The computer starts slowly, and it can t be solved by many methods

Generally, there are 2 cases.

First, software problems:

The average computer has too many things. Either that's a new virus.

The best way to deal with these is to copy the important files and reinstall the system.

You can also find Defragment in my computer's properties, which is much faster.

Second, software issues:

This kind of problem is very common, and the wealthy buy a computer again.

Updating the main hardware is also possible, and it is also more cost-effective and applicable.

Typical system problems, it is recommended that you install the rainforest wood wind system to try, or the computer is very old kind of disabling the theme will be much better.

Is there too much antivirus?

There are also a lot of boot startup programs.

For example, Kingsoft's anti-virus and firewall.

are more CPU....

It's easy to reach %100 but once it's fine.

Click on My Computer Properties - Advanced - Performance Options - Adjust to Optimal Performance. Then start over again. I think it's going to hurry.

Your problem should be caused by too many system junk files, and the handling methods are as follows: 1. Clean up the system junk files with one click ghost; 2. Use Rising card or 360 to clean up system junk files; 3. Defragment disk of drive C. In general, just do the first step and the startup will be significantly accelerated!

First of all, open "System Properties" (right-click - Properties on my computer, or open "System" in the control panel, shortcut win+pause break) click the "Advanced" tab, open "Settings" in the "Startup and Failback" area, remove the two in the "System Startup" area, and if it is a multi-system user, keep the "Time to display the operating system list". Click "" to make sure that the additional property of the startup item is fastdetect instead of nodetect, and do not add the noguiboot attribute first, because guiboot will be used later.

The next step is very important, open the "Hardware" tab in "System Properties", open "Device Manager", "IDE ATA ATAPI Controller", double-click to open the "Secondary IDE Channel" properties, click the "Advanced Settings" tab, change the delivery mode of devices 1 and 2 to DMA if available, select "None" if the device type can be selected, click OK to complete the setting, and set the "Primary IDE Channel" in the same way.

I've had this problem too.

You can try cleaning up the disk.

Open 360 Security Guard--Optimization Acceleration--Startup Items--System Key Services--All Prohibition Rates Except for System Theme Management Services3%, All of the above are forbidden to start, and then carry out a deep optimization, you are looking at the startup speed of your computer, you will find that the speed has gone up!! Ha ha.