How to hand knit wallets, how to make handmade wallets

Take sheepskin, for example.

1. Tools. Leather cutters, carving knives, 2B pencils, lambskins, cardboard, nylon interlinings, compasses, pointed cones, garment rakes, double-sided tape, etc.

Second, manual. 1. Prepare the leather surface.

1) Firmly stick the paper pattern on the leather surface with transparent glue, and use a carving knife to carve the leather along the twill on the paper pattern.

2) Scribing. Cover the epithelial surface with another piece of paper, point out the heads and tails with an awl, and then use a ruler to draw lines on it.

3) Cropping. Use a cutter to cut the skin into strips along the line.

2. Cut the leather surface.

1) Measure the seam with a compass.

2) Cut the braided strip along the seam you just drew and evenly apply white latex.

3) Attach the braided leather to the back of the other skin.

4) Cut it neatly.

5) Cut neatly along the edges.

3. Sewing inside the bag.

1) Point out the four corners along the paper pattern with a pointed cone, then use a ruler to draw a line, and then cut it along the line.

2) Stick double-sided tape on the top end, and then fold it in half (six in total).

The bottom card slot is neatly shaped, adding together a total of eight card slots. The two pieces at the bottom of the card slot. Double-sided tape on both sides. The meaning of double-sided tape is to stick it first, and the seam will not run crooked.

3) All the card slots are stacked together, starting from the bottom one, and the position of each piece is determined one by one, and the first card slot is pasted.

4) Use a garment rake to make a good stitch hole.

5) Sewing skin. Two needles are sewn at the same time.

After threading the leather thread through the stitch, turn the thread back through the tip of the needle (the thread should be thick) and then pull it tight.

6) After sewing, sew more holes back to fix.

7) Leave half a centimeter of thread to cut and burn the thread with a lighter.

8) The card positions on both sides are sewn piece by piece from top to bottom.

9) Sew the side well (take a circle to plan the seam, punch the hole, and finally sew it again).

10) Double-sided tape fixation.

4. Sewing of finished products.

1) Wrap the whole wallet in a large circle.

2) Use your fingers dipped in transparent edge oil to apply the edge oil to the side of the wallet and seal the edge.

The hand-woven wallet is completed.

Hand-knitted wallets are generally suitable for dense stitches, and the commonly used crochet method can also be used to weave beautiful wallets. Once you have decided on the style of your wallet, you can choose a stitch method and use the remaining wool thread for knitting clothes.

Try it yourself... But isn't there a cross-stitch with that kind of wallet? You can choose the pattern by yourself,。。 Embroider it yourself.

What materials are you going to use?

The manual wallet method is as follows:

2.Stitch the long side. As shown below:

3.The back of the stitched cloth is ironed with cotton. Cotton and linen are not recommended to be hot, but I like the feeling of softness. As shown below:

4.Stitch the table cloth and lining cloth. Don't forget to leave your mouth back. As shown below:

5.Turn it over and hide the needle and suture it. As shown below:

6.Turn it over to the inside and roll the needle to suture. As shown below:

7.The cute little bun is done! It's simple. As shown below:

Traditional wallets are things that people carry with them to hold money or other small items, and they have also symbolized people's taste and status since ancient times. Wallets can collect money and monetary tools such as bank cards and credit cards in a small bag, which is easy to carry around and use, usually the size of a palm. Nowadays, in addition to the above functions, wallets can also be used as portable decorations or as household ** clips.

Wallets can be basically divided into medium and long wallets and short wallets according to their styles; The mid-length wallet is known for its rectangular shape and longer length. If you have a lot of stuff and put your wallet in your bag, it is advisable to choose a mid-length bag. For shorter wallets, mid-length wallets are also more generous.

Short wallets are short in length and width, generally close to square, and are recommended if you often pack money in your pockets.

Here's how:Tool materials: paper, glue.

1. First of all, the two short sides are folded to the middle line, as shown below.

2. The quarter line on the right side coincides with the diagonal (gray line), and the two corners at the position of mark 1 are folded to the back.

3. Fold both sides to the back;

This is the back of the previous step, folded left and right in half, at this time it can also be glued together.

4. The two mezzanine wallets are ready.

It is possible to increase the number of interlayers, glue them together.

5. Stuff a piece of paper with the same width as a wallet in the mezzanine.

6. The two corners on the right side are folded inward, and the finished product is as follows.

1.Take a piece of paper and fold it in thirds.

2.Open and fold the corners of both sides in half toward the middle.

3.The two corners of each end continue to fold in half towards the middle.

4.Once folded, align the sides toward the midline.

