What is the difference between receiving and placing in the component interface in Creo?

There is a difference between receiving and placing in the original meeting 1, because the transmitting signal of the receiving device is not the same as the transmitting signal in the placing area.

The main difference between receiving and placing the original interface in Creo is the processing of the signal, whether the signal is sent or received, and the parameters are modified.

Click "Auto" in the figure above, then select the central axis in Figure 4 below, select "Coincident" for "Constraint Type", and click "New Constraint" when finished;

Create Component in Assembly Mode allows designers to create components directly from the assembly interface. During product development, the shape, position, and other parameters of some components depend on other components in the assembly, and it can be troublesome to create these components directly in part mode.

Here we take shafts and bearings as examples. We know the diameter of the bore of the bearing, and now we want to create a shaft to fit with it (base bore system).

When it is received, it is mainly converted into an electrical signal, and when it is placed, it is basically an electronic signal that does not move.

The default should be smart selection, that is, the software automatically determines the target the user wants to select based on the position of the mouse...

Only when the object you select is clear and the intelligent selection gives too many targets, you can adjust it to select other targets...

What is the difference between seeing the heart in the middle that is suffering and does not give up? It certainly doesn't make much difference.

But the reception will certainly be more convenient, and the placement also needs to have some requirements.

Another kind of software is what is the difference between technical control, this difference is not too big, I will leave some news on the Internet, or look at the physical store to understand.

Who can meet and always accept and what is the difference between place? What is the difference between accepting an original document that can be accepted directly inside?

The operating system needs hardware support, and other system software needs to be supported by the operating system, and the user is only a permission, which only exists in the software or system.