How do I put the laces in my shoes and how do I tuck the laces of my sneakers into my shoes?

Skateboard shoes generally loosen the laces more, if it is not a board shoe, it is recommended not to get it.

Also, if it is a board shoe, then the front laces should be loose, so that there is only a little lace left at the end, so that there is no need to tuck it in, and it is very handsome when you show your head outside

If it is similar to canvas, you can also refer to the above statement, and if the laces are too long, you can go to the store and buy a shorter one.

No way! This should be a shoelace in the tongue of the shoe!

There is a gap behind the tongue of the shoe! Put ** the most hidden! Unseen!

That's how I wear it!

Hope it helps!

Just cut off the laces, it's a redundant move.

After tying your shoelaces.

Tuck into the laces on the top of your feet.

A few more rounds will never come out.

It's okay for my Gaobang to keep his shoelaces on the outside.

But it's still loose mainly for ease of putting on and taking off.

The kind on one side of each department.

It's not an ordinary kind of system...

Comfortable yourself is the trend.

The easy way to do this is to tie the laces under the tongue and tuck the excess length into the seams on both sides.

Hello, don't stuff your shoes, because that will generally fall out, tie your shoelaces, and put more shoelaces neatly under the laces, and it's OK, thank you.

Stuff it in first, then put your foot in again, step on it with your foot, and you're good to go.

Try to loosen the laces and tie the soles as much as possible, if they are too long, you can only put them under the tongue.

There are two ways to tie shoelaces:

1. Bow tie method:

1.Thread the head of the shoe straight from the bottom (grey part) into the bottom two holes at the bottom.

2.Thread the laces from the inside up (dotted line) to the next row of holes, leaving a "gap".

3.The shoelace head crosses over and threads into the next row of holes.

4.Continue to wear it upwards, straight on the inside, crossing it on top.

Second, the straight system method (lazy style) method:

1.Thread the head of the shoe straight from the bottom (grey part) into the bottom two holes at the bottom.

2.One end of the shoelace head (blue end) runs along the left side and goes up from the top lace hole.

3.The other end of the lace (the yellow end) runs straight up the right side through the hole in the second row.

4.The same end (yellow end) goes up and back through the remaining holes.

How to hide shoelaces].

1) You can tie the laces in the tongue of the shoe, so that the knot is pressed by the tongue, and the tongue is upturned, which is also very beautiful.

2) You can also stuff the laces directly into the shoes and step on them directly, but it is more difficult to get used to it at first, so you can get used to it slowly.

The shoelaces are too long is a lot of people's distress, and they will trip themselves if they are not careful, which will bring inconvenience to life, and we can use the following methods to avoid these situations: 1. Hide in the tongue, 2The laces are hidden in the upper, 3

Shortening the shoelaces in circles can be used to hide the laces well and avoid the inconvenience caused by being too long.

Tools Ingredients: lace-up shoes, unused pencils.

Method 1, first of all, the shoelaces should be tied like this, and they should be worn into the inside from the outside 2, prepare an unused pencil or some slender stick, and the edges and corners of the top should be slightly smoothed, otherwise you will scratch your feet when you use them.

3. Press the middle of the shoelace with the freshly sharpened end of the pencil.

4. Press the shoelaces with a pencil and stretch them to the right of the instep (which side of the shoelaces is stretched) 5. Drain out a small part of the shoelaces (not too long).

6. Then repeat the step on the left side of the right foot, the right side of the left foot, and the left side of the left foot.

Here's how:

1. The easiest way is to put the remaining laces inside the shoes. The method of tying shoelaces in front is still the same as usual, do not tie them in the back, and put the remaining shoelaces directly under the tongue, such a method is suitable for walking in normal times, if you want to exercise then this method is not very feasible.

2. After wearing the shoelaces, tie a knot in the shoe, just like the usual knot, so that you are not afraid that the shoelaces will fall off, which is similar to the method mentioned above, but tie an extra knot inside to prevent the shoelaces from falling out easily. So the method of tying the laces inside is very simple.

Take out the shoes with the laces on.

2.Tie the extra laces with a bow.

3.Tuck one side into the shoe.

4.Tuck the other side in as well, and the laces are hidden.

Other methods: After fixing the laces, pull them outward; Then according to the "Z" shape down in and out of the system from the first hole to the last hole, into a "one" shape.

2.After the last hole is pierced, carefully inspect the hole you just pierced to see if there are any mistakes, and by the way, smooth out some of the twisted laces. Hide the excess laces in your shoes after the inspection.

3.Take out the second lace, preferably the opposite color of the first heel lace, repeat the "Z" shape according to the previous method, down and up, so that the lace is in a "one" shape. Check that the shoelaces have taken the wrong path and flatten the laces to hide the excess in the shoe.

Please note that the second lace should always be on top of the first. Finally tidy up the laces, secure them, and you're done.

If the laces are short, tuck them under the tongue and secure them. If the laces are long, tighten the laces, stick to the two sides of the shoe, and tuck them flat under the insole (usually the insole that comes with the board shoes can be taken off, and a thin insole can be added if you can't take it off). It's both beautiful and comfortable.

