Urgent, the CPU fan speed is super fast, 42187 per minute, what should I do if the computer is buzzi

How could it be! The fan is already smoking, and the measured speed may not be accurate.

If you think the sound is loud, you can get a deceleration line, ** about 2 yuan, and the fan speed can be reduced by 50%.

Added: Dizzy, I still want to be detailed and practical, that value is obviously wrong, and it doesn't make sense to look at that value. Now your problem isn't the computer buzzing?

Our purpose is two, one is to ensure heat dissipation, and the other is to reduce noise.

Now there is no problem with heat dissipation, only noise, so start with noise reduction. Either change the fan, a radiator, the silent one needs more than 100, and the heat dissipation and mute effect is absolutely first-class. You are reluctant to spend money to get a deceleration line, in fact, it is to add a resistor to the fan line, the fan speed will come down, and the noise will be smaller, understand?

And add: I'm going crazy, I don't have to buy a new one, don't you just think it's loud, it's useless for you to soak the garbage fan in oil, you get a deceleration line if you think it's loud, and you can get it for a few dollars, and the fan sound will become smaller, as for your software to see the fan speed, delete it quickly, it's useless at all. Also curious, what motherboard do you use?

Also, you can't find anything good about the CPU radiator within 50 yuan, and the decent points are more than 100 yuan, if you want to change it, just change a fan, buy an overclocking three, 20 yuan on the line.

Add again: Maybe it's a problem with the motherboard, the display is wrong, I don't know if the motherboard has software to flash the BIOS, you can flash it and try it. For other noises and whatnot, look at my above.

It's the sound of a fan spinning fast.

DizzyMy highest speed is not tens of thousands of revolutions. Is your speed test software inaccurate?

The sound of the original fan of inter is not smallYou can take a different speed test. Or take a look at the BIOS.

Change the fan, the original intel fan is garbage.

Excuse me, what is your speed?

1.Peacetime. 2.Play the game.

3.Desktop or laptop?

In fact, I think that if it is a desktop computer, if the noise is not very loud or you can accept the range, it is better to hurry up, because good heat dissipation will guarantee the life of your machine.

When you open the game, the temperature will rise.,And yours is AMD.,AMD's temperature increase is generally higher than Inter.,But,Your CPU is only more than 50 degrees.,There's no problem at all.。 If you don't believe it, you go and look at the temperature of your graphics card when you play the game, that's the horror. I see that your machine configuration is so high.,The graphics card must be very good.,It's estimated that it's very common to play games on 80 degrees.,But these are normal.,Don't worry too much.。

Just remember to deal with the dust a little more.

If you're not at ease, go for a different CPU fan, the kind of fan designed specifically for overclocking, 50 100 yuan apiece.

Of course, I don't think the CPU is a big deal in its 50s.

I have a laptop, play games, the CPU is 60+, the graphics card is 75+, but it's nothing.

The speed of the fan increases, you go to wipe the dust, maybe wipe off the lubricating oil.

The main reason is the resonance of the heat sink caused by the high speed... It means that the heatsink is not tightly attached to the CPU.

Heat can build up between the CPU and the cooling fan, causing the temperature to be too high and the CPU will stop working to protect itself.

CPU temperature skyrockets... The sensor will keep the fan running at maximum speed.

Silicone grease is sold in general computer stores.

Small computer repair points are also inexpensive.

In the hot summer weather, the fan will definitely need to speed up the heat dissipation.

You can clean up the dust in places such as the fan inside the case, which can improve heat dissipation.

If you use the original fan that comes with the CPU, you can change to a brand fan, and the heat dissipation and noise will be better.

Under normal circumstances, the fan speed is about 2000 rpm, and the fan will be almost unbearable at 3000 rpm, and above 3800 rpm, the fan is overloaded, and there is a possibility of breaking and stopping at any time, so the landlord quickly replaced the radiator.

It has to ring. Generally, it will be quieter below 2000 rpm. You go and change it to a radiator about 60 to solve the noise problem.

