How many work carts should be allocated to 50 rooms?

It should be equipped with about three taels of four taels of work, and the car is completely sufficient, but your personnel must keep up, otherwise it will have no effect.

If you have 50 rooms, three work cars are usually enough.

A minimum of three work carts should be installed in 50 rooms, so that it is more convenient to work.

A minimum of 50 rooms should be allocated. Five work bikes should be enough, and if it doesn't feel like it's enough, two more are pretty much the same.

If there are 50 rooms, you need to have at least 5 work trucks, because in this way, everyone basically effectively ensures its normal operation efficiency.

50 rooms should be equipped with about 5 cars, because if there are 5 work cars, basically 10 people can be seated in each car.

50 rooms should be equipped with several work cars, should be equipped with five buses, should be equipped with five work vehicles.

50 rooms should be equipped with several work cars, one refers to the pick-up and drop-off, or refers to the cleaning car to be used at work, if it is a work pick-up and drop-off, it should be 3 degrees enough, if it is a work car, then about six can be.

If you want to equip this kind of room with a work car, at least it must be matched. 10 cars can be used.

50 rooms with 3 to 4 work vehicles.

How many taels of work cars should be equipped with the 50 rooms you are talking about? Is it the kind of work car which cleans in the hotel? Generally speaking, there are three or four to five cars. The staff can be diligent.

Ignoring the view, you may have to pay a few buses, in which case you have to drive uh, 50 pounds. in, because the work to be assigned is wrong, well, there is. There are ten, ten or so will do.

According to the seats of the car, generally speaking, it is about 35% full.

There should be a few work cars for 50 rooms, and if there are 50 rooms, I should have at least 10 cars.

It depends on the long-term occupancy rate, which is based on the occupancy rate to allocate work vehicles.

50 rooms should be equipped with this work car, you can look at the arrangement of one of his seats in this work car, the number of seats to arrange, in fact, this is the most reasonable.

This depends on how many workers you have.

Or how many people and warehouses do you have?

to make specific arrangements.

How many cars should be equipped for 50 rooms, and at least three cars should be equipped from here, right?

The guest room should be equipped with a few tickets, if you take the car, this may be said, sometimes there are, then the choice may be different, so this is not necessarily.

Guess for yourself how many people you have in a work car?

50 rooms should be equipped with a few work vehicles, this depends on the number of customers you have and the cost of everything.

Hello, if the vehicle is shaking, in this case, it is recommended that you go to the 4S store for inspection. Hope mine is helpful to you.

Landlord, let me ask you a few questions: 1, three trapezoids a, b, c, their height ratio is 1:2:

3. The ratio of the bottom is 12:15:10, and the ratio of the top and bottom is 6:

9；4. It is known that the area of trapezoidal A is 60 square centimeters, and the sum of the areas of b, c, and two trapezoids is found.

2. Table 1: Basic salary: 650, bonus:

800, allowance, 750, salary payable: 2650, housing provident fund; 265, Withholding Tax: 80, Pension Insurance:

212, Actual Total: 2093, Table 2: Basic Salary:

720, bonus: 800, allowance, 780, salary payable: 2750, housing provident fund; 275, Withholding Tax:

90, endowment insurance: 220, total actual issuance: 2165, the housing provident fund paid by Li Liang in Table 2 remains unchanged, and the unit pays the same amount of housing provident fund for it, so how much does Li Liang pay for the housing provident fund in a year?

Looking at Table 2, if Li Liang's monthly pension insurance remains unchanged, and the unit pays one-half of the individual contribution for him, how much pension insurance did Li Liang pay in 2007?

3q, I know you have the answer, do me a favor.

X cars were used for 40 seats, and Y cars were used for 50 seats.

40x＋10＝50y－10

i.e. y (4x 2) 5

And 45 6 270, 50 6 300

270 4 x 10 300, i.e. 6 x 7, x 7 y 6 The total number of people is 40 6 10 290.

