Please comment on my computer configuration and what areas need to be improved

If you're just playing the game, it's a waste!

There's no need to use such a good graphics card!

667 is already good with 800? No need! The difference in frequency is almost invisible.

The power supply is also wasted, just use a calm king.

CPU is recommended to use 4000+, which can't check much performance.

The main wrench has also been replaced, and the TF570U is good for overclocking, and it is very easy to use for general applications!!

It's good to use a pioneer 112ch!

If your set of configurations is for simple gaming, it's definitely not good! The good places are not good, the places that shouldn't be good are really good, it's a bit too much!

I work in the computer city, as a DIY configuration should be the most reasonable cost performance hehe!

As for whether what I said makes sense, you can go to the tech market yourself and run a few more times to find out!

The performance is very good There are 2 small suggestions.

The motherboard can be considered for the same model of Yingtai and Panzheng Because it is an all-solid-state capacitor and shielded inductor coil, it has good overclocking Gigabyte M55S-S3 I think it is famous The liquid capacitors and plug-ins used are average.

CPU performance will be better with 4000+ 3600+ and 3800+ are similar.

1 CPU to add! At least 4000+

2. The hard disk is larger and 160g.

3 Memory for DDR2 667 DDR2 800 is wasted.

In fact, you can save 2 and 3 enough money to add to 4200+

The configuration is good, if you change to Yingtai's 570U or 570SLI, the performance may be better, if the conditions allow the CPU to change to 4000+, it is not much worse.

Well, it's really good, I'm very envious of you, if you want to improve it, you change it to 4400 (Russia, I think so rich won't care about the more than 200, take advantage of the current AMD CPU price reduction) Memory to 2GB because the Vista system requirements are relatively high.

The preparation is good, good. Hehe, I'm more envious.

If you were higher, it would be even better.

It's perfect. Since I'm engaged in 3D design. So my processor is 5000 and the memory is 6g. 3 fast 1TB hard drives. 2 fast x1950pro graphics card, ***+-rw with two light carving.

You have 2 Achilles' heels in this configuration, 1. That is, your motherboard only supports DDR3 1333 memory. So if you buy 1600 memory, it will automatically downclock to 1333. You'll need to set the overclocking settings to get back to 1600.

In addition, depending on your graphics card and CPU, 2G of memory is obviously not very sufficient, at least buy another group of dual-channels.

This is the motherboard parameter, OC is the meaning of overclocking, that is, it can be overclocked up to 1866 memory standard DDR3 1866(OC) 1333 1066 MHz2. Your motherboard won't fit in your case.

Yes, your case structure: matx, and your motherboard structure is ATX, M means mini, and your motherboard doesn't have M, obviously your motherboard is a bit bigger than the case.

Yes, absolutely! Wake without a card!

Graphics Junk !!

Graphics card At least 450 or 5750 or more graphics card is required to use the right CPU...

It would be better if the hard drive could improve something else. Pointed.

Your chassis is not a standard chassis, considering that the power supply of this configuration is only 400-500W, so it is recommended that you replace the chassis.