-
The general reasons are as follows:
1. The sealing strip of the sunroof is not tightly sealed.
2. It is due to the loss of the dust cover on the underbody panel, resulting in the entry of water;
3. The door crack of the vehicle, the engine compartment and the cockpit are not tightly sealed, resulting in water entering;
4. The beading and melting groove of the glass, the sealing strip of the door is not tightly sealed or is aging and leaking.
Now you don't have to be too anxious, now you still go to the repair shop for an inspection and find a response from the steward. Then watch them repair. You can do a series of tests to see where the water is coming in.
For example, using water against the doors and chassis. Remove the seat and inspect the primer, etc.
Then you can do the chassis sealing. Prevent corrosion of vehicles.
-
The sunroof is a seal formed between the rubber strip on the outside of the glass and the roof, and it cannot achieve the effect of absolute sealing. Therefore, it is normal to have slight water seepage, in order to solve this problem, the manufacturer designed a drainage pipe in each of the two A-pillars in front of the design. So even if some water comes in, the skylight will flow out of the drain.
However, due to the fact that the vehicle is often parked, the sunroof position can not only enter water, but also some dust, so the blockage of the drain pipe is the biggest cause of sunroof leakage. Just unclogging the drain pipe of the skylight can solve such a problem.
-
Summary. There may be a variety of reasons for the water leakage on the left side of the BYD F3 in 09, and here are a few possible reasons:1
Rainwater leakage: Check whether the sealed parts such as doors, windows, and sunroofs are in good condition, if damaged or aged, rainwater leakage may occur. 2.
Air conditioning system problems: Check the air conditioning system for fluorine leakage and other problems, if there is fluorine leakage, it may also lead to water stains inside the vehicle. 3.
Aging of body sealant: Aging or damage to vehicle sealant can also lead to water leakage, and it is necessary to check whether the vehicle sealant is in good condition. 4.
Wiper system failure: Wiper system failure can also lead to water leakage, and it is necessary to check if the wiper system is working properly. Workaround:
5.Inspect the sealing parts such as doors, windows, and sunroofs, and replace them in time if they are damaged or aging.
There may be a variety of reasons for the water leakage on the left side of the BYD F3 in 09, and the following are several possible reasons for the closure of the high without the group: 1Rainwater leakage:
Check whether the dead orange spots in the seals of the doors, windows, sunroofs, etc. are in good condition, as damage or aging may lead to rainwater leakage. 2.Air conditioning system issues:
Check the air conditioning system for fluorine leakage and other problems, if there is a fluoride leakage, it can also cause water stains inside the vehicle. 3.Body sealant aging:
Aging or damage to the vehicle sealant can also lead to water leakage, and it is necessary to check that the vehicle sealant is in good condition. 4.Wiper system failure:
A faulty wiper system can also lead to water leakage, and it is necessary to check if the wiper system is working properly. Workaround:5
Inspect the sealing parts such as doors, windows, and sunroofs, and replace them in time if they are damaged or aging.
6.Check the air-conditioning system and repair it if fluorine leakage is found. 7
Inspect the vehicle sealant and replace it if it is found to be aged or damaged. 8.Check the wiper system, if it is found that it needs to be repaired in time.
If the above methods do not solve the problem, it is recommended that you go to a regular car repair station for inspection and repair.
-
Summary. Kiss <>
Expansion: The clutch pedal is the control device of the clutch assembly of the manual transmission car, and it is the human-computer interaction part of the car and the driver. In the normal driving of the car, it is one of the five major operating parts of car driving, and the frequency of use is very high.
Whether it is operated correctly or not directly affects the starting, shifting and reversing of the car.
What is the reason for the water leakage on the left side of the BYD F3 in 09.
09 BYD F3 left front clutch pedal under the leak what is the reason.
Hello, happy to answer your <>
In 09, the left side of BYD F3 leaked stuffy water, and the reason was that the water tank was leaking, and it was a leak of glass water and a cover macro kettle. The gasket around the exhaust pipe is damaged, resulting in a poor seal of the vehicle's exhaust pipe, which in turn leads to water leakage. The above is the answer to the reason for the water leakage on the left side of the BYD F3 in 09.
Kiss, it's the reason why the water tank is leaking.
Kiss <>
Expansion: The clutch pedal is the control device of the clutch assembly of the manual transmission car, and it is the human-computer interaction part of the car and the driver. In the learning car in the normal driving of the crack is one of the five major control parts of the car driving, the frequency of use is very high, for the sake of convenience, people directly called the clutch.
Whether its operation is correct or not directly affects the start and closing of the car, gear shift and reversing.
-
Reasons for water leakage under BYD cars: 1. The water tank is leaking or the glass kettle is leaking; 2. The sealing gasket around the exhaust pipe is damaged and the sail ring starts early, which leads to the poor sealing of the exhaust pipe of the vehicle, and then the phenomenon of water leakage.
