The mouse is in a very abnormal state, always busy 40

What is the configuration of the computer?,If the configuration is too low.,Run Vista definitely card.。

This configuration is okay, I guess your driver is not installed correctly.

It's a Trojan horse, try it with a "Trojan Killer" and then check whether your antivirus software is updated.

Or you enter safe mode to see if there is still such a situation, if not, it means that your computer is indeed poisoned or trojan horse, etc.

There are too many add-ins xp run at the next point Enter msconfig Configure add-ins Vista has not used it I don't know the heterogeneity.

There is a program running. Presumably poisoned. Or maybe it's just too many add-ons.

This is a specific manifestation of the slow system, it should be a virus, and you should be fine if you kill the virus.

1 Probably poisoned, Trojan horse.

2 Rogue software.

3 Adware.

4 Systemic problems, sluggish response.

Recommended: 360 Malware Cleaner Helper Windows Cleaner 3 Software Use to Ensure OK

The possible causes of sudden mouse failure are: mouse problems, drive problems, and power supply problems.

The sudden failure of the mouse may also be caused by the following problems:

1. Whether the socket between the mouse and the motherboard is firmly plugged in. First of all, you can check whether the socket between the mouse and the motherboard is firmly inserted, and whether the pin of the plug has been damaged. You can use the substitution method, that is, plug a normal mouse into your own computer, restart the computer, if it still doesn't move, it may be that the PS 2 port of the motherboard is broken.

2.The mouse has a conflict with a piece of software. If you think about when this phenomenon occurred, what software was installed at that time, if you can't find out, please reinstall the system.

3.There is too much software loaded on boot. There is too much software loaded at boot and the boot is slow, resulting in the mouse cannot move, and the boot add-on can be cleaned up.

4.To update the mouse driver, first open the Device Manager according to the above method, open the Mouse Driver tab, click Driver Update, and press the operation in turn.

It is recommended to check whether there is a problem with the welding of the mouse cable interface and the electrical board in the mouse.

The mouse is broken, or the interface behind it is not in good contact.

The serial port is abnormal or the LED is not aligned with the mirror inside.

It is possible that the mouse is in poor contact with the host.

1. If the mouse plug is not in good contact, it is recommended to carefully check whether there is any foreign object at the interface.

3. Some hardware interfaces are not easy to identify, and it is normal to restart to connect to them. It's also about the configuration of the computer.

4. It may be that the parts in the mouse are broken, you can try whether other mice can be used normally on your computer to determine whether it is an interface or a mouse.

5. There may be a problem with the driver of the stupid mouse, but try to restart the computer.

1. If the mouse plug is not in good contact, it is recommended to carefully check whether there is any foreign object at the interface.

3. There are some hardware interfaces that are not easy to identify, and it is normal to sell Tongsheng to restart to connect to it. It's also about the configuration of the computer.

4. It may be that the parts in the mouse are broken, you can try whether other mice can be used normally on your computer to determine whether it is an interface or a mouse.

5. There may be a problem with the driver of the mouse, but try to restart the computer.