Lavida can change the engine oil by itself, where to buy the engine oil?

Step 1: Run the ** motor to bring it to the working temperature. Then use a jack to jack up the vehicle, pull up the hand brake and squeeze the front wheels up with a wooden wedge.

Check the drain bolts, reinstall the drain bolts, and be careful not to tighten the bolts too tightly to prevent damage to the oil pan.

Step 3: Move the oil container under the oil filter, use the oil filter wrench to loosen the filter and unscrew it by hand. If the filter is still hot, remember to wear gloves.

Don't worry about the filter being tightened and damaging it during removal. As long as you don't damage the connection screws on which the filter is installed and the parts around the filter, you'll be fine.

Step 4: Refer to the user manual to select the appropriate oil filter.

Step 5: Apply the interface gasket of the new filter cartridge with new oil. If the filter is installed vertically, you can pour some fresh oil into the filter, which will reduce dry grinding the next time the engine starts.

Screw the filter in by hand and tighten the filter as indicated (usually after tightening the filter by hand and then screwing it in 3 or 4 turns).

Step 6: Next, add the new oil to the oil pan, refer to the user's manual. A funnel can be used to prevent oil from being poured on the outside of the engine.

Check the lower part of the engine for leaks. If there are no leaks, put down the vehicle, check the dipstick, and start the engine. The indicator light on the meter should turn off immediately after starting.

Finally, turn off the engine and repeat the oil level. Dispose of used oil and filters according to local regulations. If you need to buy engine oil, you can go to Yutu to see, ** there is a guarantee.

The German GT Magic Red that I often buy is a small number of PAO engine oil that is not produced in China, and the goods are all imported from the original bottle, and the import code and anti-counterfeiting code can be checked, and this kind of engine oil can be used with care. Door-to-door maintenance is only a man-hour fee, not much.

Add 4L of oil.

The amount of oil filled should be slightly lower than the standard scale. Excessive over-the-top oil (exceeding the upper limit of the scale) will have the opposite effect. Too much oil will increase the rotational resistance of the crankshaft, reduce the output power of the engine, and the excess oil will enter the combustion chamber to participate in combustion, causing the vehicle to burn oil, blue smoke, and increase fuel consumption.

When choosing engine oil, it is necessary to strictly follow the car instruction manual to let the oil use grade selected, if there is no same level of engine oil, you can use a higher level of engine oil, but never use a lower grade instead.

Lavida manual oil model is different displacement, Lavida and Lavida use different engine oil, Lavida is suitable for SJ grade model 5W40 mineral engine oil, while Lavida uses SL grade model 5W40 semi-synthetic engine oil, all of which are 4L. The 4S uses Volkswagen original engine oil by default, of course, car owners can also choose Shell, Castrol, Mobil, Great Wall and other brands according to their needs.

Lavida is practical and does not need to change the fully synthetic engine oil, generally semi-synthetic is enough, if the sound is loud, you should go to the maintenance to let the 4S shop look at it, road test, is it to wash the throttle, I used to change the sound after the change, and then the throttle was washed down, but you should not have many kilometers, or check it.

The manufacturer's recommended engine oil is 5w-40.

As for the brand, Shanghai Volkswagen has a variety of original engine oils manufactured by a number of engine oil manufacturers such as Kunlun, Valvoline, Castrol, Mobil and Shell. As long as the model is right, the original mineral oil and semi-synthetic for self-priming vehicles can be used, and there is no need to use fully synthetic. Don't worry about the money of turbocharged cars, just change them to semi-synthetic and fully synthetic ones.

Don't treat the car as a grandfather, it is enough to use ordinary Volkswagen engine oil. It's not a super luxury car.

The car is suitable for fully synthetic engine oil, the performance of fully synthetic engine oil is very good, the fluidity is excellent, whether it is a cold start in winter or a high temperature resistance in summer, and the oil change interval is long, which can protect the engine to the greatest extent.

