the old oil.

4.Drop the vehicle and remove the old oil filter.

5.Open the new oil filter, take an appropriate amount of new oil and apply it to the sealing ring, wipe the oil and dirt on the joint part of the filter with a clean rag, screw on the new filter, and tighten it with a certain torque with an appropriate oil filter wrench, and wipe the appearance and joint part of the new filter.

6.Screw on the oil drain screw, put down the vehicle, fill with new oil, check the oil level, start the vehicle to idle and run at medium speed for a while, during which pay attention to observe whether the oil filter is leaking, and complete the operation after everything is normal.

Do you know the tips for changing the oil filter of your car? (3)

Lift the car up, take the oil basin, take the oil plug wrench, take the oil cartridge oil grid, put the oil into the oil basin with the oil plug wrench, and then remove the filter element with the oil grid, and then touch the oil on the new filter element, tighten it, and then take an oil plug screw pad, replace the old one, install the plug when the oil flow is quiet, tighten it, and then put the car down and add the oil, and add it to the oil dipstick.

The first part is ready to disassemble the tool, and replace it with a new oil filter.

Step 2: Put the oil, find the oil filter in the car, and remove it.

The third step is to replace the oil filter with a new one.

1. Prepare tools: special oil filter wrench head, disassembly and assembly oil filter tool, oil screw tool (13 pull wheel wrench), oil screw, T30 hexagon head and 8mm inner corner head (disassembly and assembly of engine lower guard) There are two kinds of screws, link straight handle, maintenance of oil, oil filter. 2. The car should be driven for a period of time and then change the oil, that is, if the car (engine) is hot, the oil cover should be opened when the oil is to be released, so that the oil can be released faster under the action of atmospheric pressure.

1. Preheat the engine: the oil change is best carried out immediately after a certain mileage, if not, the vehicle should be started for a few minutes before and after the oil change, so that the lubricating oil circulates evenly in the engine. 2.

Drain the oil: Open the oil drain port located in the engine chassis and put all the oil into the container prepared in advance (as shown above), the oil is hot at this time, be careful of burns. When you're done, don't do it right away.

3.Use the machine to extract the oil: use the machine to extract the oil to observe the state of the outflow of oil, if there is a smell, very viscous or stratified phenomenon, the oil change interval should be shortened, if there is a strong fuel odor, explain.

Find this place, then unscrew it, take this filter off, then clean the area around the filter, install the new one back on, and just screw it on.