5.Turn over and continue aligning towards the middle. Fold it in half.

6.Pull the triangle out from the inside of the wallet.

7.The corners are folded inwards and the triangles are pressed downward.

Such a good-looking wallet is folded.

Prepare materials: two sheets of A4 paper, one of which is yellow flower paper and one is white paper.

Step 1: First, the yellow flower paper is placed horizontally, and the edge of the flower paper is folded along the white paper, as shown in the figure below.

Step 2: Then reopen the flower paper, fold the white paper up and down, and put it on the flower paper, so that the white paper forms a double-layer opening upward, as shown in the figure below.

Step 3: Then take the upper half of the white paper and fold it down, as shown in the figure below.

Step 4: Then fold the two sides of the yellow flower paper as shown in the figure below.

Step 5: Then fold the top edge of the yellow flower paper and stuff it in, as shown in the figure below.

Step 6, finally fold it in half again, put change in it, and here a simple handmade origami wallet is ready, as shown in the figure below.

That's all about handmade wallets, I hope it can help you.

The steps to manually sell late wallet origami are as follows:Material for the preparation of the fight: a square piece of paper.

Operation steps: 1. Take a square piece of paper, and then fold it in half along one side.

2. Then fold it inward from both ends to the quarter sock of the paper.

3. Fold the two corners of the lower end of the folded part to the left and right respectively.

4. Open the two corners of the fold again.

5. Turn it over and follow the fold marks from both ends to a quarter of the paper.

6. Fold down along the dotted line from above, and then down to the junction of the two corners.

7. Turn it over and fold the upper part directly down, so that the wallet is done.

First of all, the number of pins needs to be a multiple of 2, and 48 stitches are demonstrated (if you want the bag to be bigger, you can take a few more stitches, and if you want the bag to be smaller, you need to take a few fewer stitches). Then pull it out from head to end.

1st circle: 2 locks, thread the back 1 needle crochet and 1 needle medium and long needle, (every 1 needle, hook 1 needle in the next 1 needle, and then go back to the skipped needle to hook 1 needle in the medium and long needle), repeat the crochet hook in parentheses for the whole circle.

The second circle: first pull out 1 needle to the left, 2 locks, and then go back to the first 1 needle to hook 1 needle in the middle and long needle, and then repeat every 1 needle, hook the medium and long needle in the next 1 needle, and then go back to the skipped needle to hook the medium and long needle, and loop the hook for a complete circle.

After that, repeat the pattern of the second circle and repeat the hook (i.e., the first circle first skips the medium and long needle that appeared on the orange side of the previous circle, first hooks the needle behind it, and then goes back to hook the medium and long needle), until the height of the bag you want (the demonstration hook is 11 turns).

The 13th circle: still hook according to the law, but this line only hooks half of the number of needles, and then turn over, do not add or subtract a line of hooks to pull out the needle; Turn over again, first pull 1 needle to the left, and still hook a row according to the hook method of the two staggered needles above. Repeat the hook method of the above two lines (one line of pulling, one line of staggered needles) and hook again, and then break the thread.

Then we insert the needle from the left side of the bottom row of the lid and pull it out of the metal ring at the same time, and then start to hook the short needle without adding or subtracting (2 short needles in the loop) until the other end, and then attach the loop in the same way. Then continue to hook the short needle back to hook the hair on the lid of the bag.

After the short needle is hooked in a circle, continue to pull the needle without adding or subtracting the hook to almost half of the cover, and then hook the 5-needle lock needle, 1 needle apart, and then start to hook and pull the needle on the next needle, and the thread is broken after the circle is pulled.

Bottom of the bag: Pick up the lock pin, calculate the number of lock needles to be lifted according to the number of needles at the bottom of the bag (23 stitches are demonstrated), and half of the number of needles at the bottom of the bag can be used. Then do not add or subtract the hook 3 rows of short needles.

Then, the fabric and the bag are each picked with half a needle (both pick the outer half needle), and sew them with a short needle, and the whole circle is sewn.

Then take three strands of cloth line, tie a slipknot and thread it out of the wrapping ring, the loop is set on the left index finger, the cloth strip thread on the right hand side is threaded into the coil and pulls out another coil on the right index finger, the lower one is tightened, and then the cloth strip line of the left hand is pulled out of the coil of the right hand and the coil is set on the left index finger, and so on, the left knot, the right knot, until the length of the desired bag.

Finally, thread the tape end into the wrap loop, pull it out of the finger loop, pull it tight, tie a knot with the excess thread to fix it, and trim the end of the thread neatly. Then sew the decorative buckles, so that the messy and beautiful denim shoulder bag is complete