-
Not easy to break. Xenon lamps.
HID gas discharge lamps, also known as HID gas discharge lamps, replace traditional tungsten filaments with high-pressure xenon gas wrapped in quartz tubes to provide higher color temperature and more concentrated lighting. The same brightness reaches 55 watts using an ordinary car bulb, while a xenon lamp only needs 35 watts, a reduction of nearly one and a half. Xenon lamps can significantly lighten the vehicle's electrical system.
burden. The color temperature of the car xenon lamp is between 4000K and 6000K, which is much higher than that of ordinary car headlight bulbs.
Normal use does not work on hernia lamps.
Causing injury, if not impacted by an external force, its lifespan is that of a traditional halogen bulb.
It is 10 times longer, about 3000 hours or more, and can basically be used to scrap the car. It uses the current generated between the electrodes to promote the collision of xenon molecules to produce brightness, and there is no problem of tungsten wire burning. In addition, xenon lamps are equipped with ballasts to reduce the load on the power supply of the car due to frequent light changes, and reduce the load at the moment of electricity consumption.
-
Hehe, now the lamp surface is made of plastic domestic car lamp surface is easy to yellow and fall off, and the imported car is fine. There is a difference between domestic ones. However, it is recommended to take good care of it, and waxing may be better.
-
Hello, seeing this problem, I thought for a while, if the original car is a halogen lamp, then it will die when you see water, and the halogen lamp is not waterproof. If the xenon lamp is changed, it is easy to break, and the battery will also be damaged; If it's the same LED as the A340 I changed not long ago, that's better.
Waterproof, no load on the battery. If the original car itself is a xenon lamp or LED, it is rarely broken under normal use.
-
Pay for your own repair, take the insurance to change, now rarely to repair anything, are mainly to replace accessories, a headlight is the deputy factory is enough, some of the deputy factory luminosity is higher than the original factory, this kind of innocuous small accessories the original factory deputy factory can not see, the headlights said this purely to prove that they understand better, the actual use of the words does not matter, the deputy factory is cheaper, even if you go to the insurance in the future and fine, is it because your deputy factory insurance will not compensate you? Isn't this misleading.
-
It must be fixed well, and here's why.
1. Headlamp repair and refurbishment technology, as long as the headlight is not penetrated and broken, it can be repaired to the original effect, 2. The original thickness can be restored after repair.
3. The light transmittance can reach 100%.
4. The repair time is very short, and only one cup of tea is needed.
5. Stand the test of time.
The headlight repair technology is the introduction of Baoqi special repair liquid to repair, this repair is not only very short, but also very low, after the repair can stand the test of time.
-
As long as it can be guaranteed that the original factory or the replacement is better, the repaired headlights may affect the future vehicle insurance claims (for example, the headlights can still be repaired if the car is scratched, but you don't want to repair it, and the insurance company will not replace the headlights on the grounds that they have been repaired).
-
Summary. If the headlights of the car are damaged, replacing the headlights is not considered an accident car. If the headlight is damaged in a traffic accident and there are other injuries to be repaired, it is a water accident car.
Is a broken headlight and a replacement headlight considered an accident car?
Hello, I have seen your inquiry, please wait for a moment and answer it for you immediately.
If the headlights of the car are damaged, replacing the headlights is not considered an accident car. If the headlight is damaged in a traffic accident and there are other injuries to be repaired, it is a water accident car.
Got it. Hmmm, okay.
-
The accident car is the structural components of a car (longitudinal beams, suspension systems, front and rear anti-collision steel beams, energy-absorbing boxes and other core frames), frame (body skeleton, structural components, excluding appearance covers), these parts of the vehicle if they are stretched, deformed and damaged because of collision.
Once the structural components are partially damaged, even if they are repaired by stretching, knocking or other means, they will not be able to restore the overall rigidity of the body, and if they collide again, they are likely to "fall apart".
-
Car headlights. There are two cases of breaking:
One is that the headlight part is not lit. This happens for a number of reasons:
1.Caused by poor tie ride.
2.The light bulb burned.
3.Loose or corroded joints make the contact resistant.
Enlarge. The other is that the headlights are not lit at all. This happens for a number of reasons:
1.The power line is short-circuited or over-the-top before the light is switched.
