-
Anonymous users2024-02-07The five static route configuration commands are: iproute, iproutedefault, iprouteadd, iproutedelete, and iprouteshow.
1. iproute command.
The iproute command is the most basic command in static routes, which is used to manually add route information. For example, if we need to send packets from the network to this router, we can use the following order to kill the liquid burner:
2. iproutedefault command.
The iproutedefault command is a command used to set the default route. When the router is unable to match the destination address, it sends the packet to the next-hop device specified by the default route.
For example, if we need to send all unmatched packets to this router, we can use the following command:
3. iprouteadd command.
The iprouteadd command is similar to the iproute command and is used to manually add route information. Its syntax format is as follows: iprouteadddestination-network subnet-maskvianext-hop-ip-address.
For example, if we need to send packets from the network to this router, we can use the following command:
4. iproutedelete command.
The iproutedelete command is used to delete route information. Its syntax format is as follows: iproutedeletedestination-network subnet-mask.
For example, if we need to delete the routing information of the network, we can use the following command:
5. iprouteshow command.
The iprouteshow command is used to view the route table information. Its syntax format is as follows: iprouteshow: The command lists all routing information, including information about the destination network, subnet, mask, segment, tick code, next-hop device, and interface.
For example, if we want to view the current route table, we can run the following command: iprouteshow.
-
Anonymous users2024-02-06ROM Monitoring Mode: The router is booted but no iOS is loaded, the prompt is: > or ROMmon>
Boot Mode: Boot Flash contains a minimized iOS boot program with a prompt of Router (Boot) >
User Execution Mode: A complete set of iOS** is successfully loaded and launched, which can display system information, perform basic tests, and more. You can't view the configuration file and use the debug command.
Privileged Execution Mode: Second-level mode for full access. You can realistically state system settings and status information, enter configuration mode, and run debug commands.
Configuration mode: Enter the config terminal command in enable mode to enter the configuration mode. Interfaces, routers, and line configurations can be set.
Initial configuration of the dialog mode; At startup, if the router is not configured (perhaps because the router is new or the configuration file has been deleted by the write erase command), it enters the system configuration dialog mode. You can set the hostname, execution password, and enable password in turn. The IP and subnet masks of the network management interface can also be configured. Then save it to NVRAM.
First, network interconnection, routers support a variety of LAN and WAN interfaces, mainly used to interconnect LAN and WAN, to achieve different networks to communicate with each other; >>>More
I don't know what you mean by the network cable is the landlord's? It's really hard for you. >>>More
It may be laborious to do this, but it may not be really effective. If DHCP is enabled on the router, IPs outside the DHCP address pool can also be accessed by manually setting a fixed IP address. >>>More
There are two situations, first: your computer is poisoned by ARP, as soon as you start the Internet virus, trick other computers into sending data packets to your machine, and your computer throws away these packets, their computer will not be able to get on, use 360 to kill the virus. >>>More
Setup for both routers:
1. The router used to connect to the external network is the first router, and we will use this router as the main router. If your router is newly purchased and has been restored to factory defaults, then its IP should be... >>>More