If you are a normal turbocharged car, then using the original engine oil is enough. However, because the working speed of the turbocharger is too high, any ball bearing can not withstand the strength of 100,000 revolutions per minute, so the main shaft is not connected by the ball bearing and the turbine body, but adopts a floating design, the main shaft is floating in the oil, and the extremely narrow space between the turbine body and the main shaft is filled with flowing oil, which not only plays the role of lubrication, but also can take away impurities between the main shaft and the turbine and play a role in heat dissipation. At this time, there will be a problem of oil burning, that is, the turbine damage mentioned earlier.

Fully synthetic engine oil is relatively rare, with better lubrication and heat dissipation, and when the turbine speed is increased, this thinner oil can flow 100% to the lubricated area, so there are no problems mentioned above.

The role of motor oil:

The engine is the heart of the car, and there are many metal surfaces in the engine that rub against each other, and these parts move fast, the environment is poor, and the operating temperature can reach 400°C to 600°C. Under such harsh working conditions, only qualified lubricating oil can reduce the wear of engine parts and prolong the service life, so what requirements should qualified lubricating oil meet? In other words, what are the six functions of lubricating oil?

1. Lubrication and wear reduction: between the piston and the cylinder, between the spindle and the bearing, there is a fast relative sliding, to prevent the parts from wearing too quickly, it is necessary to establish an oil film between the two sliding surfaces. An oil film of sufficient thickness separates the surface of the relatively sliding part to reduce wear.

2. Cooling and cooling: The oil can bring the heat back to the oil tank and then dissipate it into the air to help the water tank cool the engine.

3. Cleaning and cleaning: good engine oil can bring carbide, sludge and wear metal particles on the engine parts back to the oil tank through circulation, and wash the dirt generated on the working surface of the parts through the flow of lubricating oil.

4. Sealing and leak-proof: The oil can form a sealing ring between the piston ring and the piston to reduce gas leakage and prevent external pollutants from entering.

5. Anti-rust and anti-corrosion: lubricating oil can be absorbed on the surface of parts to prevent water, air, acidic substances and harmful gases from contacting parts.

6. Shock absorption and buffering: when the pressure of the engine cylinder port rises sharply, the load on the piston, piston chips, connecting rod and crankshaft bearing is suddenly aggravated, and the load is transmitted and lubricated by the bearing, so that the impact load bears plays a buffering role.

1. Add 4L engine oil, which is exactly the amount of a whole barrel of 4L engine oil.

2. It is best to change the oil more thoroughly every 5500km, and clear the oil filter every 90 million km. Only regular oil changes and regular cleaning of the filter can avoid wear of parts and clogging of the oil circuit.

3. There will be great wear and tear under the condition of attrition driving. In order to better protect your car, it is best to shorten the oil change cycle and choose a good oil to make the car more durable and powerful.

Generally, it is the 4L package sold on the market, and it is generally incomplete. There will be a little leftover.

It depends on the normal displacement.

There are specific steps for changing the oil of various car products on the Yutu network, and the Yutu network is a trustworthy one.

Volkswagen Lavida uses 5W30 semi-synthetic engine oil, which plays a role in lubricating and reducing friction, auxiliary cooling and cooling, sealing and leakage, rust and corrosion, shock absorption and cushioning for the engine.

Question: Can Volkswagen Lavida add shell engine oil?

Shell motor oil is also available.

Change the oil, the oil grid, the air grid, and the air conditioning grid.

5w-40 viscosity oil, as long as it is guaranteed to be true. At home, if you don't drive much. If it is mineral oil, it will be 5000 kilometers, and it will be replaced within half a year (whichever comes first).

Question: 16 displacements.

Question: I've been using the 5w-40.

Friends of the Northeast.

Question right, Northeastern.

Question: Okay, next time change the oil by 30.

If the run-in period has passed, it is recommended to change the oil at the time of the first warranty, you can go to Yutu.com to see, there are many qualities, and the quality is ***.

Hello, I suggest changing the synthetic engine oil I hope my answer can help you I wish you a quick solution to the problem Happy with the car!! [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Hello, Castrol oil, ** at least need Golden Care. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Hello, this car personally recommends that you use fully synthetic engine oil, like Mobil One Castrol Magnetic, which is almost very good.

Thank you for using, I hope my answer can help you, if it can help you it would be great, if there is anything you don't understand or don't understand, you can continue to ask, I will definitely try my best to serve you! [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】