What s going on with the Kia K2 heater in one gear?

If the blower has only one gear, it can be determined that the blower resistance is damaged. First of all, consider that the blower motor is energized. That's why there is a gear to work.

The speed adjustment of the blower is mainly completed by the resistance of the blower, that is, the resistance of different resistance values is connected in series in the blower line, so that the current supplied to the blower will change, and the speed of the blower will be changed. If the blower resistor fails, only one of the direct conduction positions will work. The resistor loses the function of adjusting the speed of the blower.

Therefore, it is recommended to carefully check or test the blower resistance or use the replacement elimination method to test the fault of the blower resistance.

The Kia K2 heater you said is in good gear, there should be something blocked, or something stuck, the air outlet is best to go to the repair shop to check the air conditioning wiring, and the air conditioning pipe, now the weather is starting to heat up, no air conditioning, it's really uncomfortable.

Possible Causes:

It should be the fan resistance.

Wind turbine resistance connectors.

Faulty switch and fan resistor lines.

Explain your gear problem. If you need to repair it urgently, hurry up to the four-S store and let someone check it for you, safety is the most important.

Check the air conditioner flap for cassette.

Faulty air conditioner outlet.

There are several reasons why the Kia K2 warm air is adjusted to **, and the air is out:

1. The heating pipe is blocked; There may be dust or other debris in the heating ducts, which can cause the airflow to be blocked and dissipated, and the air cannot be properly discharged. It is advisable to clean the heating ducts regularly, especially before the winter season.

2. The valve of the warm air outlet is damaged; The valve or valve at the outlet of the heater is damaged or malfunctioning, resulting in the airflow cannot be opened or adjusted normally. It is advisable to go to a professional car repair station for repair or replacement.

3. Failure of the heating air temperature control system; The heater temperature control system may malfunction, resulting in the temperature not being properly regulated. It is advisable to go to a professional car repair site for inspection and repair.

4. Air conditioning system problems; If the vehicle is equipped with an air conditioning system, it may be caused by a problem with the air conditioning system. It is advisable to go to a professional car repair site for inspection and repair.

The Kia K2 is a model of Dongfeng Yueda, which was launched during the 2011 Shanghai International Auto Show and was officially launched in July 2011, forming the K series together with the K5 launched in March 2011 to compete in the domestic market.

Summary. Hello, I am your exclusive technician, attentive, careful, dedicated to answering your car questions, for you to find the corresponding problem solutions and solutions! The reason is the lack of refrigerant in air conditioning.

1.If the air conditioner lacks refrigerant, hot air will come out when the engine speed is low, and then cold air will come out after running. 2.

Check the pressure in the air conditioning duct with a pressure gauge first. If the pressure is low, add refrigerant first.

Hello, I am your exclusive technical brightener, attentive, careful, dedicated to answering your car questions, for you to find the corresponding problem solutions and solutions! The reason is the lack of refrigerant in air conditioning. 1.

If the air conditioner lacks refrigerant, hot air will come out when the engine speed is low, and then cold air will come out after running. 2.Check the pressure in the air conditioning duct with a pressure gauge first.

If the pressure is low, add the grinding and closing agent first.

Refrigeration is no problem, you can see that the cold and warm air motor itself is quietly moving in a small crack, and when the action is large, it will be converted into a potato source to resist the hot air, and it will be converted back to cold air after a while.

Yes, there is a problem with the motor.

It can't be that there is a problem controlling the computer, right?

Generally, it is the problem of the motor, and the teeth in the motor are slipping.

Ok thanks.

Isn't it powered when the knob is operated, but now it's equal to the motor's constant power supply.

When operating the knob. Only then will the motor have electricity. But if you talk about the potato sail with a large motor slippery in the hand. With a little more force, the motor will run vertically. Because the flap has a certain weight. If there is a problem with the control panel, the motor will not rotate repeatedly.

The reason why the car heater is not hot: it may be caused by the engine cooling system; It can also be caused by the poor working of the heating control mechanism. When repairing, first determine which cause is caused, and then carry out corresponding maintenance.

The method of identification is very simple: look at the temperature of the two inlet pipes of the small water tank of the warm air, if the two pipes are hot enough, it means that the air volume control mechanism is a problem; On the contrary, if both water pipes are cold, or one is hot and the other is cold, it means that there is a problem with the cooling system.

Problems that can arise with the cooling system are:

1. Thermostat.

The normally open or thermostat stool is turned on too early, so that the cooling system is prematurely circulated, and the outside temperature is very low, especially when the car is running, the cold air quickly puts the antifreeze.

Cooling, the engine water temperature will not rise, and the heater will not be hot.

2. The impeller of the water pump is damaged or lost, so that the flow through the small water tank of Zaosui warm air is not enough, and the heat cannot come up.

3. There is air resistance in the engine cooling system, which leads to poor circulation of the cooling balance system, resulting in high water temperature and unheated heat. If there is always gas in the cooling system, it is likely that the cylinder head gasket is damaged and the gas is flowing into the cooling system; If the inlet pipe of the warm air small water tank is very hot and the water outlet pipe is cold, this situation should be that the warm air small water tank is blocked, and the warm air small water tank should be replaced.

The troubleshooting steps for the car heater is not hot are as follows:

1) The speed of the blower is slow or not, and the blower motor should be checked to see if the speed control resistance is damaged, and if so, it should be repaired or replaced.

2) The waterway is blocked: the dredge water pipe should be checked, and the radiator should be replaced if necessary.

3) The connection of the water pipe joint falls off or the water valve fails: connect the falling off pipe mouth and replace the failed water valve.

4) The temperature damper cannot return normally: adjust the temperature damper according to the regulations, and replace new parts if necessary to make the temperature damper return normally.

Hello, the warm width of the car is not hot, and the warm air tank is generally blocked, or it is due to the lack of water in the engine.

I hope the subject and netizens are grateful.

The Kia K3 has a warm air behind the low configuration, and the Dongfeng Kia K3 manual air conditioner can use the temperature control knob to adjust the temperature of the airflow flowing through the ventilation system. To change the indoor air temperature, turn the knob to the right to get warmer and hotter air, and to the left to get cooler air.

The automatic air conditioner temperature adjustment method is to turn the temperature control knob clockwise to the right limit, which can gradually increase the temperature until the maximum (HI) temperature. Turn the temperature control knob counterclockwise to the left limit to gradually decrease the temperature to the lowest (LO) temperature. When you turn the temperature control knob, the temperature rises or decreases in units.

When set to the lowest temperature setting, the air conditioner will work continuously.

The exterior styling of the new generation K3 is more sporty and aggressive than the old model, and the overall shape and line outline of the body are very sporty. The front face of K3 adopts the front face of the Kia family's tiger roar, and the large-size waterfall front grille is decorated with a large number of chrome elements, with a through-type front envelope design, which makes the front face of the vehicle more recognizable and highly recognizable. The body size is mm and the wheelbase is 2700mm.

The tail design is more rounded and fashionable, and the taillights adopt a through-type design, which not only stretches the visual width of the body, but also makes the tail shape fuller.

Photo by Pacific Automobile Network Q&A).