290 people The 6 classes are all between 45 and 50, which means that the total number of students is between 270 300!

40 passenger cars several, 10 people have no seats, if you rent a 50-seat bus, empty 10 seats, this number must be an integer multiple of 10, so there are only 280, 290 two numbers, after verification to get 290

Method 1 First of all, the total number of students in the six classes is the smallest: 45 6 270, the maximum; 50 6 300, i.e. between 270 300.

Multiples of 40 meet this condition only 7, and multiples of 50 meet this condition only 6.

40 7 10 290 (person).

50 6 10 290 (person).

A: 290 people participated in the event.

Method 2 After the small car is replaced by a large car, each car can take more: 50-40 10 (people) so at least one car should be reduced, and the original 40 people who took it and the original 10 people who did not have seats, totaling 50 people, are allocated to other cars, 10 people per car, and several cars are needed: (40 + 10) 10 5 (cars).

There is also a car that is still 40 people, i.e. 10 seats empty.

So, the total number of people is: 50 5 40 290 (people).

Where did the squad leader go, and he wants you to lead the team?

Four or five, in the end?

Usually the training is done in vain, I don't know what to do? Expel.

Captain Stove Shelter:

220 meters. When needed, the training room:

6 minutes in Hidden Central State.

Set: It takes x hours to catch up.

40（2+x）=50x

80+40x=50x

80=50x-40x

80=10x

x = 8 (hours).

A: It takes 8 hours to catch up.

Suppose it takes x hours to catch up, column equation:

50x=40x（2+x）

50x=80+40x

10x=80

x = 8 (hours).

The car run-in period is not only the run-in between you and your car, but also the run-in between the various contact friction parts of the vehicle. Due to the progress of modern automobile manufacturing technology, the run-in process of new cars is also greatly shortened, and you only need to run 1000 kilometers "carefully", and your car can be fully fired.

So in the more than 1,000 kilometers before the new car is running-in, how to drive to extend the life of your car?

1.Do not brake suddenly:

Emergency braking not only impacts the braking system during the break-in, but also increases the shock load on the chassis and engine. Therefore, Xiaohuniu suggests that it is best not to brake urgently within 300 kilometers of the initial drive.

2.Do not overload:

If the new car starts to run at full load during the run-in period, it will cause damage to the parts. Therefore, within the first 1000 kilometers, the general load capacity should not exceed 75%-80% of the rated load.

3.Try to run as little as possible:

If the new car starts to run long distances during the run-in period, the continuous working time of the engine will increase, which is easy to cause wear and tear of the parts.

4.Don't drive at high speed:

Novices take a new car on the road, be sure to ask for stability, don't drag race with old drivers! In fact, this is because there is also a speed limit during the run-in period of the new car, and the domestic car is generally within 40-70 kilometers per hour, and the imported car is generally within 100 kilometers per hour. When the throttle is fully open, the speed of the vehicle should not exceed 80% of the top speed, and pay attention to the engine tachometer and speedometer while driving to ensure that it works at medium speed.

Under normal circumstances, the engine speed should be 2000-4000 rpm during the run-in period. If you think these numbers are too difficult to remember, then you can safely open 60 yards, and it will definitely be no problem

1.Warm up at the beginning.

For cold starts, it is best to wait for the water temperature to preheat above 40 before starting. When starting, you should gently press the clutch and accelerator pedal, and choose a good road surface. Don't hit the accelerator when it's cool.

2.The speed needs to be controlled.

The car in the run-in period must control the speed of driving, not too high, and the speed is best controlled at 50 80 kilometers per hour. Do not exceed 100

After driving for 1500 kilometers, the speed and speed can be gradually increased to the maximum speed allowed by the vehicle, and do not press the accelerator hard to ensure that the piston, cylinder and some other important components increase the load in a moderate state.

3.Gear changes frequently.