The CPU comes with a heatsink bar.

It's all like that, change to a big fan and low speed.

Cheap Kyushu Fengshen Ice Cream Mini flagship.

The expensive ones are the ice.

AMD is like that.

I have an AMD FX-8150 at home

When playing games, the fan has to turn 6000+

This solution is applicable to XP Vista Win7 system.

Problem Description]:

Computer noise, fan noise.

Cause Analysis]:

The optical drive has an optical disc caused.

Hardware failure. Solution:]:

Solution 1: Check the optical drive.

If there is a disc in the optical drive, please take out the optical disc when the optical drive is not in use, otherwise every time you boot up and start up, you will check the peripherals of the optical drive and read the optical disc, 2

The vibration and sound of the computer will be relatively loud.

Option II. Detect hardware and fans.

The hard disk disk will squeak or click when reading data on the track, as long as the computer is running more frequently than the case of frequent crashes, the hard disk sound is normal, especially the old machine hard disk aging or the sound of the large storage hard disk is louder.

If it is the sound of a fan whining, the computer has a temperature control setting, and with the length of computer use and the temperature of the computer, the speed of the host fan, especially the CPU and graphics card fan of the notebook, will change.

In the same way, if it is an old machine, it is recommended to clean the dust of the graphics card fan, CPU fan, and host power supply fan, and if the effect is not obvious, you can appropriately add the special lubricant for the fan or replace it with a new one.

It is recommended that you go to a professional repair shop to clean up the dust from the graphics card fan, CPU fan, and host power supply fan to avoid unnecessary hardware damage.

One of the reasons is that the hard disk has bad sectors and responds slowly.

Second, there are many self-start procedures at boot, resulting in slow boot time and long waiting time after booting.

Third, the buzzing of the fan may be due to the lack of oil in the fan, or the power consumption of the CPU is high.

The first step of changing the fan and the second step is to go to a professional repair computer to check if your hard drive has physical bad sectors.

It's a hard drive issue.

It has little to do with other parts in computer accessories.

That's because 1: Your fan has been used for a long time, the lubricating grease has been exhausted, and the bearings inside have been slightly worn and there is a gap.

2: You haven't cleaned the fan for a long time, too much dust is attached to the fan blades, resulting in uneven weight of the blades, and the unequal weight blades and gaped bearings produce more vibration under the action of centrifugal force when rotating at high speed.

3: It comes and goes, because your fan is a four-wire fan with intelligent speed control, which will adjust the speed appropriately according to the real-time temperature of your CPU. This is when the temperature of the CPU rises dramatically when you're running a big game or processing more data, and the fan is running at its highest speed.

Seeing your addition, you unplug the CPU fan and there is noise, then you unplug the other fans one by one, find the fan that made the noise, buy a new one and replace it. (Unplugging the CPU fan and turning it on is a very unwise thing to do, once I unplugged a CPU fan, and two minutes later it died heroically.) ）

The CPU fan speed is too large, or the sound is too loud due to the problem, in short, it is abnormal, the CPU heat dissipation is not good, and the fan speed increases, and then see if the environment you are out of is too hot, and there is dust in the heat dissipation port, clean up the heat dissipation system.

If there is more dust, there will be noise. It's okay. Just clean it up.

There is a lot of dust, go to professional repair, blow and clean, mine is the same as you, do it well.

There may be a problem with the heatsink on your laptop.

Let the laptop take a break, it's too hot, it's dissipating.

If you move to a computer store, the lubricant may be gone.

Is it taking too long; Oh.

Glad to solve the problem for you.

According to your question, I think the possible problem is that there is too much dust in the cup, it is recommended that you turn off the power first, then cut off the power supply, and then open the case, use a long, thin brush, gently brush, blow. Try to get the dust out of it.

But the reason for the fan itself is not ruled out. According to what you said, you hold down the sticker, but you make the vibration range driven by the fan smaller, of course the sound will become smaller, hehe, if the first method can't solve it, try to change it.

