What should I do if I can t get in when I take the subject 2 exam?

Timely remediation. This method has encountered the situation that can not be put into the warehouse, at this time we should take measures in time to adjust the position of the vehicle, such as when we are reversing the steering wheel to play the wrong time, we should correct our position in time, so that the vehicle can be stored normally.

Half-hill starts, including fixed-point stops and ramp starts. When I practice, I first drive the car slowly up the ramp, and when the car reaches the designated position, I press the clutch and brake at the same time, so that I will not turn off or slip. After hanging neutral, pulling the handbrake, and confirming the correct position, then the next step is the ramp start.

Hang first gear, let go of the handbrake, and slowly release the clutch at the same time, until the vibration of the engine cover is more obvious, stop loosening the clutch, and set your feet in this position. If you put it to a certain extent, the car will start moving forward. This completes the half-slope start.

When the left rearview mirror just covers the white line, hit the steering wheel to the right for one and a half circles (that is, killed, some are two and a half circles). Immediately look at the right side of the rearview mirror, the speed must slow down, when the rearview mirror can see the right corner, after seeing the corner of the library, you should pay attention to the distance between the body and the corner, when the body and the white line parallel to the right.

I think you have to go and tell the coach about it, and let the coach show you what the situation is, because reversing into the warehouse is a more flexible test item, as long as you remember the points, and then adjust it according to your own situation.

You can get off the car to ** how other people operate, don't be in a hurry when you get to the library, put the lens right, adjust the seat, sit a little upright, look at the rearview mirror If it meets the requirements, you can hit the steering wheel.

Find a few reference points on the ground and in the car, and don't always rely on your instincts.

When I was studying, I also encountered such a problem, I was beaten by the coach, the parking point of the ramp and the starting point should be in the middle of the bottom and top of the ramp. When driving from the bottom of the ramp to the fixed point of parking, there should be no problem of not being able to drive up. Instead, it should be from that point after parking, and when you start to continue upward to the top of the slope, you can't go up.

Learn to predict the position of the vehicleWe must know that there will be a certain error in every operation we have, and no one can perfectly reverse into the garage every time. Often when we find that we can't enter the warehouse, it is too late, so we must know how to predict whether the next step can be stored normally in the exam, and what to do to enter the warehouse correctly.

Is the point not accurate, practice more, practice makes perfect. Remember to remember the point clearly, if you remember the wrong point, you won't be able to go in.

If you can't get in the warehouse, you can study the specific reasons with the coach, such as mirrors, such as checking back points, such as car speed ......There is a problem with the reloading, and Ke Er is very sad.

I am a coach, and I have had such a problem in the student exam before, and then after the discussion of our coach, I came to the conclusion that I will first talk about a common reason why the coach car does not go uphill. In order to save costs, many coaches in driving schools have been converted from oil to gas. The so-called oil-to-gas conversion is to replace petroleum fuel with natural gas.

In this way, the cost will be reduced a lot, but the power output of the engine will also be reduced. When going uphill, the gas coach will not be able to go up.

First of all, I don't know the training method of subject 2, but I remember that when I practiced subject 2, including the exam, I didn't step on the accelerator during the whole process, and I passed it. Because it is better to be slower in subject 2, including a half-hill start. Then let me tell you how I practiced the half-slope start.

You must be able to repair the direction of reversing into the warehouse, and then do it according to the points taught by the coach.

I remember that when I took the second exam, there were many dots and lines on the ground, as long as I followed what the coach taught me and found it accurately, I could pass it.

I was the coach who told us that we could temporarily rent the exam room car, 200 an hour, and other students equally, an hour only to practice reversing, yesterday just passed the second subject,

The reason why the computer reports that "the reverse is not in the warehouse" is: when reversing into the warehouse, the wheels are pressed to the sideline; If the wheel is pressed, the infrared signal used for monitoring will be blocked, and the computer will automatically alarm. There are several reasons for crimping:

The speed of reversing and warehousing is too fast; operating the steering wheel too slowly; The reference point at the time of warehousing was not well observed.

To control the driving speed, use 1 gear or reverse gear to idle the whole process, and drive at what speed you start. In the process of controlling the timing of steering, we should observe carefully, grasp the key points of steering, and turn in a timely manner. When controlling the driving route test, the driving route of the car mainly depends on the speed of turning the steering wheel and the driving speed.