Don't use one gear for a long time, start in low gear, gradually change to high gear, and drive gradually. The phenomenon of low gear and high speed, high gear and low speed must be avoided.

4.Brake disengagement.

When braking the vehicle in the run-in period, it is necessary to step on the clutch pedal first, so that the gear mesh is released before pressing the brake pedal. This can reduce the impact damage of the engine, braking system and chassis of the new car. However, this method of "leaving first and braking later" is not in line with the driving norms, and it is limited to vehicles that are in the run-in period.

After the run-in period, from the clutch maintenance, we should still "brake before leaving". We've also heard a lot of novices always put their feet on the clutch at the beginning of driving and put the pedal down before braking. Some people also keep their feet off the board for the convenience of shifting gears.

It is true that for novices, driving this way can make the car drive more smoothly, but the wear and tear on the clutch is not small.

When you run in about 6000 kilometers, remember to go to the 4S shop to change the oil (it should be free), a total of about 7000 kilometers of running-in, I wish you and your car well!!

The run-in mileage of a new car is generally 3,000 km to 5,000 km. Liu Haibing, service manager of BMW Nanjing Yubao 4S store, said that although some high-end models no longer have a run-in period in the strict sense, car owners still have to pay attention to a few points after getting a new car.

When the new car is used, there is no strict requirement for the run-in period of the model, the engine speed should not exceed 3000 rpm, and the general speed of the low-end model should not exceed 100km h according to the standards of each manufacturer. Like BMW series models, generally speaking, when the engine speed is 3000 rpm, the speed can generally reach more than 150 kilometers per hour, so there is no high requirement for the speed limit of the model.

In addition, when it comes to the first warranty, the new car needs to change the engine oil once. Under normal circumstances, low-end model manufacturers generally stipulate that the oil needs to be changed for about 3000 kilometers, and high-end model manufacturers stipulate that the first maintenance should be done at about 8000 kilometers. In the use of new cars, due to the new parts in the operation of the gap may become slightly larger, resulting in screws and other fasteners may be loose, if there is an abnormal noise, or the owner feels uncomfortable in the control of the vehicle during driving, to go to the 4S shop in time to check.

What's more worth mentioning is that the new car you just bought, don't easily choose some parts from the market, if you want to install it, you should also choose the 4S store to recognize its installation capacity. Because the general maintenance of the new car is free of charge during the warranty period, if the problem caused by the owner's private installation of the vehicle in use, the manufacturer may not be responsible, and the 4S store will assume the responsibility for the installation in the installation shop recognized by the 4S store. Therefore, during the warranty period, if the owner strongly needs to install new parts, it is recommended to choose the 4S shop where the car is bought to install it more appropriately, so as to avoid disputes when repairing the car in the future.

What problems need to be paid attention to during the run-in period of a new car?

What are the precautions for a new car?

What should I pay attention to during the run-in period when I just bought a new car? Newbies get to know it.

It is the process of the new engine, in the mileage of about 3,000 kilometers, the performance of the new engine has not reached the best state, there needs to be a certain run-in, during this period try not to make the engine run at high speed and large load, generally do not let the engine speed exceed 3000 rpm, so that the engine can smoothly transition to the best performance.

1.The speed of the vehicle does not exceed 85kmh!

2.Don't rev and shift too fast!

3.Gasoline can be used better!

4.Don't use the car for too long every day!

5.The load should not be too large, so as not to overweight the engine power compared to the new car! 6.In short, you should take care of the beginning point, and all aspects of the car will remain good after the run-in period!

There will also be metal blanks in the fine manufacturing of the car, and the so-called running-in is to use all parts of the car to achieve smoothness and smoothness. So to"Light"

The start should be light, the acceleration should be light, the load should be light, the speed should be slow, in short, it should be carefully cared for.

Then, according to the instructions of the manual, change the oil and oil filter regularly, as well as the transmission and rear axle oil, and it is best not to lend the car to other people to drive during this period.