Why is my CPU temperature only 52 C, and Master Lu prompts that the temperature is too high

The normal value of CPU temperature is about 30-45 degrees, of course, the lower the better, there are several reasons for high CPU temperature, first, overclocking is too high, second, the ambient temperature is too high, third, the air duct is blocked, fourth, it is turned on for a long time, fifth, the power supply voltage is unstable, and so on. This is also a common problem with assembly machines. Simplified Processing:

Open the case lid or use an electric fan after opening the lid.

52 degrees is normal. Just turn off Master Lu. Switch to everest and set the alarm temperature yourself.

Between the heatsink and the CPU is the thermal grease, if the heatsink base is very smooth, then a thin layer will do. The base is brushed, or concave or convex.

52 is normal! It depends on the ambient temperature! I'm also Master Lu!

When it's cold, it's over 40 degrees! If it's hot, it's 56 degrees Celsius, which is the highest temperature! Don't do too much thermal grease, the dosage is not to be squeezed out, it is generally a very thin layer, when I coat it, I usually push the tube down a little bit, the middle point, the side point, remember not to paint on the side, put it on the side and squeeze it to the side!

Too many paintings are not good!

Master Qilu was afraid of the first flu

Click Master Lu's "Computer Monitoring", and then click "Temperature Alarm Setting Options", and then turn the temperature to a higher level. Don't apply too much silicone grease, even less!

There are several reasons why CPUs are hot:

1. The internal silicone grease of the CPU has dried up, resulting in the heat of its CPU core cannot be transmitted to the outside in time, and the lid needs to be opened to replace the silicone grease.

2. The CPU radiator has low performance, which causes its heat to be unable to be sent away in time, and can only be replaced with a better radiator.

3. The thermal grease material of the CPU is not good, resulting in its heat cannot be transmitted to the heat sink in time, it is recommended to replace it with better silicone grease.

4. The fan of the CPU cooler is broken, and you need to replace a fan that fits the cooler, and it is best not to touch the memory module.

Two situations: 1. The configuration of your own computer is too old and not suitable for the current software.

2. The heat conduction copper pipe connected to the fan and CPU is damaged and cannot conduct heat. Test method: (Disassemble the machine, turn on the machine and run for a while, and check the clearance temperature near the fan side and the CPU side.) Just touch it with your hands. Remember to burn. ）

In general, it is accurate. If you're worried, you can try a different temperature detection software.

Change a cooling fan, it is already hot in summer, and your heat sink is estimated to be covered with dust, and the heat dissipation effect is not good, but the heat preservation effect is good.

AMD's CPU generates a lot of heat, and it is possible to have more than 70 degrees in the summer. However, the temperature of the graphics card is outrageous. First of all, it is recommended that the landlord change to a temperature measurement software to measure it.

If this is still the case, it is recommended that the landlord open the case and check the CPU fan and graphics card fan and heat sink to see if it is working properly, and it may need to be replaced.

Master Lu monitors the CPU temperature is too high cooling method:

Check that the fans in the case are working properly. Clean the dust inside the case. Be sure to add thermal grease between the CPU and the heat sink.

Drop a drop of sewing oil on the bearing of the cooling fan to reduce noise. Don't drop too much, just one drop. If necessary, you can install a high-power CPU fan and buy a radiator with better heat dissipation effect, such as Kyushu Fengshen.

Install a cooling fan for the case. There is strong electromagnetic radiation in the chassis, which is harmful to the human body, so it is recommended to move the host to good ventilation.

？？Master Lu CPU temperature is highMaster Lu alarm CPU temperature is too high? What to do?

I gave a Master Lu old prompt that the CPU temperature is too high, why use Master Lu to detect that the CPU temperature is too high (up to 96 degrees), and others. CPU Temperature: Detect CPU Temperature:

Auto Shutdown CPU Temperature: Software CPU Temperature: Normal CPU Temperature:

Which is better to adjust a CPU temperature detection software, CPU temperature detection software, and CPU temperature detection software? (Novice) Is Master Lu's CPU temperature detection data accurate, notebook CPU temperature detection problem!! Mine is the Toshiba M323 , which has been used for two years and has been using it without any problems.

A few days ago, I installed Master Lu to measure the temperature, and the general temperature of the CPU is about 65, the graphics card is more than 40, and the motherboard is more than 25. The CPU temperature is also very unstable, and I didn't use the computer to warn me that it was over 75 degrees, and I wondered if Master Lu had made a mistake. I just turned on the CPU temperature in less than two minutes and the temperature showed more than 40 degrees, is this possible, or Master Lu has a problem, or my computer has a problem.