2.Headlight fuses trip or burn out.
3.The light switch bimetal contacts are poorly contacted or do not close.
4.The light switch is damaged.
5.After a certain gear of the light switch is connected, some lamp lines are connected to the iron to cause the bimetal contacts to open.
-
A sudden turn off of the low beam can be caused by a broken bulb, a dead battery, heated wires, or ablative or sticky contacts. Whatever the reason, the low beams should be turned on, as they are very important for safe driving at night. The quality of automobile headlights is related to driving safety and is an important guarantee for our safe driving at night.
In order to improve the safety of driving at night, it is necessary to improve the illumination effect of the headlights. The lighter it is, the safer it is. Once the headlights of the car fail to light up, there is a great safety hazard when driving at night, and it needs to be repaired in time.
The reason why the low beam light suddenly broke is that the bulb is broken, the filament of the bulb is burned out, the circuit is not working, no current is passing through, and of course it will not light up. The battery is dead. You can honk your horn at this time.
If you don't work all night because you forgot to turn off the electrical appliances, you won't be able to catch the car the next morning, and you won't even be able to turn on your low beams. The conductor heats up, resulting in an increase in line resistance and a decrease in the luminous intensity of the headlights. In serious cases, the headlight line will be short-circuited due to the melting of the wire insulation, and even the line will be burned or a car fire accident will occur.
The contacts of photorelays or combination switches in the line are ablated or adhered to, resulting in an open circuit or short circuit.
Check the low beam port to check whether the light port assembly is open, resulting in the low beam is not on, the headlight assembly needs to be replaced, generally speaking, the fifth situation will not appear frequently, and the cost of other situations is not very high, but it is very important to go to the repair station to check it first, determine the problem and then decide what way to repair.
The battery is dead, at this time, you can press the power of the battery by honking the horn. If you forget to turn off the electrical appliances overnight, you won't be able to drive the car the next morning, and you won't even be able to turn on the low beams; The bulbs are damaged, and most of them also have a certain lifespan. When they are close to being scrapped, the light intensity is not up to standard, and the heat is intense until the filament burns out.
In addition, there is another reason. For example, after the vehicle wades in water, the headlight assembly is prone to water. When a hot bulb comes into contact with water droplets, the temperature drops sharply, so cracks and damage occur, affecting brightness; The fuse is blown out, and most low-beam fuses can be found in the fuse box in the engine compartment or on the left side of the dashboard.
The insurance means that it is behind the lid of the fuse box and can be taken out and tested with a special clip; The adjustment circuit of the low beam is faulty, and there may be a problem with the light adjustment switch. In this case, you can go to the shop for repair and check if the adjustment logic of the lamp is abnormal.
-
It is particularly dangerous and you can't see the oncoming car in front of you, and you can't see the car that is close to us, and you use the high beams all the time, which will cause unnecessary trouble to the driver in front.
-
This kind of car will be particularly dangerous, especially at night when the high beam is turned on will shake the driver in the distance, but his low beam is broken and cannot be turned on.
-
The car will be particularly dangerous if the low beam is broken, especially at night, whether it is when the car is in the car or when crossing the road, it is particularly dangerous, and the road surface cannot be observed without the illumination of the light, which is prone to danger.
You can change the headlight yourself, unplug the power socket of the bulb, and remove the waterproof cover behind the bulb. Then remove the bulb from the reflector. Then place the new bulb in the mirror, align it with the fixing clamp, clamp the wire springs on both sides and push it in, and finally secure the new bulb in the mirror. >>>More
There are two kinds of water ingress in car headlights, one is slight water ingress and the other is severe water ingress. >>>More
Installation: Carried out in the state of turning off the engine and cooling the car. >>>More
There are many reasons why car headlights do not light up, including: burned-out bulbs, heated wires, damaged relays or combination switches, open wires, short circuits, open circuits, damaged fuses and poor line contact. First of all, you should check whether the fuse is good, because the headlight suddenly does not come on, and most of the cases it is caused by the blown out of the bulb fuse. >>>More
Hello, the effect is still OK, 1. Repair scope: various types of headlights made of plexiglass, acrylic PP, PC, PE, ABS and other materials 2. Repair type: yellowing, cracking, blurring, scratches; (Note:.) >>>More