Like the previous one, it may be that your CPU fan is too dusty, and it may be good to clean the dust, but not necessarily, I don't know if your fan is a hydraulic shaft or a ball, if the ball is better to put on some oil, like lubricating oil, but don't put it on too much.

1: It may be because there is too much dust in the computer, and there is dirt on the fan, which increases the fan resistance, so that the fan can not operate normally, and the computer sound is particularly loud.

2: It's because the fan bearing is out of oil, the solution is to open the chassis to find the loud fan and add some oil to the bearing, and the sewing machine oil or lubricating oil in the grocery store can be! The second is to get a new fan.

3: The screws of your CPU fan are loose, because you get the paper underneath will reduce the vibration, indicating that there is a gap between the CPU fan and the CPU to vibrate! You can tighten the screws, or you can buy some silicone to stick on the contact between the CPU and the fan.

IT elite organization

ip bugs.

Sincerely serve you.

Hehe, the main reason is that the fan has less oil, and my machine has also had this kind of problem, just get the fan a little oil.

Hello: 1, the cooling fan that has been used for a long time has a certain amount of wear and tear on the oil-impregnated bearingsGet a new fan

2, you can also [Fill with lubricating oilSolution: Uncover the fan trademark label, you can see the bearing, and you can drip in the motorcycle oil.

What should I do if the computer CPU fan is loud!!

China Pharmaceutical University.

Glamour Picks. People hit the list. Go to the topic.

There are a total of 51 rewards to write.

Du Tinglan Kindong.

ta has more than 10,000 likes.

Let's talk about following to become the 41st fan.

The noise of the computer mainly comes from the fan, and many materials have introduced the method of filling the fan with oil to reduce the noise, but I think that the noise of the fan is not necessarily due to the lack of oil in the bearing.

The "eccentricity" of the fan's blades is the main cause of the noise. High-quality fans, the center of gravity of the fan blades on the axis, the operation is very stable, the noise is very small, and the inferior fan, there is often a certain deviation, the center of gravity of the fan blade does not cause "eccentricity" on the axis, such a fan rotates, it is equivalent to an oscillator (the oscillator is to add an eccentric wheel on the motor shaft), with the use of time, the fan bearing gradually wears, or the fan heat sink is not firmly installed, loose, etc., will make the vibration aggravated and the noise becomes larger. The simplest solution to this type of failure is to install the fan as firmly as possible so that it cannot vibrate, of course, this method does not solve the substantive problem, because the fan blades are still "eccentric"; Another method is to inject oil into the fan bearing to cushion the vibration and reduce the noise; There is another way to solve the problem at its root:

Remove the fan blade, use a thin wire to hang the fan blade through the small hole in the center of the fan blade, if one end falls, it means that this end is heavier, you can grind a few times on the grinding wheel, so after several times, when the fan blade is hoisted with a thin wire, if the fan blade can be static in the horizontal position, it means that the transformation is successful.

A few questions about oiling the fan:

1.Sewing machine oil or engine oil, I recommend using four-stroke motorcycle oil, because sewing machine oil is very thin, fluidity and volatility, it will not take long after oil injection, and the fan will be "old disease**", and the cushioning effect of sewing oil on vibration is also very small, for weakening noise, it has little effect, and the use of engine oil just avoids the above two shortcomings.

2.After the sealing problem of oil injection, a label paper is attached to the oil injection part of the fan, and after the label paper is removed and oiled, the label paper can generally not be used anymore, what to replace it? I used four or five layers of scotch tape.

Find a roll of scotch tape, use a knife to cut horizontally, cut through about four or five layers, and then peel off these four or five layers of scotch tape together and you can use it. Be careful not to use just one layer of tape, because a layer of tape is prone to vibration and noise when the fan is rotating, and it may be damaged and cause oil splashing. Another advantage of using scotch tape instead of label paper is whether the fan is short of oil, which can be seen at a glance and does not need to be disassembled.