Do I need to alternate between distance and distance lights when meeting a motor vehicle at night?

When meeting a motor vehicle at night, passing through sharp curves, slopes, arched bridges, pedestrian crossings, or without traffic lights.

Controlled intersections need to use alternating distance and low beams, and switch to low beams when meeting vehicles on roads without a center separation facility or center line. According to the Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China: Article 48 On roads without central isolation facilities or without central lines, motor vehicles shall comply with the following provisions when encountering vehicles coming from opposite directions:

1) Slow down and drive on the right, and keep the necessary safety distance from other vehicles and pedestrians; (2) In the road section with obstacles, the barrier-free party shall go first; However, when the obstacle has entered the obstacle section and the barrier-free party has not entered, the obstacle shall go first; (3) On a narrow slope, the uphill side goes first; However, when the downhill side has reached the middle of the slope and the uphill side has not gone uphill, the downhill side goes first; (4) On narrow mountain roads, the side that does not rely on the mountain goes first; (5) At night, vehicles should be 150 meters away from the opposite direction of the vehicle to use low beams, narrow roads, narrow bridges and non-motorized vehicles.

Low beams should be used when meeting cars. Article 59 When a motor vehicle passes through a sharp bend, slope, arch bridge, pedestrian crossing or an intersection without traffic signal control at night, it shall alternately use high and low beams to indicate it. When a motor vehicle approaches a sharp bend, the top of a ramp and other road sections that affect the safe visual distance, as well as overtaking or encountering an emergency, it shall slow down and sound its horn to signal.

Extended InformationThe Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China stipulate that Article 58 When a motor vehicle is driving at night without street lights, poor lighting, or in low visibility conditions such as fog, rain, snow, dust, and hail, it shall turn on its headlamps and marker lights.

and rear position lights, but when the rear vehicle driving in the same direction is driving in close proximity to the vehicle in front, the high beam is not allowed. Fog lights should be turned on when driving in foggy days.

and hazard warning flashers. Article 59 When a motor vehicle passes through a sharp bend, slope, arch bridge, pedestrian crossing or an intersection without traffic signal control at night, it shall alternately use high and low beams to indicate it. When a motor vehicle approaches a sharp bend, the top of a ramp and other road sections that affect the safe visual distance, as well as overtaking or encountering an emergency, it shall slow down and sound its horn to signal.

Article 60 Where a motor vehicle breaks down on the road or a traffic accident occurs, obstructing traffic and making it difficult to move, it shall turn on the hazard warning flashing lights in accordance with the provisions and set up warning signs 50 to 100 meters behind the vehicle.

Do not use high beams when meeting a motor vehicle at night! Only need low beams, this is a civilized approach, many people don't understand, turn on the high beams to affect the other party and see nothing! This is a serious practice! Resolutely strike!

No, you don't. If the lights alternate between near and far, it is a reminder that the vehicle in front of you is in trouble. It is not used when meeting the car, but when meeting the car, both parties use low beams.

At night, if you are on the road with street lights, you do not need to alternate between the distance and the distance when meeting the motor vehicle, only when the road is darker or when crossing a T-shaped intersection.

When meeting a motor vehicle at night, you can directly adjust the high beam to the low beam. Especially large vehicles. If you drive high beams, it will be dangerous for the opposite car to stop, you can't see anything clearly, and it doesn't comply with traffic rules.

Lighting is good and is not needed.

Poor lighting: Due to limited line of sight, it is necessary to be aware of the surrounding situation, and it is necessary to use alternating distance and near.

Low beam. When meeting cars on a road without street lights or poor lighting, select the meeting place in advance, and when 150 meters away from the oncoming vehicle on the opposite side, cooperate with the other party to change the high and low beams, that is, the other party uses low beams when turning on high beams, and the other party uses high beams when using low beams; And control the speed according to the road conditions, and drive on the right side as much as possible.

Precautions for motor vehicles.

Do not meet in complex and dangerous places such as narrow bridges, narrow roads, tunnels, and sharp bends. If there is an oncoming vehicle in these sections, you should control the speed correctly according to the speed of the oncoming vehicle, the size of the vehicle, the distance and the road conditions, avoid complex and dangerous areas, and choose a wide place at both ends to meet.

If you are farther away from the dangerous area than the other car, slow down or stop in advance to let the oncoming car pass through the dangerous area first, otherwise, you can accelerate through the dangerous area in advance and then meet the oncoming vehicle. If the car will be seen at the curve, the line of sight is blocked, and the principle of passing on the right side should be strictly observed, and a certain lateral distance should be maintained, and it is strictly forbidden to occupy the road. Making a big turn when turning right and making a small turn when turning left are both dangerous behaviors that can cause accidents.

The above content refers to Encyclopedia-Huiche.

At night, the lights need to alternate between near and far:

1. The vehicle should close the high beam at a distance of 150 meters from each other, and use the low beam instead, and at the same time should reduce the speed of the vehicle (generally with medium speed gear), choose a wide and straight place to meet, and wait for the two cars to meet when they will be in the wrong place, you can turn on the high beam;

2. When the two cars are about 50 meters apart, and the low beam still makes people feel dazzling, the low beam should be turned off and replaced with small lights to ensure safety. After switching to low beams or turning off low beams, if the road surface is not clear, you need to observe the distant situation, and you can continue to turn on the low beam or high beam for observation, but the driving time should not be too long (the method is: a flash is enough) so as not to dazzle the driver of the opposite car;

3. However, when intersecting with non-motorized vehicles on narrow roads and narrow bridges, intermittent lamps can not be used to prevent cyclists from dazzling and accidents occur.

Lights used at night with motor vehicles:1. When meeting on a road with no street lights or poor lighting, cooperate with the other vehicle to change the high and low beams;

2. Turn off the high beams when you are buried within 150 meters of the oncoming car on the opposite side, and use the low-beam anti-glare lights instead;

3. Turn off the high beams in advance when meeting cars on the road with good lighting conditions, use low beams instead, turn off the low beams when the two cars meet, and only turn on the small lights or wide lights. The car is a train, a car that is running in the opposite direction, and a staggered section of the car passes through a certain place at the same time.

Precautions for meeting cars1. Pay attention to traffic command signals and traffic signs when meeting cars;

2. If the line of sight is not clear, you should reduce the speed of Lingdan in advance and turn on low-beam driving;

3. Do not use emergency braking, slamming the accelerator, or slamming the steering wheel in the car;

4. Do not meet the car at the obstacle;

5. Do not meet in complex places such as narrow bridges, narrow roads, tunnels, and sharp turns.