win2003 Dual NIC Sharing Internet What is the difference between the bridging method and the routing

There are a lot of differences, one of which is:

Routes can be interconnected with multiple machines, but dual NICs can generally only be peered with two devices. If you only have two computers to access the Internet, dual network cards are still more economical than routing, but the routing is a little more convenient, and you can dial out the Internet independently. If you use dual network cards, when the host is not **, the other machine cannot be connected.

It is impossible to bridge the bank, 2003 on the routing and remote service to turn on the VPN function, the school LAN with Qiaoxun account, through the VPN to achieve Internet access, as for the IP, you can not bend the wide banquet of this network segment.

Suppose four computers are A, B, C, D, where A can access the Internet.

1.Set the network card of computer A to connect to the Internet, and set it to shared network connection in the properties.

2.Check the IP address of another NIC of computer A, if it is 3Connect the NIC of computer A that is not connected to the Internet to the switch, and B, C, and D are all connected to the switch.

4.Set the IP address of the NIC of the B, C, and D computers connected to the switch to the network segment, and the gateway is not used for the router.

In this case, you can use the route to set the account password in the route, each set IP and DNS can each machine can access the Internet, and the four machines can share files, and they can access the shared files with each other.

This big brother, I don't know if I can save Brother Xiaozen Wang. I'm also making He Zhenzai's hair gray. Thank you so much.

My dual network card connection and but can ping the dual network card travel leak to connect to the network IP) but dead and alive can not ping if you know please. Bow down, worship.

If you install two network cards on your computer, bridging is equivalent to allowing the two physical network segments to communicate with each other, and the shared network is equivalent to this computer as a route! A network card as a WAN port, a network card as a reputation for the LAN port, you can bring other computers Wu Qing Shangqing orange volt network!

Dual network cards share the Internet with ICS, which is a lower version of NAT

Bridges, on the other hand, do not allow for direct sharing of the Internet.

The switch connects all computers, and one of them is the best choice to install routing software or ** software.

There is no need to use sygate or the like, a single network card will do.

The bridge scheme is optional, but it is necessary to determine whether there are routing restrictions on the gateway of the login software first, and if you restrict the connection to one, there is no way.

Try to use the router as a switch, the general route is "WVN" port in, and then divide a few ports (I use 4 ports) out, you pull the line directly into the other port (not WVN), and then connect to other machines, I am in the same situation as you, and then do it like this.

It should be ok. But it has to be open 24 hours a day. Another idea is to install a software router on your desktop and connect the router to it like a switch. Remember to turn off the RIP protocol for routing.

Is it XP?

No software is required.

Directly set the "Local Connection" connected to the "Netcom LAN" as shared.

Follow the system prompts to set the host to and the other to the other.

As long as the host is turned on, the other machine is already connected to the network.

That's what my home computer looks like.

The server's network card has its own software to do aggregation. Such as Intel. The two ports corresponding to the corresponding switch must also be aggregated.