When your body has been put into storage, you have to continue to reverse it, and if the front of the car is still outside the warehouse, you will step on it, even if it is not in the warehouse. It's also very simple to solve, wait for the right angle of the library to be completely covered by the rearview mirror, and it is just right to step on it at this time.

There is no line, because it is not in place, after the front of the car covers the yellow line and the yellow line, is it a hanging department out of the warehouse, or you can go to an item, please ask.

That's because your car isn't fully in the front of the car, and those are going to go into the line.

There are various reasons for not entering the warehouse, it may be that the starting position of the vehicle is too close to the sideline; It may also be that the body is not straightened and the tail is upturned; It may also be due to the poor timing of the steering wheel, sooner or later, etc. There are many reasons that can lead to the failure of a reverse warehouse.

In addition, there are still some differences in the way different coaches and professors of different driving schools enter the warehouse, and there are more reasons for not entering the warehouse. So, if there are no situations listed above, don't worry. Next, Bian Xiao will tell you how to deal with it.

Prevent large losses from entering the warehouse.

The best way to solve this problem is to go to the library right away, and the imitation driving school provides netizens with two ways to prevent it from happening.

One: Stable mentality.

It's normal to be nervous before an exam. Students should learn to adjust their mentality so as not to bypass the nervous mentality and affect the operation of the exam.

Candidates can try to drink some sweet drinks, take a deep breath, change their thinking, close their eyes, and recall the operation process of reversing into the warehouse several times (see the picture above for the process of reversing into the warehouse)...

2. Prediction. In the vast majority of cases, by the time we find out that the vault is about to fail, it's already too late.

In this case, we must make sure that the operation meets the requirements before moving on to the next operation. For example, before the start of the test (before entering fingerprints), it is necessary to determine whether the body is sufficiently distant from the sideline and whether the body is straightened. Correct any problems you find, and then enter your fingerprints before starting the exam.

Interim Remedy Noise:

Unexpected situations may arise during the exam. If the course of the body deviates from your expectations due to some factors, it must be corrected in time. There is no way to give the specific correction methods to netizens, mainly because there are many problems and cannot be listed one by one.

The best thing to do is to practice more and become more familiar with the car.

Millions of car purchase subsidies.

Controlling the clutch, adjusting the seat position and left and right rearview mirrors before reversing into the garage, and maintaining an optimistic attitude are also important ways to achieve success in reversing and warehousing. After reversing into the garage and getting into the car, first adjust the front and rear positions of the seats, adjust the backrest to a comfortable angle to ensure that the steering wheel can rotate freely, and the hood of the front of the car is the best. Adjust the left and right rearview mirrors so that the body in the mirror appears in the position of mirror 1 3 or so, and the rear door handle is exposed on the upper edge of the mirror.

First gear, with the front of the car, straight out of the warehouse. When the hood of the front is just over the sideline across the garage, hit the steering wheel to the right. Everyone is different, so find the right reference point according to your situation.

When the body is parallel to the left line of Huai Shouting Letter, straighten the steering wheel and continue to move forward, with the front of the car crossing the induction line. At this time, the distance between the body and the left line is exactly within the optimal distance to ensure that the rear storage does not roll the line. The time point of the previous right kill can be adjusted repeatedly to ensure that the body is within the optimal distance.

Reverse storage must go through cheats:1. Slow:

Be slow. Reversing into the warehouse must be controlled clutch seepage Zheng and slow down. The slower the speed, the better, so that in the event of a mistake, it can be adjusted in time.

2.Quasi-lead wheel is accurate: the point pointed to should be accurate.

It's best to hit the direction early, and remember not to hit late. Because you can set the direction by playing early, you can't set it when you play late, and you can directly press the sideline. 3.

Repair: Not all trainees will be able to reverse the car into storage, which requires the most critical skill, which is repair. Those that can fix the direction, such as reversing into the warehouse.

Millions of car purchase subsidies.

There are many reasons why the driving test subject 2 cannot be reversed, it may be that the starting position of the vehicle is too close to the sideline; It may also be that the body is not straightened and the tail is upturned; It may also be because the timing of the steering wheel is not well grasped and so on. In addition, different driving schools have different storage methods for different instructors and professors.

Driving test subject 2, also known as short circuit test, is a part of the motor vehicle driving license test, and is the abbreviation of the driving skills test subject of the closed bird calendar. Driving test subject 2: The specific reason for reversing into the warehouse:

1.The clutch control car search is not good: the test car is different from our usual training car, and the tightness of the clutch of different cars must be different.