Shoelace tying method 1: 1After adjusting the length of the ends of the laces, pull out the laces from the inside out; 2.

Pull out the laces and thread the second hole from the outside to the inside; 3.The left shoelace is worn under the shoelace between the two holes on the right, and the right side is the same; 4.repetitive operation; 5.

Pay attention to the direction of the crossed laces at both ends; 6.Excess shoelaces are tucked into the inside of the shoe and knotted; 7.Trapezoidal knots when finished.

Wear your shoelaces in the direction of the dotted line; 3.Adjust the laces so that they remain in a straight line and do not roll up; 4.The excess is tucked into the shoe; 5.

Again, leave a piece of white lace on the inside, and tie it with the yellow lace inside; 6.Wear your shoelaces in the direction of the dotted line; 7.Adjust the white laces so that they are on top of the yellow laces; 8.

The excess is knotted on the inside of the shoe along with the yellow laces.

Shoelace tying method three: 1One end is knotted on the inside, and the other end is perforated in order; 2.

Jump a hole through it; 3.Tie it in the same way; 4.After repeating, the remaining laces are tucked into the inner side and knotted; 5.

Purple laces are also pierced in the same way, in order; 6.Pierce it in from below and out from above; 7.Choose harmonious laces according to the color of the shoes; 8.

Excess laces are knotted on the inside.

Tie the shoe first, then stuff it directly into the shoe, and that's fine.

You can tie your shoelaces as normal and tuck them into the tongue!

Just stuff it in, it's just a little uncomfortable.

Tuck it into the sides of the upper, but it's a little uncomfortable.

There are several ways to tie the shoelaces inside:1. Cross knots.

1. One end is knotted on the inner side, and the other end is perforated in order;

2. Jump a hole and penetrate it;

3. Tie it in the same way;

4. After repeating, the remaining shoelaces are tucked into the inner side and knotted;

5. Purple shoelaces are also perforated in the same way and in order;

6. Wear it from below and then out from above;

7. Choose harmonious laces according to the color of the shoes;

8. Excess shoelaces are knotted on the inside.

2. Trapezoidal knots.

1. After adjusting the length of both ends of the laces, pull out the laces from the inside to the outside;

2. Pull out the shoelaces and thread them into the second hole from the outside to the inside;

3. The left shoelace is worn out from under the shoelace between the two holes on the right, and the right side is the same;

4. Repeated operation;

5. Pay attention to the direction of the cross laces at both ends;

6. Excess shoelaces are stuffed into the shoes and knotted;

7. The trapezoidal knot after completion.

3. Twist knots.

1. Two shoelaces are knotted inside and worn out;

2. Wear out of the second hole after the two shoelaces are crossed;

3. At this time, in order to center the intersection as much as possible, tighten the laces;

4. The appearance of twist is produced in the process of centering the intersection;

5. Enlarged twist knots**;

6. Leave the last hole;

7. Finally, use x to deal with it, so that it is more convenient to put on and take off;

8. The remaining shoelaces are knotted together in the shoes.

Fourth, double direct knots.

1. After leaving a length of yellow laces, they are worn out of the left face and entered from the right face;

2. Wear shoelaces in the direction of the dotted line;

3. Adjust the shoelaces so that they remain in a straight shape and do not roll them up;

4. Tuck the excess part into the shoe;

5. Also leave a section of the white shoelace on the inside, and knot it with the yellow shoelace inside;

6. Wear shoelaces in the direction of the dotted line;

7. Adjust the white shoelaces so that they are on top of the yellow shoelaces;

8. The excess part is knotted with the yellow laces on the inside of the shoe.

5. Internal X knot.

1. After something is consistent at both ends, each end is pierced through the second hole;

2. Penetrate into (2) hole from (1) hole, and then penetrate out from (3) hole;

5. Knotting on the inside;

6. The finished style.

4 ways to tie high-value shoelaces! Teach you how to tie your shoes in a fancy way, and make your shoes different every day.

1. Cross knots.

1. One end is knotted on the inner side, and the other end is perforated in order;

2. Jump a hole and penetrate it;

3. Tie it in the same way;

4. After repeating, the remaining shoelaces are tucked into the inner side and knotted;

5. Purple shoelaces are also perforated in the same way and in order;

6. Wear it from below and then out from above;

7. Choose harmonious laces according to the color of the shoes;

8. Excess shoelaces are knotted on the inside.

2. Trapezoidal knots.

1. After adjusting the length of both ends of the laces, pull out the laces from the inside to the outside;

2. Pull out the shoelaces and thread them into the second hole from the outside to the inside;

3. The left shoelace is worn out from under the shoelace between the two holes on the right, and the right side is the same;

4. Repeated operation;

5. Pay attention to the direction of the cross laces at both ends;

6. Excess shoelaces are stuffed into the shoes and knotted;

7. The trapezoidal knot after completion.