Water leaks in the cab of a car are not a small problem because there are a lot of electronic devices and buttons in the cab, and the slightest mistake can cause a short circuit and damage the interior of the cab.
Causes of car cab leakage sunroof drain hole: sunroof drain hole is easily blocked by fallen leaves and spring hail dust, once blocked, when it rains, the rainwater can not be discharged in time and will seep into the car; Aging of the sealing rubber ring of the sunroof: the rubber parts will age and harden in the process of use, and after the aging of the rubber ring of the sunroof, the sealing will be reduced, and there will be water leakage on rainy days; And when the sunroof is maintained, directly washing with a high-pressure gun or using a strong acidic and alkaline cleaning agent will also deform and age the rubber ring of the sunroof; The drain hole of the air conditioner brand is blocked, and the evaporation box will produce condensate during the use of the vehicle air conditioner, and if the drain is blocked, the condensate will leak out from the co-pilot's position; Poor door sealing:
If the installation is incorrect or aging and hardening, the sealing of the door will be reduced, and the cab will be flooded when it rains or drives to a waterlogged area; Clogged drain holes in the door: Due to the low location of the drain holes in the doors, it is easy to be clogged by silt, and if the door is full of rainwater and cannot be discharged, it will seep into the cab.
Check whether the drainage holes of the sunroof, doors, and air conditioners are blocked, and if they are blocked, clean them up and drain the stagnant water; Check the sealing rubber rings and rubber strips of the sunroof and doors to see if there is deformation and aging, and if so, replace the rubber parts; If water accumulates under the co-pilot, you can take out the co-pilot's mat and floor glue and clean it with a special carpet cleaner for automobiles; Then suck out the water on the car, if the water is more serious, you can open the sealant plug at the lower part of the car chassis to release the water on the car; After the stagnant water is drained, clean and disinfect the car to prevent the car from producing peculiar smells and breeding bacteria; Then open the door and dry the wet area of the car.
Photo by Q&A) Model Y Model 3 Model X AION V Ideal One Xpeng P7 @2019
-
This is not able to be repaired.
du, which must be replaced in its entirety. As for the plugging dao processed on the cylinder block of the engine, it is generally oil plugging or water plugging, which has the installation method and sealant application requirements required by their respective manufacturers, or some are directly processed by the production line and formed at one time, which is not allowed to be maintained.
The vehicle cooling system is basically composed of a water pump, a water storage tank, a shut-off valve, and a water pipe. In the event of a leak, the maintenance department applies pressure to the cooling system with a special pressurizer, so that the unsealed parts can be immediately revealed, and the fault point can be quickly and accurately identified. Generally, the leakage of the water pipe is due to the loosening of the spring clamp or the decrease in the tire performance of the quick-plug adapter card, as well as the aging of its own rubber.
As for the water tank, it is usually traumatic or internal corroded trachoma. Finally, the water pump has a sealing ring and its own water seal between the cylinder body, and the sealing ring is mostly due to installation deviation or long aging, and the water seal is mostly in the abnormal operation of the water pump, resulting in excessive pressure and water seal pressure relief.
-
Hello, if the engine leaks, don't open it again, send it for repair, it is generally caused by broken seals, and if you want to open it again, the crankshaft will be burned to death
-
1 First of all, it's ,.. the exhaust pipe is rotten
2 Water leakage, so-called"water"Even if the exhaust gas condenses into a liquid state when it encounters the atmosphere with a temperature difference outside, it leaks out of the bad exhaust pipe.
3 In addition, there is also a powdery substance that has not been burned completely and will seep out of this leak.
4. Replace (repair) the exhaust pipe, and then check whether the vehicle engine is working properly, etc.
Good luck. Travel safely.
BYD F3 copied the Toyota Corolla from the appearance, the first few batches of models used Dongan Mitsubishi's 4G15S engine, after 2010 BYD's own all-aluminum engine. The vehicle assembly technology and workmanship are still relatively rough. After all, the F3 standard model is only more than 50,000. >>>More
BYD's external dimensions and price are slightly better, do you fancy Yuexiang, Yuexiang is not the same, in fact, Geely Emgrand EC7 series is good, it is different from Geely's high-end brand, with high configuration and good quality
1. Check the air conditioning filter, the air conditioning filter is too dirty, which will lead to a small air volume of the air conditioner and increase the air pollution in the car. >>>More
The following is the latest price of the full range of BYD F3 models in 09: >>>More
Calculation Evaluation Method:
1. The current market value price = the naked price of the new car at that time (1-15%) 1-15%) That is, it decreases by about 15% every year, and it is multiplied by how many (1-15%) in a few years. >>>More