What should I do if the monitoring monitor keeps flashing white, and the monitoring screen is white?

The supply voltage is unstable or the line loss is too large.

Summary. 1. This situation is generally a problem with the camera, it is recommended to power off the camera and try to connect it again, if it is still a white screen, the camera is broken, it may be due to the problem with the crystal head of the camera, you can replace the crystal head, and the white screen will disappear.

2. You can use the multi-purpose inner meter to measure the output voltage of the power supply, if there is a problem, the line at the output connector of the power supply has not been completely broken, and the picture will return to normal after rewiring.

What should I do if the monitoring screen is white?

1. This situation is generally a problem with the camera, it is recommended to power off the camera and try to connect the electric volt burn, if it is still a white screen, the camera is broken, it may be due to the problem with the crystal head of the camera, you can replace the crystal head, and the white screen of the picture will disappear. If there is a problem, the line at the output connector of the power supply has not been completely broken, and then it needs to be rewired, and the picture will return to normal.

No. I clicked something on the computer and that's it.

Problems with your computer's settings.

You're clicking on the **image color?'

TV on the wall.

This seems to be an issue with the color of the page.

Hello, the above questions will be answered by me. The monitor flashes for the following reasons: 1. The circuit problem of the camera itself, the power supply is not good for a long time.

Second, the possibility of a precursor is the most likely. Directly dismantle it and take it to the computer room to try it with a new power supply. 2. Jianhui Shifeng discussed replacing the power adapter for testing.

Most of these problems are caused by insufficient or unstable power supply voltage, if it is a centralized power supply, it is recommended to install a power adapter next to the camera to supply power separately, so as to reduce the voltage drop in the process of low-voltage transmission as much as possible. 3. Monitoring is now the mainstream. Based on the IP network ** monitoring system (IPVS) 4, check the camera and ** wire joint, there may be poor contact, oxidation and the like.

There is also a lack of power supply, try changing the power supply. There is an image during the day, but not at night, it should be that the light of the camera is broken, and it is good to change the light. 5. Check whether the CPU processor of the router is 99% overloaded.

6. Check whether there is packet loss in the network. 7. The bandwidth is insufficient. Hope it helps!

The monitor flashes and flashes, and it is solved by following the steps below: 1. The camera flashes because the signal is interfered by other lines, and the line interface is not in good contact. 2. If there is a problem with the camera encoding or the power supply is insufficient, please pay attention to check the encoding and power supply problem of the camera flashing.

3. The light at the camera position is dark, and the light sense is continuously switched. The choice of location also affects the camera. 4. DVR interface connection problem.

Pay attention to check the interface connection to make sure it is connected correctly. Judgment method: 1. Check Li Xun's line interference.

5. The light is dark, and the light sense is continuously switched.