ADSL is intermittently disconnected, ask the hero to solve the puzzle!! 10

There is a problem with the entrance line.

Or maybe there's a problem with the signal.

Hello, you said that this situation is generally caused by carrier lines, cats, routers, etc.

1 Check the crystal head of the lower network cable, the crystal head of the ** line, whether there is aging and rust, if it does not work, it will be redone, or it will not have an impact.

2 The cat has been left open for a long time, it is very hot and hot, it is recommended to place the cat in a ventilated place as much as possible, and do not overlap with the router. so as not to overheath the temperature. It's really not good to recommend changing a cat with good performance (I hit ** to go to telecom, free to change).

3 Several computers share the network, because the router is too poor, others use P2P to watch movies, etc., it will drag the router to death, restart the router will be better, the long-term solution is to change to a better enterprise-level router.

4. The operator's computer room is far away from your home, beyond the ADSL distance, line failure, etc., then ask them to measure the signal strength and line situation (sometimes two lines, one can be connected to the Internet if one is broken, but the network speed is slow, easy to drop, ordinary people can't find it).

Please find the problem from the above points, I hope it can help you!!

I don't understand hi me, I can teach you to analyze and solve it step by step!!

Seeming yes, we're all from o( o

The line can't carry 4 trillion bandwidth, so the drop is called telecom bandwidth reduction.

It is recommended to replace the cat, whether it is the cat's business or the cat's power supply.

One is the problem of the cat, try another one, the second is the transformer socket that connects the cat to see if it is tightly plugged in, whether it is a little bit of poor contact, we often encounter this thing, just change the socket.

There's something wrong with your cat. Try a different cat. If that's still the case, it's a problem on the operator's side. Go to them.

You first check whether the crystal plug of the network cable is loose, click on the computer, then open the device manager, find the network adapter point to deactivate, and then start it, maybe it's fine. If not, don't be angry! Sit down, have a cup of tea, and cheer up in the hot summer, the temperature is very high, don't you feel hot?

You put me here and don't care about us; The temperature of my chip is above 40 degrees, the temperature of the hard disk is higher than 45 degrees, and the temperature of the network card is more than 80 degrees; Can you work in such an environment? You still have a fan or an air conditioner or something, do you mind my business? Our Equipment (Device means:

Cats, routers, network switches, Hubble, computers, etc.) are the same, feel hot and can't be rudely ruined to work for you anymore; You can't go to the Internet, you look for masters in the north and south, don't cool me down, you can't find anyone (or replace cats, routers, etc.), because our brothers have the same temper, if you don't cool us down, we will strike! You may wish to take a look at the following methods, and use measures that you feel are acceptable to reduce the temperature of my (equipment) working environment, I promise: continue to serve your elderly.

A: Users who often surf the Internet for up to half a year should open the shell of the device after the power is off and clean up the dust inside the device. b: Place the equipment in a safe place for people, open the lid of the equipment, use air convection to strengthen contact with the air, and naturally dissipate heat;

c: Install a micro fan to the equipment to increase the convection of air and force heat dissipation;

D: If you are doing IT, I suggest that you install a heat sink on the heating part of the device after disconnecting the power supply.

e: After the equipment is disconnected from the power supply, use a 3mm drill bit to drill many holes up and down the equipment to strengthen the air convection flow and improve the heat dissipation conditions;

F: As for the ventilation and drying of the equipment, it is best to make a (there are also laptops on the market) a terrific edge heat dissipation bracket to support the equipment for natural heat dissipation;

H: Let the adsl cat sync first: power off the cat and restart it.

i: The software settings are reasonable, so that 3 do not install: do not install informal software, do not install P2P (occupy resources) software, and do not install infrequently used software.

Turn off all unnecessary network connections, such as Thunderbolt BT Donkey, etc.;

j: Optimize the network Personally, it is recommended to use some gadgets such as Super Rabbit, Optimizer or 360, etc.K: The computer should have at least one valid and genuine antivirus software installed l:

NIC problem: The NIC has an appropriate bandwidth and works stably. As long as you take care of our brothers (routers, cats, hubble, network switches and their computers), our brothers promise to really do it:

You respect me, I respect you" for your faithful service. Otherwise, ride a donkey and read the record book--- let's see!

Thank you for my answer!

Thank you: friend!

Change it! How can you have feelings, are you reluctant?

The machine is old-fashioned.。。。 Change the machine and try it, there will be that disconnection in you, no? If you haven't done it. That's a matter of the machine. If there is. Then there is the ADSL problem of the telecommunications bureau.

See if your adsl disconnection is periodic or disorderly! Enter the control interface of the ADSL cat to see the signal-to-noise ratio of your line, in addition, you should also pay attention to whether there are some high-power electromagnetic devices next to your ADSL line? Also, is there a problem with your separator, if there is a problem with the separator, the line will be broken as soon as there is a dozen, and the fixed machine is not cordless, which has interference.

Whether the anti-theft function is turned on on the fixed machine, pay attention to the switch on the back or side of the machine, which will seriously interfere with the ADSL signal.

See if the outer wire box terminal is oxidized, find your own terminal, unscrew it, and remove the oxide layer from the connector and wire with fine sandpaper! That's it! If you find that ADSL often drops packets and drops, especially when brushing **, xx often occurs, after eliminating computer and network cable problems, you can deal with it like this!

If you really can't do it, you can ask the maintenance staff to change the line! The maintenance guy didn't have that hard work to help you get it!

Reason 1, the voice separator is not installed according to the specifications (the voice separator is installed on the bus) The second reason is that the user line is too long and the contact is poor.

The third reason is that there are high-voltage electricity, transformers, and transmission towers nearby.

The fourth reason is that you have a computer problem or a broadband port problem.

The fifth reason is that the modem is used for too long and is caused by heating.

It should be, you check the crystal head, ** line and network cable to see if there is oxidation (turning green), broken wire and the like.

If not, change the model. Because the models that Telecom exchanged for are second-hand.

Is it a problem with the line?,This situation is generally a problem with the line and the cat.,I've had this problem before.,It's a line problem.。

I guess your cat is broken or there's something wrong with that string.

This should be the PPPoE protocol is corrupted. You delete and uninstall all the dialer software you originally installed. Then install an ADSL dialer to see. If this is the case, it means that the PPPoE protocol in the system is completely corrupted. Reinstall the system handlebar.

This question is divided into several cases:

1.Does the Link (or DSL) light of your ADSL terminal device (Broadband Cat) flash when the connection is dropped? If it flashes, it means that your home's ** line is not very good, caused by excessive line attenuation, if the line is new, there is no joint and no aging and there is no overdistance, then it means that the cable of the telecommunications department to your home cable is not good.

The solution to this situation is to allow the telecom department to reduce your bandwidth to see if there are still drops. If not, see if there is something that interferes with the signal in your home, or together, but the ** line at home is best away from the high-voltage power line, and then whether the splitter is damaged or plugged incorrectly.

2.Virus cause, your machine is infected with a virus, which affects your PPPoE dialer and causes the connection to drop.

The above two situations are common problems that I encounter in my work. I am an employee of Netcom.

It should be a problem with the network line. You can consult and let the maintenance personnel come to your home to see.

But like my family, I can't get better, I can't go back, and I'm depressed.