Many students find it difficult to control the clutch after changing cars. In fact, the main reason is that students do not master the clutch well. When our clutch is too high and the speed is too fast, when we press the clutch a little, the speed will slow down.

2.The front and rear mirrors of the test are not adjusted: Many students start the test directly without adjusting the rearview mirror after getting on the bus, resulting in limited vision, wheel line pressure, and library angle pressure, resulting in failure to pass the test.

Candidates will need to adjust their seats before boarding the bus. Second, adjust the position of the left and right mirrors to ensure that the points they see through the mirrors are the same as the points they usually see when driving in a driving school.

3.Excessive exam stress: Exam stress is a common problem for everyone, but too much stress can affect the normal performance of students.

There's no need to put too much pressure on yourself.

Millions of car purchase subsidies.

One: Stabilize your mentality

It is normal to feel nervous before the exam, and students should learn to adjust their mentality so as not to bypass the nervous mentality and affect the operation of the exam.

Candidates can try to drink some sweeter drinks, take deep breaths, change their thinking, close their eyes and recall the operation process of emptying the warehouse several times.

2. Prediction.

In the vast majority of cases, when we find out that the inventory is about to fail, it is actually too late.

In this case, we must confirm that the action meets the requirements before starting the next action, for example: before the start of the test (before the fingerprint is entered) to confirm whether the body is left enough distance from the sideline, and whether the body is aligned. If you find a problem, you should correct it in time, and then enter your fingerprint and start the test.

Interim Remedies:

Various surprises may arise during the exam'Situation, if due to some factors make the body travel path deviate from your expectations, it must be corrected in a timely and fast manner.

Second, there are many reasons why the subject does not fail, such as the speed of the vehicle is too fast, the operation is not timely, the starting position of the vehicle is too close to the sideline, the body is not aligned, the seat rearview mirror is not adjusted properly, the closing difference rises, and the timing of the steering wheel is not right. When encountering these situations, students should learn to adjust their mentality and correct them in time.

The second subject, also known as the road test, is part of the motor vehicle driver's license test and is the abbreviation for the field driving skills test subject. The car C1C2 test items include reversing into the warehouse, side parking, fixed-point parking and ramp start, right-angle turning, curve driving. Among them, the skills of reversing into the warehouse are slow, accurate, and repaired

Reversing must be slow, the starting point must listen to the coach, and the direction will be hit when you reach the point. But now, because you can't give up halfway, you have to hit the direction earlier, don't hit again at the point, it's too late. When playing the direction, you should follow the principle of fast direction and slow speed, and do not stop after playing; Before you can finish playing the direction, you have to press the clutch to slow down.

A lot of beginners, once they get to the point, will hit the direction very quickly. That is, they patronize the direction of the shot, and the clutch of the left foot cannot be pressed. Not all students can get it right, and this requires the most critical skills:

Repair. The key to reversing is repair, as stopovers are now not allowed. When you arrive at your destination, you should take a sedan car early.

Remember that you can't call it in the future, because you can't get into the outer line of reservoir pressure if you don't repair it in the future.

Millions of car purchase subsidies.

There are several reasons for not entering the warehouse, it may be that the starting position of the vehicle is too close to the sideline; It may also be that the body is not straightened and the tail is upturned; It could also be because the timing of the steering wheel is not good or it is too tight.

Generally, when students arrive at the examination room, they will be nervous, which is a normal stuffy training. How to adjust: Don't think about success and failure in a daze, let go of your mentality, deal with it in a normal way, treat the test as a driving practice on the training ground, and show the results of your usual driving practice.

There are two opportunities, that is, Senjing's 50% success, and you don't feel terrible if you don't fail in training.

Some students change cars and have to clutch hard to control them, and they panic for a while. In fact, all manual transmission car clutches have several situations, namely high and low, light and heavy. Some students said that they stopped as soon as they stepped on the clutch and let go too quickly.

In fact, when you release the clutch, don't go too fast, but release it slowly. When the car moves, it cannot be released again because this is the best joint for the car. At this time, I feel that the car is too slow, and I can step on the clutch gently.

The clutch was released too quickly during the exam, and it was too fast for a while. The heart pressed to the end, and the car stopped. When the heart is released too fast, the speed is uncontrollable, the heart is too panicked, and all the movements are twisted and wrong.

You should know it's fast. It's hard to control the slowness of the hood because the car has inertia. If you can't control it for a while, you can use the brake to help you, and then use the brake to drive easily, and then slowly release.

Millions of car purchase subsidies.