What else is better than Master Bilu to measure the temperature of the computer? Thank you!! Anonymous 0 22011-3-22 Hi, I, don't forget, hehe,,,0 22011-3-29 CPU over 75 degrees is normal, but don't be in a state of high heat for a long time, electronic components aging super fast 0 22011-3-22 Get a good CPU fan, or get a good heatsink 0 22011-3-22 Master Lu has no problem, it's your computer that has some problems. Let's take it apart and clean up the dust. It's time for the fan to be oiled too.

When most people use the computer, they usually open the lid of the chassis and use an electric fan to dissipate heat from the chassis.

The heat dissipation problem of notebooks is a common problem of high-performance notebooks now, basically full load or baking test, 80 is more common.

Some people are on 100, and the computer will automatically shut down.

Generally, the standby temperature is 50 degrees, and the full load is below 80 degrees, and we think that the temperature of the notebook is basically normal.

As for the reason for the temperature fluctuation, the reason is due to the temperature protection function of IntelCPU, but when the CPU temperature reaches a certain limit, it will automatically reduce the CPU frequency to a very low level, and if you are in the game, you will feel stuck below. Then the temperature drops significantly, but below a certain temperature, the frequency rises and the temperature rises. The rate of change is relatively fast.

There is a lot of dust on the computer, so clean up the dust. I don't know if it's a laptop or a desktop, if it's a desktop to change a fan is not expensive, it's only 30 yuan, a notebook, clean up the dust, reinstall the system, and then add a radiator, which can basically solve the problem, and then find me if it doesn't work.

90 degrees, into a crash.

Open the case yourself and take a look, touch the aluminum heatsink under the CPU fan, and see if it's 90 degrees, and you'll know.

Or maybe the CPU is in poor contact with the aluminum heat sink.

The silicone is dry. Just find someone who understands to help you remove the radiator and replace it with some silicone.

The speed of your computer's fan is okay.

1.It is recommended that you find a blower to clean up the dust from the fan first. Free 2It is recommended that you install a rear panel cooling fan for the case. $10 within 3Change a CPU fan for 40 yuan, generally change yourself for 25 yuan, and find a company for 40 yuan.

The heat dissipation paste is dry, go buy some silicone grease, remove it and coat it yourself, and then install the radiator on it, absolutely, more than 10 pieces of a single fan, it is better to replace the radiator directly, the entry-level is less than 100 pieces, there are a lot of Zhongguancun, you can choose as you like, if you still have any questions, I please know.

1.Check if the CPU has been overclocked, the overclocked processor is very easy to age, the heat will increase with the occasion, you can try to restore the original main frequency. 2.

After the dust accumulation of aluminum alloy heat sink, the heat dissipation effect will be very poor, and the fan will also age after a long time. The speed slows down, and a better fan is twenty or thirty yuan, and the expensive fifty yuan is also available.

Clean up the dust, if you haven't tried it before and haven't seen someone else dismantle it, be careful, don't make it useless.

It is not necessarily that the fan is not working, there is a possibility that the motherboard has a problem with the CPU voltage control causing the CPU to work at full load at high voltage, and the heat generation is huge, you can enter the BIOS to see if the CPU voltage is at the normal level and check whether the external frequency and frequency doubling of the CPU exceed the default maximum setting, if it is exceeded, then you need to manually set it to reduce the frequency Otherwise the problem of CPU heat generation cannot be solved.

If it's not a problem with the power supply and motherboard, then clean up the dust on the radiator and fan first, and then replace the silicone that the radiator and CPU are in contact with, this silicone should be wiped evenly, and then add some lubricating oil to the fan, or directly change the radiator, the heat sink and the fan's ** depends on your CPU model.

Hello, your CPU temperature is too high, it is recommended to replace the CPU of microtechnology and pay attention to the case cooling. See below for the solution

The inexplicable shutdown is because the motherboard is set up with temperature protection to prevent the CPU from being burned out, at present, this problem is not caused by the fan, but because of the aging of the silicone in contact with the CPU, if the computer is used for five years and has not been cleaned and maintained, due to too much dust can not dissipate heat normally, it is recommended to clean up the dust, and see if there are programs that occupy the CPU.

For this problem, we offer the following solutions:

1. Check if there are viruses or programs that keep the CPU in full load 2. Clean the dust of the CPU cooling fan.

3. Replace the fan.

4. Check whether the BIOS settings improve the CPU performance to higher than the original frequency or higher5. Replace the CPU

6. Replace the silicone grease.

Just uninstall Master Lu, as for why, I don't know, anyway, that's the case.

Some of the temperature inaccuracies you can tell by touching your hands can also be problems elsewhere.

Are you 90 degrees as soon as you turn it on.

If yes, open the case and touch it with your hand to see if it's 90 degrees.

If not, there is something wrong with your motherboard.