The ASUS S56C computer does not detect the SSD 10 after reinstallation

SSD: 1With flash storage, the read speed is faster than that of ordinary mechanical hard disks, and there are no problems such as magnetic heads.

2.In fact, for the use of SSDs, brands.

It doesn't matter which one is the same, as long as the quality is good. Because the warranty of SSDs is very bad.

3.The system is best installed in a solid state, and other large-capacity data is best placed in a hard disk. Because SSDs and USB flash drive storage media are both self-proclaimed by chips. The lifespan is determined by the number of uses, which is about 120G SSD.

The service life is about 20 years. Flash is not recommended for storing large amounts of data. It will reduce the service life, that is, the brand will waste life times when reading and writing.

4.Although it is shockproof and fall-resistant, it is also a loss if it really falls to the point, so be careful.

5.During use, there will be no working sound of mechanical hard disk, it is relatively quiet, and it does not consume as much power as mechanical hard disk, and the working temperature of the hard disk chip is normal at -40-85 degrees.

About interfaces: divided into: SATA serial port (and, PCI-E, LIF, msata, cfast

Wait. 4k Alignment:

Condition: Supports SSDs in Advanced Format (2011 onwards).

alignment: When you install and run, you can see that the green color proves that it is aligned, the yellow one does not have it to be aligned, and the red one means that the disk does not support and cannot be aligned. Or a hard drive detection tool. asssd

benbhmark

You can see the prompt after installation, as above.

2.For the new disk, during the win7 installation, the formatting tool will format it, so that the partition will directly start 4K alignment, if the partition has a system partition, you must select the main disk partition, and choose the size of the partition you want, not too small.

3.The hard disk that has been used, on the premise of not destroying the data in the hard disk. You can also try.

If you have any questions, you can ask them, I hope it can help you.

Hopefully, there are a lot of supported software on the Internet, you can also try it

Have you seen it in Disk Management, it is possible that the SSD has been deleted and there is no partition, and it will not be displayed.

If it is not detected at all, then it is a bad contact, open the opening in the lower right corner behind the computer, and reinstall the SSD there.

If you configure the SSD yourself, the files required in the above link are currently provided by ASUS 400 customer service, and cannot be provided here, please forgive me! You can call 400, 600-6655 and ask the customer service staff for it.

Or call ASUS Customer Service**400, 600, 6655 to consult with an engineer and help you solve the problem!

Hello! 1. The SSD configuration of S56CB is optional, that is, the batch is different, some models may be available, and some are not configured.

2. On the desktop, computer icon, right-click, manage, disk management, see if there is any situation as shown in the figure below, if there is, the machine is configured with SSD. If there is an SSD configuration, the machine is pre-installed with a high-loss yuan genuine system that is set up and does not need to be configured separately. If there is an SSD, if the SSD is not configured, it is displayed in black, and the configuration is two partitions in blue, one is about 4G and the other is about 18G.

3, According to your description, the boot time is also in the normal range. You can check whether the machine has an SSD configured, and if there is an SSD, you can refer to the link How to Configure an SSD. The required documents can be obtained by contacting ASUS Passenger Carrier 400, 600-6655.